縱向測試 的英文怎麼說

中文拼音 [zōngxiàngshì]
縱向測試 英文
testing longitudinal
  • : Ⅰ動詞1 (釋放; 放走) release; set free; let go 2 (放任; 不約束) indulge; give oneself up to; l...
  • : 動詞1. (測量) survey; fathom; measure 2. (測度; 推測) conjecture; infer
  • : 名詞(古代占卜用的器具) astrolabe
  • 縱向 : [造紙] direction; machine direction; endwise; longitudinal direction; vertical; longitudinal縱向...
  • 測試 : test; testing; checkout; measurement
  1. The normal levitation of nodal plane tested under ultrasonic dynamic contact action validates the normal dynamic contact model

    用微位移儀實際夾心式換能器節面沿上浮的實驗證實了該模型的分析結論。
  2. In this paper, thermal evolution history of organic matter of the source rocks and hydrocarbon generation history have been researched by tti method, hydrocarbon migration direction and migration times were probed combining with the area structure development feature ; distribution pattern of the main reservoir intervals on lateral and longitudinal have been predicted by researching on development feature and control factors of the reservoir intervals, the actions of reservoir conditions in hydrocarbon accumulation and bearing also were probed combining with pore evolution feature ; the micro - pore feature of regional cap and direct seal in carboniferous - lower triassic in this area have been determined with micro - capillary pressure curve and intrusive mercury curve ; the prospecting districts have been pointed out combining with the hydro - geologic feature, the potential reservoirs were classified according to trap types in this area, the author attempt to evaluate on the hydrocarbon - bearing condition in the str ata of carboniferous ~ lower triassic from hydrocarbon generation and migration reservoir condition, reserved condition etc, and predict the reservoir types and hydrocarbon - bearing patterns combining with the structure evolution. based on above, the author point out that the central block of chenghu - tuditang synclinorium and the southern block of dangyang synclinorium are the advantageous regions for exploration

    本文用tti方法研究了烴源巖有機質的熱演化史和油氣生成史,並結合區內構造發育特徵,探討油氣在區域上的運移方和在時間上的運移期次;通過對儲集層段的發育特徵和控制因素的研究,預了本區主要的儲集層段在橫上和上的分佈規律,並結合孔隙演化特徵,探討儲集條件在油氣聚集成藏中的作用;利用微毛細管壓力曲線法和壓汞法,對石炭系?下三疊統的區域蓋層和直接蓋層的微孔隙特徵進行了定量評價,並結合水文地質分佈特徵,指出有利於油氣保存的地區;根據區內存在的各種圈閉類型,對可能存在的油氣藏進行了分類,並圖從油氣的生成與運移、儲集條件、保存條件等方面,動態地綜合評價石炭系?下三疊統油氣成藏條件,並結合構造演化特徵,預其油氣藏類型和成藏模式。
  3. And this result is extended to the eigenfunction of maxwell ' s equations. then the mode series of step index planar dielectric waveguide and circular optical fiber are studied, including propagation modes and radiation modes. as application, there are three examples : the emergent wave from planar waveguide to free space, the transverse and longitudinal coupling of waveguide and the measurement of scalar gratings

    由於從一個空間到另外一個空間的光束傳播伴隨著界面上各個模式能量之間的耦合,作為應用,本文介紹了完備性在三個情況下的應用:平面波導出射光束的衍射性質、波導的橫耦合以及標量光柵的
  4. The turbulent flow in open channel is tested with laser - doppler anemometer, in which the longitudinal time average velocity and fluctuating velocity of turbulent flow in open channel under the conditions of the sudden changes of roughnesses at different water depths are measured

