線強度計 的英文怎麼說

中文拼音 [xiànqiángdùjì]
線強度計 英文
inte imeter x
  • 線 : 名詞1 （用絲、棉、金屬等製成的細長的東西） thread; string; wire 2 [數學] （一個點任意移動所構成的...
  • 強 : 強形容詞（強硬不屈;固執） stubborn; unyielding
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 計 : Ⅰ動詞1 （計算） count; compute; calculate; number 2 （設想; 打算） plan; plot Ⅱ名詞1 （測量或計算...
  1. Some problems occurred in the compensation management of cadi and the causes are discussed. according to the current situation of the human resource of cadi, the characteristics of engineers working in the cadi and the characteristics of the aircraft design, the distribution schemes focusing on job positions and performance are given, of which a linear programming model is built to resolve the performance compensation at the aim of max - motivation in order to form a suitable model of compensation management and to achieve " double - win " between the employee and the employer

    針對611所人力資源狀況、工程技術人員特點及飛機設計專業工程工作特點，提出以崗位為核心的崗位薪點設計方案和以個人業績為核心的績效分配設計方案，建立了以激勵強度最大化為目標的線性規劃數模，用單純形法求解績效獎酬，以形成一種激勵強度大、內部公平合理、對外具有競爭力的薪酬管理模式，即實現員工與組織在此問題上的「雙贏」 。
  2. Based on the line spring model of rice and levy, this paper sets up eight nodes line spring element and its stiffness matrixes and works out a program consist of prism element, hexahedron element and line spring element

    編制了五面體單元、六面體單元和八節點線彈簧單元相結合的計算程序，計算了t型板接頭表面裂紋的應力強度因子，計算值與光彈性試驗結果吻合較好。
  3. The whole tension strength of steel fiber reinforced self - stressing concrete is a combination of tension strength of matrix and the self - stress value ; the strain of knee point is defined to 500 10 ^ ( - 6 ), and a formula for stress of knee point is suggested

    鋼纖維自應力混凝土抗拉強度為混凝土基體的抗拉強度與自應力值之和；曲線下降段拐點的應變定義為500 10 ^ （ - 6 ） ，並提出拐點應力計算公式。
  4. Abstract : in this paper, the environment of charged particle from cosmic ray which can induce the hard and soft error on micro - electronics was discussed. employing widely used model and our latest work, we calculated the distribution of cosmic ray in low earth orbit and discussed the model and its application

    文摘:本文主要討論了在近地空間能夠引發微電子系統故障的宇宙線帶電粒子環境問題，參照國外轅為成熟的模式和我們最新的工作，對近地軌道的宇宙線強度進行了計算，並就模式的應用和存在的問題進行了討論。
  5. According to the load behavior and defection degrees of existed reinforced concrete bridge, the calculating modeles for normal section strength and bearing capacity for reinforced concrete bridge are established by the elasticity analysis and nonlinear analysis of grade stiffness degeneration

    根據既有鋼筋混凝土橋梁的受力特點和損傷程度，採用兩種方法：即《規范》法分析理論和分級剛度退化非線性分析理論，分別建立了既有鋼筋混凝土橋梁正截面強度計算和承載能力評定的計算分析模型。
  6. Natural characteristic analysis not only verifies whether the natural frequencies and mode shapes of the antenna are reasonable or not, but also is the base of the structural response analysis, fatigue resistivity computing and the other dynamics problems. the structure design of antenna is a complicated systems engineering, which is generally limited to multiple objects that influence each other, so we need to keep the balance among those objects by decision - making technology of multiple objects to ensure every target optimized

    固有特性的分析不僅能檢驗天線結構的固有頻率和振型是否合理，而且也是結構響應分析、動強度計算等其他動力學問題研究的基礎；天線的結構設計是一個復雜的系統工程，它通常受到多個目標的限制，而各目標往往是相互影響的，甚至是相互矛盾的，因此需要藉助多目標決策技術，平衡各目標，以保證空間天線最優的滿足各項設計指標。
  7. X and gamma reference radiation for calibrating dosemeters and doserate meters and for determining their response as a function of photon energy - dosimetry for radiation protection over the energy ranges 8 kev to 1, 3 mev and 4 mev to 9 mev

    校準劑量計和劑量強度計及測定作為光子能函數靈敏度用x和基準放射線.能量范圍在8kev - 1 ， 3mev和4mev - 9mev放射保護用放射量測定
  8. The simplified model took into account the working of the steel tube, and the calculating method of local compression strength of concrete in tube corresponded to that recommended in the chinese code for design of concrete structures

    簡化模型考慮了鋼管參與工作，管內混凝土局部承壓強度計算方法與我國混凝土結構設計規范保持一致。建立了矩形鋼管混凝土桁架節點非線性有限元分析模型。
  9. The results show that there are really obvious scintillation in gcrs intensity at the periods of 10 - 60 minutes as expected by many scientists, such as dorman, et al. then we analyzed the data observed at beijing snm between two solar cycles " transitional phases by using wavelet method

    我們還計算了幾個磁暴前銀河宇宙線強度的短周期的變化特徵，計算結果顯示，磁暴前銀河宇宙線強度在10 ? 60分鐘范圍內出現明顯的閃爍，這是磁暴前銀河宇宙線強度變化的的一種先兆特徵。
  10. Intrinsically the calculation of line strength and shape is a quantum mechanical problem.

