線性壓力 的英文怎麼說

中文拼音 [xiànxìngyālì]
線性壓力 英文
linear pressure
  • 線 : 名詞1 （用絲、棉、金屬等製成的細長的東西） thread; string; wire 2 [數學] （一個點任意移動所構成的...
  • 性 : Ⅰ名詞1 （性格） nature; character; disposition 2 （性能; 性質） property; quality 3 （性別） sex ...
  • 壓 : 壓構詞成分。
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 線性 : [數學] [物理學] linear; linearity線性代數 linear algebra; 線性方程 linear equation; 線性規劃 line...
  1. Based on the analysis of mechanism for joint region, the " frame - wall " and " aslope compression stub column " mechanical models and yielding patterns of core zone of the joints are set up. the shear load - carrying formulation for joint core zone is also given in terms of plastic ultimate analysis. and then, the comparisons between the formulas given in this paper and that of chinese design code ( draft ) and nonlinear fem as well are presented

    對節點核心區的抗剪，通過受力機理的分析，建立了鋼「框架剪力墻」加混凝土「斜壓短受力體系及其屈服機制，根據塑性極限分析，給出了節點核心區抗剪承載力計算的迭加公式， 《規程》公式和非線性有限元近似模擬分析結果進行了比較。
  2. The paper studies the surface geometry of globoidal indexing cam by applying the theory of conjugate surfaces and the method of coordinate transformation, presents the equations related to the main inducement curvature of the cam profiles, analysis and deduces the equations of two circumscription curves, which judge if the conjugate surface could mesh properly. some calculate examples and conclusion are given. the surface equation of the globoidal cam and conjugate equation are established

    論文首先在分析空間嚙合原理基礎上，採用坐標變換法推導出弧面分度凸輪的工作廓面方程、嚙合方程和壓力角計算公式，對弧面分度凸輪的嚙合特性進行了深入的分析和研究，對判斷曲面能否正確嚙合的依據如兩類界限線方程以及誘導主曲率等進行推導，並給出算例。
  3. Fluid noise mainly comes from out put pulsation of rate of flow, the main reason of out put pulsation of rate of flow is the instant high pressure return flow that obturation cubage produced when the big round curve pressure transition. the v trough on the port plate can reduce the fluid noise. in this paper, the author based on the acting of dam a river and condensability of liquid and used matlab language as tool to calculate the v trough on the original port plate and drew out the p - t diagrammatic curve and analyzed its shortcoming and improved the design of original v trough and got that the best size of its angle was 12. 3 and its length was 5mm and the cross section was an equilateral triangle

    流體噪聲主要來源於輸出流量脈動，造成輸出流量脈動的主要原因是閉死容積在大圓弧段壓力切換時產生的瞬時高壓迴流，在配流盤上開設v型尖槽可降低因高壓迴流而引起的流體噪聲，本文以截流作用和液體的可壓縮性為理論依據，以matlab語言為工具，對原配流盤上的v型尖槽進行了理論計算，繪制出p - t圖線，分析了它的不足，並對原有v型尖槽進行了優化設計，得出了v型尖槽的最佳幾何尺寸：配流盤平面上的v型尖槽的兩邊的夾角為12 . 3 ，槽長5mm ，槽的橫截面為等邊三角形。
  4. In chapter three, we negative the nonliear terms in the system of equations which include surface pressure, wind stress and coriolis force terms. the height of the storm surge and the storm current can be seen as two terms

    在第三章里，我們忽略了控制方程中的非線性項，將風暴潮潮高和風暴潮流分成氣壓效應和風應力效應的疊加。
  5. The company has established a scaled production line for sensors of such types as pressure, temperature, force, shift, photoelectricity, etc. and automatic control systems on the basis of following the purpose of “ create the biggest value for customers ” and the credendum of “ service supreme, property first ”, and can perform batch production of products of more than one hundred specifications

    公司本著「為顧客創造最大價值」的宗旨，以「服務至上，性能穩定壓倒一切」為信條，建立起壓力、溫度、力、位移、光電等類型傳感器及自動測試控制系統規模化生產線，批量生產上百種規格的系列產品。
  6. The linear relationship between shock wave velocity d and particle velocity u of our samples were obtained : d = 3. 701 + 1. 527u there the unit of relocity is km / s. no phase transition shows for enstatite with perovskite structure according to the experimental linear d - u line up to 110gpa

    實驗結果表明，在80 115gpa壓力范圍內本文所用頑火輝石的沖擊波速度d與粒子速度u可用線性關系： d = 3 . 247 + 1 . 626u來描述。
  7. Leech ; ap neuron ; integration ; pressure sensory ; membrane excitability ; modulation

    中華寬體金線蛭ap神經元整合壓力感受膜興奮性調制
  8. Building hardware - gasket and weatherstripping for doors, windows, shutters and curtain walling - linear compression force test methods

    建築五金.門窗百葉窗和幕墻用襯墊及擋風雨條.線性壓力試驗方法
  9. First, the dynamic stability of braid composite cylindrical shells with the influences of some main factors is introduced. the general governing equations for the nonlinear dynamic stability is obtained. by the hamilton principle. the creep buckling analysis of braid composite cylindrical shells under axial compression and the dynamic stability under nonconservation force are discussed as emphases. in creep buckling question, by means of theoretical analysis, the instaneous critical load and durable critical load of viscoelastic braid composite cylindrical shell under axial compression are obtained and the numerical example is given

    首先介紹了編織復合材料圓柱殼在幾種主要因素影響下的動力穩定性問題，用hamilton原理建立非線性動力穩定性問題的一般性基本方程。然後重點討論了編織復合材料圓柱殼軸壓下的蠕變屈曲問題及非保守力作用下的屈曲問題。對蠕變屈曲問題，通過理論分析來得到了編織復合材料圓柱殼的瞬時彈性臨界載荷和持久臨界載荷，給出了具體的算例。
  10. By applying linear pressure, friction is lowered, and the oil pump does not have to work as hard