    摘要通過激光速儀,對壁面糙率突變時的明渠紊流進行驗,量了糙率突變不同水深情況下明渠紊流的時均流速和脈動流速。
  5. It now possesses of not only some production equipment advanced in the national level, such as automatic hydraulic pressure spring eye machines, automatic control quenching furnaces and automatic control tempering furnaces the control accuracy attains 5 and shot blasting machines of landscape and vertical orientation, but also some sophisticated quality detection equipment, such as durometers, metallographic microscopes, stiffness and endurance test machines, etc. besides the hardware equipment, the company has a group of senior specialized technical personnel in the field of the design of the leaf spring processing, the leaf heat treatment as well as the tqc total quality control

    擁有自動液壓卷耳機自動控溫的淬火爐和回火爐爐溫控制精度達到5橫噴丸機等國內先進的生產設備。同時還有為保證質量購置的硬度計金相顯微鏡剛度檢及疲勞驗機等先進的質量檢驗設備。從產品生產開始的每一個環節進行全方位的質量控制。
  6. Non - destructive testing of steel tubes - automatic ultrasonic testing of the weld seam of electric welded steel tubes for the detection of longitudinal imperfections

    鋼管的無損驗.缺陷探用電焊鋼管焊縫的自動超聲波檢驗
  7. The measuring principle of brake acceleration, brake speed, height of vehicle gravity center, pitching inertia of sprung mass and efficiency of suspension anti - pitching are also theoretically discussed to provide new methods for vehicle test research

    進一步說明了該系統在車輛制動減速度、制動初速度、整車質心高度、簧上質量轉動慣量及懸架抗制動點頭率的或計算方法。
  8. Adhesives for load - bearing timber structures - test methods - part 1 : determination of bond strength in longitudinal tensile shear strength

    承重木構件用粘接材料.驗方法.第1部分:拉伸剪切強度中粘結強度的
  9. Adhesives for load - bearing timber structures - test methods - part 1 : determination of bond strength in longitudinal tensile shear strength ; german version en 302 - 1 : 2004

    承重木結構件用粘接材料.驗方法.第1部分:
  10. Pipes and fittings of longitudinally welded stainless steel pipes with spigot and socket for waste water systems - requirements, testing, quality control

    污水系統用帶套管和孔座的焊接不銹鋼管和配件.要求和質量控制
  11. Then the coupling beams with new reinforcement layout were made an inquiry into, and the improvement on the seismic behavior by coupling beams diagonally reinforced with a few rows in end regions was found out at last, based on the observations of the experimental phenomena and the analysis of the measurement result, and by the comparison of seismic behavior by making use of hysteretic response, ductility and energy dissipation behavior, a conclusion is presented : the code for design and construction of reinforced concrete high - rise structures ( the draft asked for advise hi 2000 ) ca n ' t ensure that the coupling beams have fairly good seismic ductility ; the result of improvement of the seismic ductility of the coupling beams by the increase hi stirrups besides the strengthen of longitudinal detailing reinforcement was n ' t obvious ; the coupling beams diagonally reinforced with a few rows in end regions have fairly good mechanisms, and the ductility and the behavior of energy dissipation are better than conventionally reinforced concrete coupling beams, so it is suitable to te tised in short coupling beams

    本文通過對三根小跨高比(均為l h = 1 . 0 )剪力墻洞口連系梁在低周反復荷載作用下的驗,了解了嚴格按《鋼筋混凝土高層建築結構設計與施工規程》 ( 2000年徵求意見稿)設計的連梁具有的抗震性能,研究了採取增大連梁配箍量同時加強構造筋的方案對抗震性能的影響,並進一步對新的配筋形式的連梁進行了探討,了解了在連梁梁端配置多排交叉斜筋方案對連梁抗震性能的改善。通過對驗現象的觀察和量結果的分析,利用荷載?位移滯回曲線、延性和耗能性能等指標對各個件的抗震性能進行了比較,最後得出結論: 《鋼筋混凝土高層建築結構設計與施工規程》 ( 2000年徵求意見稿)不能保證小跨高比連梁具有較好的抗震延性:通過增大連梁配箍量同時加強構造筋的方案對改善連梁的抗震延性的效果不太明顯;梁端配置多排交叉斜筋的連梁具有相對較好的受力性能,其延性和耗能性能等各項性能指標均優于普通配筋連梁,宜在深連梁中採用。
  12. Standard test method for determining the longitudinal load required to detach high heels from footwear

