縫裂的 的英文怎麼說

中文拼音 [féngliède]
縫裂的 英文
fissured
  • 縫 : 縫名詞1. （接合處） seam 2. （縫隙） crack; crevice; fissure; slit
  • 裂 : 裂動詞[方言] （東西的兩部分向兩旁分開） open
  • 的 : 4次方是 The fourth power of 2 is direction
  1. And how does this snow compare to the snow over the crevasse

    這些雪和裂縫上的雪比較有什麼不同？
  2. Through the experimental research, we think : the technological capacity of fiberglass asphalt macadam if weaker than asphalt macadam, however, if use elasticized capacity to solve blending technological problem. adjust the breed of fiber silk, extend its diameter, its paving capacity is still worth exploring, asphalt - rubber macadam structure lager have good deformed - become capacity and crazed - resistance capacity, small gap rate. good water - resistance capacity, good hot - stability and simple construction technology. therefore. pitch rubber spall is a good cover material which is suitable for the second class or lower whose asphalt pavement has split open because of fatigue. and is the good structural measure of preventing half - rigidity grass - roots unit shrink - rift reflecting. pave a thin layer of pitch rubber spall between asphalt - type pavement layer and half - rigidity basic level, although the cost of building is higher than paving togongbu in the middle, the construction technology, crazing - resistance and water - resistance are better than togongbu, not only could reduce greatly the reflex of half - rigidity grass - roots unit material, long then the use lifespan of pavement, but also it is possible to reduce suitably the thickness of asphalt mixture layer, though the cast of building in the early days becomes more, in the long - term opinion, it have fully important technological and economical significance

    通過試驗研究認為：玻璃纖維瀝青碎石的技術性能不如瀝青碎石好，但路用彈性性能較好，如能解決拌和工藝問題，調整纖維絲的品種，增大其直徑，其路用性能仍值得探討，瀝青橡膠碎石結構層具有變形性能和抗裂性能良好，空隙率小，防水性能好，熱穩定性較好，施工工藝簡單的特點，因此，瀝青橡膠碎石是二級及二級以下公路因疲勞而開裂的瀝青路面的良好罩面材料，也是防止半剛性基層收縮裂縫反射的良好結構措施，在瀝青類路面面層和半剛性基層之間夾鋪瀝青橡膠碎石薄層，雖然造價比夾鋪土工布高，但其施工工藝，抗裂性能和防水性能均優于土工布，不僅可以大大減少半剛性基層材料的反射裂縫，延長路面使用壽命，而且可能適當減薄瀝青混合料面層的厚度，雖然初期造價有所增加，從長遠來看，具有十分重要的技術和經濟意義。
  3. Flux entrapped in the joints is the principal cause of low strength or failure.

    裂縫中封存有焊藥是強度不足或斷裂的主要原因。
  4. Discussion on the causes and the countermeasures of the cracks on prefabricated floor slab

    預制樓板沿縫開裂的原因及對策
  5. Repairs were made by cleaning out the breaks and filling with gunite.

    曾將裂縫中的碎塊清理並往裂縫噴槳進行修理。
  6. The white leader can now prepare the lip of the crevasse for hauling by placing an ice axe under the haul rope ( make sure to clip the axe into another anchor further back so it can ' t fall onto the victim ' s head if the lip breaks )

    白隊先鋒這時候在拖曳繩（譯者注：指黑繩）下面置入一支冰鎬（確定將冰鎬扣入較后位置的另一個確保點，這樣如果裂縫邊緣破裂的話，冰鎬才不會砸到落難隊員的頭部） 。
  7. The white leader can now prepare the lip of the crevasse for hauling by placing an ice axe under the haul rope ( make sure to clip the axe into another anchor further back so it can [ chr ( 39 ) ] t fall onto the victim [ chr ( 39 ) ] s head if the lip breaks )

    白隊先鋒這時候在拖曳繩（譯者注：指黑繩）下面置入一支冰鎬（確定將冰鎬扣入較后位置的另一個確保點，這樣如果裂縫邊緣破裂的話，冰鎬才不會砸到落難隊員的頭部） 。
  8. Laminar flow of foam fracturing fluid in fractures

    泡沫壓裂液在裂縫內的層流流動
  9. Thus the fracture likely initiated from fatigue sharpened cracks originating from slag and void in the plug welds.