    線性壓力的應用降低了磨檫，油泵不必重負荷運行了。
  11. Building hardware - gaskets and weatherstripping for doors, windows, shutters and curtain walling - part 2 : linear compression force test methods

    建築五金.門窗百葉窗和幕墻用密封墊和擋風雨條.第2部分:線性壓力測試方法
  12. In the paper, static and dynamic triaxial tests were conducted on fiy ash at shanmenxia longgou ash dam, and the static and dynamic parameters of fly ash were obtained. thirdly the 2 dimensions static analysis of the ash dam was conducted based on biot ' s consolidation theory and duncan ' s nonlinear stress - strain model. finally the plane dynamic behaviors of the ash dam during earthquake of intensity 7 were analyzed based on the exponent function model of excess pore water pressure aroused by earthquake, which is put forward in the paper, and equivalent visco - elastic dynamic fem model and principle of effective stress

    本文結合實際工程，對三門峽火電廠龍溝灰壩的築壩粉煤灰進行了靜、動三軸試驗，確定了該壩粉煤灰的靜動力學指標；然後根據比奧（ biot ）固結有效應力原理，採用鄧肯（ duncan ）非線性應力應變模型，對該灰壩的二維靜力應力和變形狀態進行了分析；最後利用本文提出的地震超靜孔壓指數函數模型，採用等價粘彈性動力有限元方法，對該灰壩在地震作用下的動力穩定性進行了分析評述。
  13. Using the precious metal resistant to compression characteristic, forms the precise linear delivery valve, besides may not have the section adjustment pressure value, also is in the present market condition adjusts one of scope biggest controllers, material quality use wrought aluminum alloy manufacture

    利用貴金屬抗壓特性，形成精確線性壓力閥，除了可以無段調整壓力值外，也是目前市面上調整范圍最大的控制器之一，材質使用鍛造鋁合金製造。
  14. The way to eliminate chaos phenomenon through adjusting system parameters is indicated. the nonlinear dynamic behavior of journal bearing - rotor system in large parameter space is studied in numerical integral method and floquet theory and the first and second bifurcation behavior of nonlinear rotor system are discussed ; the concept is advanced that realizing the controllable nonlinear stiffness with sfd with the soft - nonlinear of sma in the super - elasticity state to make the vibration amplitude of system always be in the small solution state to reduce the vibration amplitude of rotor system

    運用數值積分方法結合floquet理論對滑動軸承-轉子系統的大參數范圍非線性動力學特性進行了全面的研究，詳細地討論了系統的一次和二次分岔行為； 5 ）提出了用形狀記憶合金在超彈性狀態下的軟非線性，結合擠壓油膜阻尼器實現系統剛性的非線性可控，降低系統在非定常狀態下的最大振幅的構想。
  15. The problem of noise of the fan is studied with the non - linear theory, and pressure pulsation of axial flow fan ' s inside flow was measured by dynamic pressure sensor, the gas - structure coupled noise of contra - rotating axial flow fan was studied through a new perspective

    摘要用非線性動力學的理論對風機噪聲問題進行了分析，同時運用實驗手段測量了軸流風機流場內部流動的壓力脈動，從全新的角度研究了對旋風機的氣固耦合噪聲。
  16. The threshold speed and the typical characteristics of the oil whip of the system are simulated under the nonlinear model of oil film force, and the state of motion and type of the bifurcation are analyzed by floquet multiplicators which is computed by the shooting method. secondly, the the nonlinear dynamical model of the low - pressure rotor - bearing system by column bearing with reduced dimensions is presented. the numerical results show the rule of the amplitude with the eccentricity of rotor, the length - to - diameter ratio, oil viscosity and the clearance - to - radius ratio of the bearing under the definite speed

    其次，對降維后的低壓轉子?軸承系統的非線性動力學方程，計算了圓柱瓦軸承支撐的轉子系統的振動穩定性在固定轉速下隨偏心距、軸承長徑比、潤滑油動力粘度和軸承間隙比的變化規律，並分析了轉子前軸承軸頸的失穩轉速與轉子偏心距、軸承長徑比、潤滑油動力粘度和軸承間隙比之間的關系，同時利用floquet理論分析其運動狀態和分岔類型。
  17. Considering output pressure differences between potential driving sources, e. g., thermoacoustic prime mover and linear compressor, the influence of pressure ratio on regenerator performance was discussed

    針對熱聲發動機與線性壓縮機輸出壓力波特性的不同，分析了輸入壓比對回熱器性能的影響。
  18. Nonlinear dynamic analysis of high arch dams is carried out considering the opening of joints and the effect of traveling wave with engineering background of xi luodu arch dam whose height is 278 metel based on the theory of interaction of fluid - solid, the coupled fem equation considering compressible water is deduced

    以高278m的溪落渡拱壩為工程背景，進行了考慮橫縫張開、行波效應等復雜因素的非線性動力分析。基於流固耦合理論，推導了可壓縮水體的耦合有限元方程。
  19. The mesh of finite element was generated automatically to simulate the true fabric of concrete. the different material property of elements was identified and assigned automatically. the nonlinear constitutive relation of materials was established

    採用非線性本構模型來表徵組成三級配混凝土的各種材質的非線性應力?應變關系，該本構模型具有可以模擬材料的開裂、拉伸軟化、塑性屈服和壓碎非線性等特點。
  20. Nonlinear dynamic model and primary resonance of piezoelectric laminated disk

    壓電層合圓板的非線性動力學模型與主共振響應
分享友人
分享到 Line

分享到臉書