線迴路電阻 的英文怎麼說

中文拼音 [xiànhuílùdiànzǔ]
線迴路電阻 英文
line loop resistance
  • 線 : 名詞1 （用絲、棉、金屬等製成的細長的東西） thread; string; wire 2 [數學] （一個點任意移動所構成的...
  • 路 : 1 （道路） road; way; path 2 （路程） journey; distance 3 （途徑; 門路） way; means 4 （條理） se...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 阻 : 動詞（阻擋; 阻礙） block; hinder; impede; obstruct
  • 電阻 : （物質阻礙電流通過的性質） resistance; electric resistance （電路中兩點間在一定壓力下決定電流強度...
  1. The probe ' s linearity, temperature and dynamic characteristics are analyzed base on principal theory of eddy - current displacement sensor, such as the influence of the coil q value to the linearity characteristic, influence of the diameter of coil to the linearity characteristic, influence of coil resistance to the temperature characteristic, influence of the measuring coil to the syntony loop

    在介紹渦流位移傳感器的基本理論的基礎上，分析了傳感器探頭線性特性、溫度特性、動態特性的影響因素。從探頭線圈q值對線性特性的影響；探頭直徑對線性的影響；探頭線圈電阻對溫度特性的影響；激勵信號溫度特性的影響：檢測線圈?振迴路動態響應特性等方面分析並提出製作高質量傳感器探頭的改進措施。
  2. Check the connection of control circuit shall be in accordance with drawings, the continuity of each circuit, and the insulation resistance against earth

    按電路圖檢查控制迴路接線正確，各迴路連續性試驗正確，對地絕緣電阻符合要求。
  3. The basic principle, main properties, typical parameters, technical characteristics and general situation of klystron are introduced. the electron beam prebunching in the modulated cavity and shift tube of relativistic klystron amplifer ( rka ) is studied analytically, a self - consistent equation of radiation generated by the prebunched electron beam in the radiation cavity is derived using the field method of particle ? wave interaction instead of the electrical circuit method, and in terms of it, the gain in the linear regime calculated, a field analysis method is proposed. the theory analysis shows that the characteristic parameters, such as resonance frequency, real part of gap - impedance, external quality fadtor in all kinds of klystron output circuits including single - beam, multi - beam, single - gap, multi - gap, single - beammulti - gap, multi - beam multi - gap klystron output circuit, can be calculated by the field analysis method

    本文系統的介紹了速調管的工作原理、主要特點、發展概況、主要性能指標和技術特點，解析的研究了電子束在相對論速調管放大器的調制腔和漂移管中的預群聚;用粒子波互作用的場方法導出了在輻射腔中預群聚電子束產生輻射的自洽方程，同時對線性區的增益進行了計算。理論分析表明，場分析法可用於計算單注單間隙、多注多間隙、單注多間隙和多注多間隙速調管輸出迴路的諧振頻率、間隙阻抗實部和外觀品質因數等特性參數。
  4. After introduction of the tranlinear loop principal, the bjt current controlled conveyor has been designed by using mixed tranlinear loop voltage follower. as for modern integrated circuit, the model of mos transistor, the active resistance and the current mirror integrated circuit formed by mos transistor are introduced. the cmos current controlled conveyor has been derived from mixed tranlinear loop cmos voltage follower based on weak inversion operation

    針對現代集成電路的工藝，本文對mos晶體管的工作原理進行了簡要的敘述，討論了有源電阻和電流鏡的實現方法，並利用mos晶體管的亞閾值特性組成混合跨導線性迴路完成對應的電壓跟隨器的設計，推導出了基於cmos技術的電流控制傳送器。
  5. On - line monitoring of hvcb is the precondition of predicting maintenance, is the key element of reliable run, and is the important supplement to the traditional off - line preventive maintenance in fact, the faults are made by hvcb, no matter in number or in times, is over 60 % of total faults so it has determinative importance for improving the reliability of power supply and this can greatly decrease the capital waste used by - dating overhaul in this paper, the inspecting way of hvcb mechanism characteristic is discussed the concept of sub - circuit protector is presented, the scheme that we offered has been combined with sub - circuit integrality monitoring theory, to ensure that it has the two functions as a whole according the shut - off times at rated short circuit given by hvcb manufacturer, the electricity longevity loss can be calculated in each operation, and the remained longevity can be forecast too an indirect way for calculating main touch ' s temperature by using breaker shell temperature, air circumference temperature and breaker ' s heat resistance is improved in this paper, and main touch resistance can be calculated if providing the load current msp430, a new single chip microcomputer made by ti company, is engaged to develop the hardware system of the on - line monitoring device, and special problem brought by the lower supply voltage range of this chip is considered fully

    高壓斷路器所造成的事故無論是在次數，還是在事故所造成的停電時間上都占據總量60以上。因此，及時了解斷路器的工作狀態對提高供電可靠性有決定性意義；並可以大大減少盲目定期檢修帶來的資金浪費。本文論述了斷路器機械特性參數監測方法；提出了二次迴路保護器的概念，並將跳、合閘線圈完整性監視和二次迴路保護結合起來，給出具有完整性監視功能的二次迴路保護器實現方案；根據斷路器生產廠家提供的斷路器額定短路電流分斷次數，計算每次分閘對應的觸頭電壽命損耗，預測觸頭電壽命；提出根據斷路器殼體溫度和斷路器周圍空氣溫度結合斷路器熱阻來計算斷路器主觸頭穩態溫升的方法，並根據此時的負荷電流間接計算主觸頭迴路的電阻；在硬體電路設計上，採用美國ti公司最新推出的一種功能強大的單片機msp430 ，並充分考慮該晶元的適用電壓范圍給設計帶來的特殊問題；在通信模塊的設計中，解決了不同工作電壓晶元之間的介面問題，並給出了直接聯接的接線方案。
分享友人
分享到 Line

分享到臉書