縱向渦 的英文怎麼說
中文拼音 [zōngxiàngguō]
縱向渦
英文
longitudinal vortex-
The study shows that the longitudinal component of the pressure force is mainly balanced by the vertical eddy frictional term and the lateral component of the pressure force is mainly balanced by the coriolis force
研究表明：在磨刀門河口動力平衡中，縱向的主要平衡項為壓力項和垂向渦動摩擦項，側向的主要平衡項為側向正壓力項和科氏力項。A study on the reinforced heat exchanging caused by delta winglet pair vortex generators
縱向渦強化換熱的實驗研究The experimental and numerical studies on the two enhanced tubes are performed. the strong multi - longitudinal vortex flow in the aea - tube is induced by alternating change of the elliptical cross - section, and for the ddir - tube, the strong multi - longitudinal vortex flow is
交叉縮放橢圓管是通過橢圓截面的交叉變化誘導產生強烈的二次流和多縱向渦流，而不連續雙斜向內肋管則是通過不連續的雙斜向內肋對的作用形成強烈的多縱向渦。In arbitrary curvilinear coordinate systems, three dimensional turbulent combustion flow fields of the three kinds of turbofan engine afterburner with the longitudinal heat shield 、 outer cold flow and the jet nozzle are simulated. the three - dimensional body - fitted grids are generated by an elliptical grid generation procedure and zone method
本文在任意曲線坐標系統下對三種帶有縱向隔熱屏、外冷卻通道和尾噴管的渦扇發動機加力燃燒室的三維紊流燃燒流場進行數值模擬。The integral method is adopted caculate and analyze to amf three - dimension distruction which is the structure of coil type four - pole and the structure of coil type double - pole and study the size of two kind of electrode structure axial magnetic flux density distribution and its fielduniformity. the finite - element method is used simulate that eddy current has effect on amf when contact tray of douple - pole amf structure is slotted or no
本文採用積分方法對本文設計的線圈式兩極縱向磁場觸頭結構和線圈式四級縱向磁場觸頭結構的縱向磁場三維分佈進行了計算分析。研究了電弧燃燒期間兩種觸頭結構縱向磁場強度的大小、均勻性，利用有限元法模擬線圈式兩極縱向磁場觸頭結構的觸頭盤開槽和不開槽時渦流對縱向磁場的影響。This paper mainly studied generation and develepment of the longitudinal vortex and its mechanism for the heat transfer enchancement
本文主要研究了縱向渦的發生發展規律及其強化換熱機理。Numerical simulation by cfd was carried out to understand the hot current behavior in a tunnel with longitudinal ventilation. it becomes clear that fire source modeling is very important because the hot current behavior is strongly affected by the fire source position and is sensitive to methods in the modeling of the fire source. the flame area which has developed from the fire source is an area of chemical reaction caused by combustion. even if grids in the vicinity of the fire source are made fine, it was difficult to simulate the heat generation area with consideration to this chemical reaction through using a method for setting the heat release rate simply on the fire source surface. therefore, we proposed a method adopting the knowledge on flame shape under the longitudinal ventilation and incorporating it into numerical simulation and it showed a good agreement with the experimental results. it was shown through experiments in a tunnel with longitudinal ventilation that the hot current developed toward the tunnel center downwind from the fire source near a wall. the cause was investigated by numerical simulation and it became clear from the results that the spiral air by the fire plume created a vortex in the crevice between the wall and the plume
運用cfd進行數字模擬，以了解縱向通風隧道內熱煙氣流的特性.通過模擬發現對火源進行模擬非常重要，熱煙氣流特性受火源位置的影響很大，並且對火源模擬方法很敏感.火源生成的火焰區是燃燒引起的化學反應區域.即使火源附近的木垛排列完好，也很難在考慮這些化學反應條件下模擬熱生成區域.建議考慮縱向通風隧道內火焰形狀並對它進行數字模擬.模擬結果與試驗結果非常吻合.試驗證明，在縱向通風隧道內，熱煙氣流從靠近墻體火源處順風向隧道中心蔓延.數字模擬結果發現，火災羽流造成的螺旋上升空氣會在墻體和羽流之間形成一個渦流區Abstract : numerical simulation by cfd was carried out to understand the hot current behavior in a tunnel with longitudinal ventilation. it becomes clear that fire source modeling is very important because the hot current behavior is strongly affected by the fire source position and is sensitive to methods in the modeling of the fire source. the flame area which has developed from the fire source is an area of chemical reaction caused by combustion. even if grids in the vicinity of the fire source are made fine, it was difficult to simulate the heat generation area with consideration to this chemical reaction through using a method for setting the heat release rate simply on the fire source surface. therefore, we proposed a method adopting the knowledge on flame shape under the longitudinal ventilation and incorporating it into numerical simulation and it showed a good agreement with the experimental results. it was shown through experiments in a tunnel with longitudinal ventilation that the hot current developed toward the tunnel center downwind from the fire source near a wall. the cause was investigated by numerical simulation and it became clear from the results that the spiral air by the fire plume created a vortex in the crevice between the wall and the plume
