繞接端子 的英文怎麼說

中文拼音 [ràojiēduānzi]
繞接端子 英文
wire wrapping terminal
  • 繞 : 繞名詞1. [書面語] （彎曲） bend2. （姓氏） a surname
  • 接 : Ⅰ動詞1 （靠近;接觸） come into contact with; come close to 2 （連接; 使連接） connect; join; put ...
  • 端 : Ⅰ名詞1 （東西的頭） end; extremity 2 （事情的開頭） beginning 3 （門類; 方面） item; point 4 （原...
  • 子 : 子Ⅰ名詞1 （兒子） son 2 （人的通稱） person 3 （古代特指有學問的男人） ancient title of respect f...
  • 端子 : [電學] （接頭） terminal; post端子電壓 terminal voltage; 端子短路 short circuit of terminals; 端...
  1. To resolve the situation that the sensitivity of present ground fault protection schemes is low for the large - sized hydro - generators, a kind of protection scheme based on the fault component of third - harmonic voltage and two kinds of protection scheme based on the fault component of zero - sequence voltage at the terminals and neutral are developed, and they can obtain higher sensitivity and reliability and provide 100 % protection for the stator windings. the influence of noise on the stator ground fault protection based on the local modulus maximum of wavelet transform is analyzed

    針對目前大型水輪發電機定子繞組單相接地保護靈敏度偏低的問題，通過分析單相接地故障后機端和中性點零序電壓的變化特點，提出了一種基於機端和中性點三次諧波電壓故障分量和兩種基於機端和中性點零序電壓故障分量的高靈敏度、高可靠性保護方案，並實現定子繞組的100 %保護。
  2. The voltage transformer is fully enclosed type the iron core is piled up of the cold roll silicon steel sheet. the iron core, primary and secondary windings are casting resin by advanced vacuum carting equipment. it has a good ability of antipollution and moisture proof. the secondary outlet is wrapped by outlet box with three exits with different directions. it, s convenient. it can prevent from stealing electricity

    本系列電壓互感器為全封閉式結構，鐵芯採用優質冷軋硅鋼片繞制，並經嚴格的熱處理，鐵芯與一次繞組和二次繞組一起以先進的真空澆注工藝用環氧樹脂澆注成型，互感器耐污穢，耐潮濕性能好二次出線端子有出線端子盒，端子盒有三個不同出線方向接線方便，並可實現防竊電措施。
  3. The current transformer is fully enclosed structure. the terminal p1 of the primary winding is as the static contact of the switch cabinet and placed inside the epoxy - resin insulation cavity

    本型電流互感器為全封閉結構，其一次繞組的p1端子，直接作為開關櫃中的靜觸頭被設置在環氧澆注的絕緣空腔內。
  4. The terminals of the rotor winding are connected to three slip rings

    轉子繞組的各端與三個滑環連接。
  5. When a whole winding is not used temporarily, the terminals must be short - circuited

    某整個繞組暫時不用時，必須將端子短接。
分享友人
分享到 Line

分享到臉書