    從鞋靴上除去高跟所要求的負荷定的標準驗方法
  13. Adhesives for load bearing timber structures - test methods - determination of bond strength in longitudinal tensile shear strength

    承重木結構用膠粘劑.驗方法.抗拉伸剪切強度中粘結強度的
  14. According the field test of conduit with high embankment, this paper states the main cause of conduit damage is that the formula or the experience curves with a smaller earth. value of the top of conduit from calculation are used. in order to get rid of the damage the better means is that soft material paved on the top of conduit

    涵洞(管)開裂病害存在非常普遍,本文結合高填土涵洞現場,指出一些設計部門採用了計算值偏小的公式或經驗曲線計算涵洞頂的垂直土壓力,是病害產生的主要原因,較好的解決措施是在涵洞頂鋪填壓縮性大於填土的柔性材料,可以大大減小洞頂垂直土壓力。
  15. This is the first time in this field. 2. putting forward rymaszewski method to square four point probe measurement

    利用rymaszewski法自動消除探針游移影響的優點,將它應用於方形探針法中3
  16. This paper mainly accomplished the following research : summarize the classify and application fields of four - probe testing technology ; take the square four - probe testing technology study by using the advantage of rymaszewski method in auto - eliminating the portrait wandering influence to induct ry method to square - probe testing method ; deeply study the influence of probe wandering to progressed ry method testing result ; complete the design of testing panel and testing circuit, realize the auto - testing of mono crystal wafer ; discuss the image enhancement and threshold selection problem in image identify, and finally accomplish the identify of probe pinpoint. the main new view points of the research : 1. it is the first time for applying image manipulation and analysis technique to the sheet resistance measurement, and achieving the auto - location function of the probe

    為此,本文開展了以下研究工作:綜述了四探針技術的分類以及應用范圍;對方形四探針技術進行了研究,利用rymaszewski法自動消除探針游移影響的優點,將它應用於方形探針法中,並對探針游移對改進rymaszewski法結果的影響進行了深入探討,提出了用圖像識別技術監進行的方法;完成了系統的平臺以及電路的設計,研製出具有圖像識別功能的斜置式方形探針分析儀一臺,實現了矽片電阻率的自動化;對圖像識別過程中涉及到的圖像增強和閾值選擇問題進行了論述,最終實現了對探針針尖的圖像識別以及探針結構的自動調整,保證了方形探針儀的精度。
  17. A series of experiments in a wider range of reynolds number were conducted for the investigation on the spatial and temporal distribution of the low - speed streaks in the near wall region of turbulent open channel flow. for the first time, the relationships between the spacing, the width, the length scale in the streamwise direction and the duration time of low - speed streaks and the reynolds number based on shear velocity were revealed

    在水力光滑區和過渡區對明槽紊流近壁區的帶狀結構進行驗,量並分析了帶狀結構的分佈,首次揭示出低速帶間距、寬度、尺度及持續時間等隨摩阻雷諾數的變化規律。
  18. By analysis the results of in - situ monitoring in the process of pipe jacking, the law of surface deformation perpendicular to pipe axis and along pipe axis, the sub - surface movements perpendicular to the axis of pipe and along the axis of pipe are studied

    通過對頂管工程現場數據的分析,研究了頂管施工引起的管道周圍土體的移動規律,包括地面橫截面和截面變形規律、深層土體沿管道軸線方和垂直於管壁方移動規律。
  19. Steel cord conveyor belts. longitudinal traction test. part 1 : measurment of elongation

    鋼繩傳送帶.牽引驗.第1部分:伸長的
  20. Steel cord conveyor belts. longitudinal traction test. part 2 : measurment of tensile strength

    鋼繩傳送帶.牽引驗.第2部分:抗拉強度的
分享友人