文摘:運用cfd進行數字模擬，以了解縱向通風隧道內熱煙氣流的特性.通過模擬發現對火源進行模擬非常重要，熱煙氣流特性受火源位置的影響很大，並且對火源模擬方法很敏感.火源生成的火焰區是燃燒引起的化學反應區域.即使火源附近的木垛排列完好，也很難在考慮這些化學反應條件下模擬熱生成區域.建議考慮縱向通風隧道內火焰形狀並對它進行數字模擬.模擬結果與試驗結果非常吻合.試驗證明，在縱向通風隧道內，熱煙氣流從靠近墻體火源處順風向隧道中心蔓延.數字模擬結果發現，火災羽流造成的螺旋上升空氣會在墻體和羽流之間形成一個渦流區Tow multi - longitudinal vortex enhanced tubes, the alternating elliptical axis tube ( aea - tube ) and the discrete double - inclined ribs tube ( ddir - tube ), are invented according to the theoretical and numerical analysis
根據理論和數值分析的結果，發明了兩種多縱向渦強化換熱管? ?交叉縮放橢圓管和不連續雙斜內肋管，對其進行了實驗和數值研究。The mean profiles of reynolds stresses bear prodigious specialty, i. e. the lateral fluctuations at the centerline are inhibjied strongly and the longitudinal ones have the tendency of growing continuously, which is induced by the special symmetrical vorticity field
雷諾應力分佈有很大的特殊性，即軸線的橫向應力被強烈地抑制，而縱向應力卻有不斷變大的趨勢，這是由於特殊的對稱渦量場結構引起的。By use of grid - shaping skill and multi - grid solver, the flow - induced vibration of the fluid - conveying pipe in water is studied. the vibration mechanism of the fluid - conveying pipe in water is analyzed, the lift and drag acting on pipe in water are calculated. the results obtained are analyzed and compared to the experimental data referred to
首先對水下輸液管道繞流渦激振動的機理進行了分析，然後，利用網格生成技術及多重網格法求得了輸液管道在不同來流條件（雷諾數）下的橫向升力系數及縱向阻力系數，最後對計算結果進行了分析，並將其與已有的間接實驗結果進行了對比。The numerical analysis indicates that that the multi - longitudinal vortex flow in tubes can markedly enhance both the laminar and turbulent heat transfer with less additional increase of flow resistance
結果表明，管內多縱向渦對層流和湍流換熱的強化效果顯著而流阻增加較少，具有優良的綜合強化換熱性能。It can still decrease influence of the eddy current greatly while contace surface of coil type double - pole amf structure is not need to be slotted, so it can also decrease surplus axial magnetic field when the current is at zero and axial magnetic field hysteresis time
線圈式兩極縱向磁場觸頭結構的觸頭表面不需開槽仍能大大降低了渦流的影響，因此也減小了電流零點時的殘余縱向磁場和縱向磁場滯后時間。I setted up the physical modele and calculation - domain for the conviction heat transfer enchancement by the longitudinal vortex, and did the numerical value simulation for the chang of the velocity filed and temperature filed which influnced by lvg. at the same time, i studied the generation develepment of the longitudinal and its mechanism for the heat transfer enchancement. by the analycise of the result, i got the pricipium rule of how the size, ratio corner and distence of the lvg have influence on the generation and develepment of longitudinal vortex, and gave out the relative construct parameter scope
通過對phoenics軟體進行應用開發，本文建立了渦旋強化換熱的物理模型和計算域，對擾流元作用下的流動速度場和溫度場的變化進行了數值模擬，研究了縱向渦旋發生發展及其強化對流換熱的機理。初步得出了擾流元的有關結構參數如總體尺寸、寬高比、攻角、間距等因素對渦流發生發展的影響規律，並給出了有關結構參數的取值范圍。The calculation to the eddy current on the contact surface and axial magnetic field of contact surface and center surface of contact gap are carried out while the current is at zero. after the iron core of ring type is put in, the eddy current on the contact surface will be increased, the axial magnetic field that the eddy current creates will be also increased
對電流過零時觸頭表面的渦流和觸頭表面及觸頭間隙中心平面上的縱向磁場進行了計算，加入圓環型鐵芯后觸頭表面的渦流增大，渦流產生的縱向磁場增大，在鐵芯中開槽后渦流的平均水平降低，縱向磁場平均值降低。The numerical solution shows that the optimal velocity field for laminar convective heat transfer in tubes is multi - longitudinal vortex flow
數值求解表明，管內層流對流換熱的最優速度場為多縱向渦流態。Through the research of amf contact structure, several kinds of improvement are proposed and the improvement effects of amf density have been analyzed by adopting finite element method with cae. after fully considering the influence of the vortex and residual amf, a new cup - type contact structure with amf has been confirmed
本課題通過對現行杯狀縱磁場結構的研究，提出了幾種改進方案，採用有限元法應用cae手段對改進方案的縱向磁場密度進行了分析，在充分考慮渦流和剩磁的影響后，從中確定了一種新的杯狀縱磁場觸頭結構。We put out a kind of new - style longitudinal vortex generater - columner longitudinal vortex generater cut by slop on the base of summing up the work which got dy the learners at the past
在總結他人成果的基礎上，提出了一種新型的縱向渦流發生元? ?斜切式縱向渦流發生器。Numbercle study longitudinal vortex generration and heat transffer enchancement
縱向渦發生器強化換熱性能的數值研究Consequently, a field coordinated enhancement method by longitudinal vortex flow for convective heat transfer enhancement in tubes is presented
提出了採用多縱向渦強化管內對流換熱的場協同強化方法，並進行了數值分析。分享友人