線圈電場電極 的英文怎麼說
中文拼音 [xiànjuāndiànchǎngdiànjí]
線圈電場電極
英文
coil-field electrode- 線 : 名詞1 (用絲、棉、金屬等製成的細長的東西) thread; string; wire 2 [數學] (一個點任意移動所構成的...
- 圈 : 圈名詞1. (養豬羊等牲畜的建築) pen; fold; sty 2. (姓氏) a surname
- 電 : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
- 場 : 場Ⅰ名詞1 (平坦的空地 多用來翻曬糧食 碾軋穀物) a level open space; threshing ground 2 [方言] (...
- 極 : i 名詞1 (頂點; 盡頭) the utmost point; extreme 2 (地球的南北兩端; 磁體的兩端; 電源或電器上電流...
- 線圈 : [電學] coil
- 電極 : electrode; pole
-
The fluctuating mangnetic field cutting across the turns or loops of wire of the secondary coil sets up an electrical pressure or voltage in these loops.
起伏變化的磁場橫向切割著次極線圈的線匝和線環時,會在這些線環中引起電壓。The subject of this thesis is to study ironless moving coil linear permanent magnet synchronous motor and the major works in this thesis are summarized as follows : 1 ) two analytical formulas are derived by concentrated current method and distributed current method to determine the magnetic field due to pm, based on the current model of pm. besides, two method ( magnetic charge method and solution by laplace equation method ) are also introduced with comparing their advantages and disadvantages. then the effects of the motor parameters on the flux distribution are discussed
本文對空芯動圈式直線同步電動機進行了深入細致的研究,內容包括: ( 1 )採用電流模型推導出兩種計算永磁磁極二維氣隙磁場的解析公式(集中電流法、分佈電流法) ,同時介紹了兩種永磁電機氣隙磁場計算方法(磁荷法,直接求解拉氏方程法) ,分析各種方法的優缺點,討論電機參數對氣隙磁密的影響; ( 2 )介紹了單層同心繞組的布置方式,根據安培定律推導出空芯動圈式直線永磁同步電動機的靜推力計算公式,分析靜態力?位移特性; ( 3 )建立空芯動圈式直線永磁同步電動機動態模擬模型,模擬不同驅動方式下電動機起動、穩態運行時電磁力、速度、位移的變化情況。Electromagnetic heat is generated from the coils that are transmitted with high frequency electric currents, when magnetic metal cookware is used, high magnetic frequencies are generated, thereby creating huge volumes of whirling fluids, which is transformed from electric power into heat power
電磁爐具熱源的產生是利用高頻電流通過一組線圈,形成高頻交變磁場,磁場的磁力線穿過鐵磁材料的金屬鍋,作用於鍋體內的粒子,使其劇烈運動、磨擦,即時產生極高的溫度場,將電能轉化成熱能。Magnetic head is designed by six magnetic poles in symmetrical distribution, the design of excitation loop and excitation angle makes magnetic field act on welding arc region which could control welding arc effectively. the insulation, cooling and hermetization of magnetic head avoid the influence on magnetic field of outside ; miniaturization design of magnetic head could achieve different welding process
磁頭裝置採用六磁極對稱勵磁方式設計,勵磁線圈和勵磁角度的設計使產生的磁場恰好作用於焊接電弧區域以實現對電弧的有效控制;磁頭的絕緣,冷卻,密封設計避免了焊接過程中外界因素對磁場的干擾;磁頭整體的小型化使該裝置可以實現多種形式的焊接工藝。The integral method is adopted caculate and analyze to amf three - dimension distruction which is the structure of coil type four - pole and the structure of coil type double - pole and study the size of two kind of electrode structure axial magnetic flux density distribution and its fielduniformity. the finite - element method is used simulate that eddy current has effect on amf when contact tray of douple - pole amf structure is slotted or no
本文採用積分方法對本文設計的線圈式兩極縱向磁場觸頭結構和線圈式四級縱向磁場觸頭結構的縱向磁場三維分佈進行了計算分析。研究了電弧燃燒期間兩種觸頭結構縱向磁場強度的大小、均勻性,利用有限元法模擬線圈式兩極縱向磁場觸頭結構的觸頭盤開槽和不開槽時渦流對縱向磁場的影響。The maximum temperature rise of these coils is also estimated from the thermo - hydraulic condition of the magnet operation
並根據磁體運行的熱工水力條件估算出極向場線圈在等離子體放電過程中的最高溫升。From magnetic fields in pf coils of east expressed as elliptic integrals, the heat load of pf coils during plasma discharge is determined
摘要通過求解橢圓積分,計算了east極向場系統的磁場分佈,從而計算出極向場線圈在等離子體放電過程中的熱負荷。The hybrid claw - pole alternators have magnetic fields contributed by permanent magnet as well as excitation coil, and the advantages are high efficiency, have good low - speed characteristics, excitation adjustable and high flux densities. for the reason of complex claw - pole construction and 3 - d magnetic field distributions, there is lack of the research on the alternators
混合勵磁爪極發電機是由永磁體和勵磁線圈共同產生電機磁場的一種發電機,與傳統的爪極發電機相比有高效、低速性能好和集線圈勵磁的電壓調節性能與高磁通密度的優點,具有很好的研究前景和使用價值。It can still decrease influence of the eddy current greatly while contace surface of coil type double - pole amf structure is not need to be slotted, so it can also decrease surplus axial magnetic field when the current is at zero and axial magnetic field hysteresis time
線圈式兩極縱向磁場觸頭結構的觸頭表面不需開槽仍能大大降低了渦流的影響,因此也減小了電流零點時的殘余縱向磁場和縱向磁場滯后時間。The explanation for this “ spooky action at a distance ” ( to borrow a term from quantum mechanics ) is that a grid of wires underneath the screen emits an electromagnetic field that causes a coil inside the pen to oscillate at a resonant frequency
這種幽靈似的超距作用(從量子力學借來的術語) ,是因為螢幕下方的柵極線路會發出電磁場,讓專用筆內部的線圈以某個共振頻率振蕩。The analytic result shows the higher fieldunification is produced between contact gap by the coil type double - pole amf contact structure, and its intension is over 2 times than quadrupolar contact structure when they are in same current
分析結果表明,這種線圈式兩極縱向磁場觸頭結構在觸頭間隙上產生的縱向磁場分佈均勻程度較高,強度要比線圈式四極觸頭結構同等電流下大兩倍。It is tested that the most proficiency method is using pulse - controlled magnet core to generate rotating magnetic field, in which the density and frequency of rotating field can be adjusted, the different form of rotating field can be easily achieved, and both magnetic pole and work piece need not rotate during the magnetic abrasive finishing process
實踐證明,最有效的方法是脈沖控制電磁線圈的方法產生。這種類型旋轉磁場的強度和磁場的旋轉頻率都可以得到調節,磁場的不同旋轉形式也很容易實現,而且在研磨加工過程中工件和磁極都無需旋轉。Adopting the short circuit electric current of to formate the test prove that this contact turn on and cut off performance. according to ablation situation of contact surface after testing, have analysed that coil type double - pole amf influences electric arc
採用短路電流合成試驗驗證了這種觸頭的開斷性能,根據實驗后觸頭表面的燒蝕情況,分析了線圈式兩極縱向磁場在大電流時對電弧特性的影響。分享友人