線性變形 的英文怎麼說

中文拼音 [xiànxìngbiànxíng]
線性變形 英文
linear deformation
  • 線 : 名詞1 （用絲、棉、金屬等製成的細長的東西） thread; string; wire 2 [數學] （一個點任意移動所構成的...
  • 性 : Ⅰ名詞1 （性格） nature; character; disposition 2 （性能; 性質） property; quality 3 （性別） sex ...
  • 線性 : [數學] [物理學] linear; linearity線性代數 linear algebra; 線性方程 linear equation; 線性規劃 line...
  1. On the basis of the basic theory of metal distortion, using round steel alit rolling as entity model and combining with production practice, the selection of slit location, slit mode and the design parameter of slit pass system were analyzed, and the area calculation model of pre - slit rolled piece and slit rolled piece was built

    摘要基於金屬塑性變形基本理論，以圓鋼雙線切分為基本實體模型，結合生產實踐，對切分位置、切分方式的選擇和切分孔型系統的設計參數進行了分析，並建立了預切分軋件和切分軋件的面積計算模型。
  2. He is studying the ecology of ameba

    他在研究阿米巴（一種線性變形蟲）的生態。
  3. A geometrical nonlinear deformation model and its experimental study of bimorph giant magnetostrictive thin film

    雙層膜幾何非線性變形模型及實驗研究
  4. Concrete structures are also usually assumed to deform linearly.

    混凝土結構通常也假設成線性變形。
  5. The specular reflection is a very important linear transformation in euclidean space, and it has a special geometrical explanation in geometrical space

    摘要鏡面反射是歐氏空間中一類很重要的線性變換，在幾何空間中有著極其形象的解釋。
  6. In actual structure, after bearing load, there is nonlinear distortion effect

    實際結構中，在承受載荷后，一般都存在非線性變形的影響。
  7. The crystalline structure changes of pp induced by pan - milling were characterized by x - ray diffraction and raman spectroscopy. xrd analyses show that when pp was co - milled with uhmwpe, crystal transformation of pp occurred, its crystallinity and crystallite size decreased, whereas, only slight reduction of crystallinity and crystallite size were observed and no crystal transformation was found when pp was co - milled with wtr chips, and amorphization of pp was strongly enhanced by co - milling pp with iron

    採用x -射線衍射研究了聚丙烯碾磨粉碎過程微觀結構變化， uhmwpe存在下pp發生晶型轉變、結晶度降低和晶粒尺寸減小；彈性材料wtr抑制pp塑性變形，碾磨導致分子堆積有序區域膨脹，晶面間距增大，結晶度下降；剛性材料金屬鐵與pp產生強烈摩擦，加快晶粒細化，晶格破裂導致非晶化。
  8. Solving the wire loop profile for which nonlinearity mainly caused by plastic - elastic forming is a challenging work, a finite element model has been proposed to simulate the wire loop profiling, in which beam23 has been selected as calculating unit, and the trajectory of capillary is divided into many displacement loads and applied on the wire step by step

    摘要針對引線成形過程中的材料非線性和幾何非線性問題，選用塑性變形梁beam23單元建立有限元模型，通過時引線分階段分步施加位移載荷模擬鍵合頭的運動軌跡，求解得到相應的引線輪廓形狀。
  9. Consequently, on the basis of non - winkler foundation model, a finite - element method that utilizes foundation flexibility matrix into iterative calculation is proposed in this paper originated from the item " the optimal design theory and research of pile capping beam " sponsored by natural science fund of hunan province, which the continuity of soil mass can be accounted for under various boundary conditions, different loadings and irregular beam characters

    本文結合湖南省自然科學基金項目「樁基承臺梁優化設計理論與方法研究」 ，針對非文克爾地基（半空間、線性變形層或單向壓縮層地基模型等）上的樁基承臺梁，提出一種利用地基柔度矩陣來進行迭代的有限單元法，可充分考慮梁下土體的連續性，並對基礎與土體脫開、承臺梁截面變化、梁體邊界條件復雜、上部荷載類型變化以及梁下基樁承載力差異等情況進行分析計算。
  10. However, due to the elastic deflection and vibration of the links, the flexible manipulator becomes an infinite dimension mimo system with distributed parameters, and is highly nonlinear and strong coupling. therefore, the model and the control of flexible manipulator are of great significance both in theory and in application

    然而也正是由於連桿存在彈性變形和振動，使得柔性機械手成為一個高度非線性的、分佈參數的、強耦合的無窮維多輸入多輸出系統， ，因此其建模和控制也具有重要的理論意義和應用前景。
  11. Taking the vr step motor as example in the paper, systemic research is conducted about the principle of the subdividing drive, the non - linearity relationship between microstep and phase current, the method of velocity adjusting and the interrelated factors. the system is designed to realize the subdividing drive, velocity adjusting and position. especially, there are two innovations in this paper. one is the first introduction of pld device and isp technology to the design of phase sequencer, the other is the new measure and amend method of microstep