    因此，斷裂可能是由於從塞焊焊縫內的焊渣和氣孔外形成的尖銳的疲勞裂紋而產生的。
  10. These graphite spheroids are know as “ crack arresters ” in the ductile iron industry because of their ability to stop cracks in their tracks

    在球墨鑄鐵行業內，這些石墨球稱為「裂縫終結者」 ，因為它們具有阻止斷裂的能力。
  11. Textiles. seam tensible properties of fabrics and made - up textile articles. part 2 : determination of maximum force to seam rupture using the grab method

    紡織品.織物和成衣接縫拉伸特性.第2部分：用抓樣強力試驗方法對接縫裂開最大拉力的測定
  12. Main achievements of the thesis : through analysis of the reasons of blockwork crack, i put forwards the measures on material production, shop drawing design and construction management, etc. especially, i put forwards to theory that changing traditional painting technics to avoid crack of painting layer. the application of above measures in engineering proved they are effective

    介紹了砌塊在國內外的發展與應用，研究了混凝土裂縫產生的機理，裂縫的形態及裂縫產生的原因，進一步分析研究了砌塊墻體開裂的各種因素，提出了在設計、生產、施工等環節的治理開裂措施。
  13. First, a new locally conformal fdtd scheme suitable for analyzing bulletheaded slot is presented, with which the errors of two schemes transforming from bulletheaded slot into rectangular slot are compared. this new algorithm is also employed in analyzing an oblique bulletheaded slot in the broad wall of a rectangular waveguide

    本文首次構造了一種適合於波導圓頭縫隙的共形fdtd方案，應用該方案對工程上方頭和圓頭縫隙的轉換誤差做了研究，並分析了傾斜組合裂縫的特性。
  14. Third, in the loess area, there is tension fractures on the top of slope generally. deep of the tension fracture could be deduced theoretically by columb strength theory

    3 、黃土地區，邊坡后緣常存在垂直張裂縫，裂縫深度根據土的強度指標可以計算。
  15. There is an old saying in our field - " no dam is not crackable ". the crack is mainly because of the bad dilation after " alkali - aggregate reaction ", the temperature traverse inside and outside the concrete with the happening of heat evolution and the shrink of volume due to the cooling of concrete

    水電行業有句「無壩不裂」的俗話，產生裂縫的原因主要有「堿集料反應」造成的破壞性膨脹，水泥水化過程中放出的熱量出現的混凝土內外溫度梯度和水泥石硬化後由於後期降溫發生的體積收縮等造成。
  16. Using radiometric dating methods, sugden determined that the ash settled into the fissure after a volcanic eruption 8. 1 million years ago

    薩格登使用了放射性測齡法，得出了火山灰是在810萬年前沉積到裂縫中的結論。
  17. Adopt advanced technic of f4 whole cold - press to moulding and heat melt to process to make, let the lining no slot to link withal cheek by jowl connect with exterior metalpipes wall, in the state of allowwing to work keep to distort in - phase, thereby to enhance using - life of lining in the working status of opposite high temperature high vacuum, stop the ecumenic pad fluorin pipes using in condition of cold and heat alternate and minus tension to come into being the matter of padding fluorin floor shrivel to jam the flowway and plastic rip, its perfect choice use to transport medium of strong corrosive strong oxidation by modern chemical - industry corporation

    採用氟塑料f4整體冷壓成型及熱熔加工等先進技術製造，使內襯層無縫搭接且與外層金屬管壁緊密粘接，在允許工作狀態下能夠保持同步變形，從而提高了襯里層在相對高溫高真空度的工況下的使用壽命，杜絕了一般襯氟管在冷熱交替，及負壓的條件下使用易產生襯塑層鼓癟阻塞流道及塑料拉裂的問題，是現代化工企業在輸送強腐蝕強氧化介質理想的選擇。
  18. Application of spliting grouting method to the crack of earth dam

    劈裂灌漿法在處理土壩裂縫中的應用
  19. The failure analysis of the heating jacket indicates that the austenitic stainless steel 316l is susceptible to stress corrosion cracking under the combined action of chloride environment and residual stresses induced by welding

    結果表明：加熱夾套開裂的主要原因是316l奧氏體不銹鋼不耐氯化物腐性，焊縫有一定的缺陷和腐蝕介質存在，屬於一種典型的應力腐蝕失效形式。
  20. He had a gray face, with slitted eyes, and a pinched nose saddled by faint blue shadows.

    他有一張灰白的臉，長著一對裂縫似的小眼睛和一個被挾過似的鼻子，鼻樑兩側各有一片淡淡的烏青。
分享友人
分享到 Line

分享到臉書