    從本質上來說，譜線強度和輪廓的計算是一個量子力學的問題。
  11. Ultraviolet ray intensity meter

    紫外線強度計
  12. The uv index is obtained by multiplying the measured uv intensity by a conversion factor

    只要將寬波段儀所量度的紫外線強度乘上一個變換常數，便可計算出紫外線指數。
  13. According to the ratio of the intensities of the double lines, the ratio of transition probability of the double lines was deduced. compared with the theoretical value, we found they coincided with each other exactly

    對a1原子共振雙線（ ali394 . 40nm和ali396 . 15nm ）的譜線線型進行分析，扣除連續譜線的影響，計算譜線強度比，得到其躍遷幾率比是w _ 1 w _ 2 （
  14. Determination of the detection limit and decision threshold for ionizing radiation measurements - fundamentals and application to measurements by use of linear - scale analogue ratemeters, without the influence of sample treatment

    電離輻射測量的檢測限和判斷閥的確定.在沒有樣品處理的影響下用模擬線性刻度輻射強度計測量的基本原理和方法
  15. Because of the former anchorage systems designed according to matching 1860mpa strength strands in the beginning of 90 ", they can not be suitable any more for the super strength strands with 2000mpa. therefore, some accidents occurred such as strands sliding and broken when tensioning. in addition, the advantages of the new materials as their high mechanics performance are not be used completely as the prestressing structures was designed as per the 1860mpa strands, which will result in the waste of materials, in view of the above - mentioned facts, by means of analyzing the development of anchorage systems home and abroad, in connection with the characteristics of the super strength strands ( 2000mpa ), this topic made a research on hvm15 anchorages by theoretical calculation and finite element analysis, and also on the manufacturing process and test

    隨著預應力技術的發展和冶金工業冶煉技術的不斷進步，預應力鋼絞線的強度不斷提高，由原來1470mpa提高到1860mpa ， 90年代末期已出現了2000mpa超高強鋼絞線，而原來的是在90年代初期按抗拉強度為1860mpa的鋼絞線標準設計的，因此，原有的錨具已不能適應現有超高強度2000mpa的鋼絞線強度要求，在工程中出現了斷絲滑移現象，同時，在使用和設計時仍按1860mpa鋼絞線的指標進行設計應用，沒能充分發揮材料的力學性能，造成材料浪費。
  16. We also made a statistical study on precursors appeared in gcrs before major and large geomagnetic storms only by using the two cusp stations " nm data obtained at mcmurdo and thule

    對大磁暴前銀河宇宙線強度的變化和各向異性進行的統計分析分析表明，銀河宇宙線強度在磁暴前是有先兆的。
  17. X and gamma reference radiation for calibrating dosemeters and doserate meters and for determining their response as a function of photon energy - radiation characteristics and production methods

    校準劑量計和劑量強度計及測定作為光子能函數靈敏度用x和基準放射線.第1部分:放射特性和產生方法
  18. On the basis of earthquake - resistant behavior experiments of high strength concrete column reinforced with concrete filled steel tube, two methods for calculating flexural strength of the column, one is based upon the method in building code for calculating the flexural strength of reinforced concrete member while the other is based upon the method of superposition, are discussed, and the moment ? xial load relationship is also analyzed using finite element method. the results are in good agreement with the experimental ones

    本文在以鋼管混凝土為核心的高強混凝土柱（鋼管高強混凝土核心柱）的抗震性能的試驗基礎上，分別基於鋼筋混凝土構件的規范計算方法和疊加法兩種思路討論了核心柱的正截面強度計算，並用條帶有限元方法模擬了核心柱的彎矩? ?軸力相關曲線，與試驗結果符合較好。
  19. The detailed research contents are as following : ( 1 ) based on molecule spectrum theory and experimental data, presented are fine parameters of ch4 combined frequency band v2 + v3 and wide frequency band 2v3, including absorption spectrum central wavelength, line space, intensity distribution, line type and line width. these fine parameters have played solid foundation for measurement wavelength selection, and effectively eliminated cross sensitivity

    主要研究內容如下： （ 1 ）應用分子光譜理論和實驗數據給出了甲烷氣體在聯合帶v2 + v3和泛頻帶2v3的精細參數，包括吸收線的中心波長、吸收線間隔、吸收線強度分佈、吸收線線型和線寬，為系統設計選擇合適波長提供依據，消除交叉敏感。
  20. The standard equipment for measuring the intensity of uv ultraviolet radiation at different wavelengths needed for calculating the uv index is the

    要計算紫外線指數需要量度不同波長的紫外線強度，進行這種量度的最標準儀器是
分享友人
分享到 Line

分享到臉書