    本文以三相反應式步進電機為實例，對細分驅動原理、細分驅動的非線性、變細分調速以及相關影響因素進行系統的研究；實現細分驅動器、調速控制、定位控制和軟硬介面的設計。在此基礎上，本文對細分驅動環形分配器的設計和微步距測量修正進行了創新；提出將pld器件和isp技術引入到細分驅動環形分配器的設計思想和錯位測量和逼近修正法。
  12. In chapter 2, author points out firstly that the elastic deformation of elastic units of a robot ' s wrist force sensor will be enlarged by the end - effector, the instruments and the work pieces, so the elastic deformation of the sensor will influence the location accuracy or kinetic accuracy of end point of a robot, under the condition of that the robot technology facing the developing of heavy load, light mass and high accuracy. it is discussed respectively that the relationship between the differential kinemics in the sensor ' s coordinate and the location accuracy or kinetic accuracy of the end point. error matrixes of location and kinemics of the end point are presented respectively based on the differential kinemics in the sensor ' s coordinate, and the on - line error compensation methods are introduced subsequently

    第二章首先指出機器人腕力傳感器彈性體的彈性變形經過機器人末端連桿、工具、工件等的放大后，會對機器人末端精確定位和運動產生的影響；然後分別研究了傳感器坐標系內的微分運動與機器人末端工件精確定位、運動的關系；在此基礎上，研究了基於腕力傳感器彈性體微分運動的機器人末端定位、運動誤差的誤差矩陣及其在線誤差補償方法；基於機器人動力學的機器人末端定位、運動誤差的誤差矩陣及其在線誤差補償方法；最後，以puma型機器人為對象，給出了基於腕力傳感器內微分運動的機器人末端定位、運動誤差及其在線補償方法的模擬實例：給出了基於機器人動力學的機器人末端定位、運動誤差及其在線補償方法的模擬實例；模擬結果表明， 1 ）基於腕力傳感器的機器人末端定位誤差在腕力傳感器允許的載荷下可達十分之幾毫米級。
  13. Issue 1. 0, national physical laboratory of uk, 2001. 7 wildes r p, asmuth j c

    但是，對于求解虹膜圖像之間的非線性變形，傳統的方法有著明顯的缺陷。
  14. Through the analysis of mapping relation between pixel point and a point of space, the paper pose a demarcate method based on grid interpolation. this method transform complicate nonlinear problem to many little regional linear problems and realize emendation on problems of linear and nonlinear deformation in image

    通過對圖象中的象素點與空間中的一點之間的映射關系的分析，提出了一種基於網格插值的標定方法，該方法將復雜的非線性的問題轉化為一個個小區域的線性問題，實現了圖象平面的線性和復雜非線性變形問題的校正。
  15. The nonlinear deflection of src beam under shrinkage and creep

    鋼骨混凝土梁在收縮徐變影響下的非線性變形
  16. Abstract : the propagation of waves passing over the abrupt changing topograghy can be simplified as a wave passing over a step. this flow process can be reasonably simulated by a 2 - d numerical wave flume developed in this paper, especially for the nonlinear transformation of the wave on the step. numerical results have been verified by experimental data

    文摘:波浪在水深劇變地形上的傳播，可以簡化為波浪在臺階地形上的傳播.利用二維數值波浪水槽可以很好地模擬這一過程，特別是對波浪在臺階上的非線性變形.數值計算結果與實驗測量進行了比較，結果吻合良好
  17. On the basis of the previous achievements and the settlement observed data, considering the obvious creep characteristic, visco - elastic - plastic creep model, which reflects the saturated soft clay ' s nonlinear deformation characteristic, has been proposed in this paper, with the consideration of the primary and secondary consolidation settlement. the soft clay visco - elastic and visco - plastic deformation is also depicted respectively

    針對具有明顯流變特性的飽和軟粘土，在總結前人研究成果和整理沉降實測資料的基礎上，把主次固結沉降結合起來考慮，提出了反映其非線性變形特性的粘彈塑性流變模型，分別對土體的粘彈塑性變形進行描述。
  18. The nonlinear deformations of simply supported, fixed supported and cantilever piezoelectric laminated beams were studied under strong electric field and mechanical force

    摘要本文研究簡支，固支和懸臂壓電層合梁在強電場和機械荷載聯合作用下的非線性變形。
  19. Abstract : a new method for the non - linear deformations of reinforced concrete columns in high - rise building under loads, creep and shrinkage is described. the practical expressions of creep and shrinkage factors are derived. the results computed by this method are in concordance with those of the test

    文摘:提出了計算柱非線性變形的新方法，同時考慮了混凝土徐變收縮和荷載的影響，引用了作者導出的一組數解徐變收縮的公式，並與試驗比較，結果令人滿意
  20. To describe the nonlinear deformation and fracture characteristics of the concrete and to keep the projectile - concrete interface clearness, the concrete was divided into smooth particles and computed by sph method but the projectile was divided into finite elements and computed by finite element method

    為了既能描述混凝土的非線性變形及斷裂特性又要保持分析過程中材料界面的清晰，混凝土劃分成光滑粒子並使用無網格光滑粒子動力學演算法，而彈體劃分成有限元網格並使用有限元演算法。
分享友人
分享到 Line

分享到臉書