纖維寬度 的英文怎麼說

中文拼音 [xiānwéikuāndù]
纖維寬度 英文
fibre width
  • 纖 : 纖形容詞（細小） fine; minute
  • 維 : Ⅰ動詞1 （連接） tie up; hold together; link 2 （保持; 保全） maintain; safeguard; preserve; keep ...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 纖維 : fibre; staple; filamentary
  1. The experimental results show : the flattop phenomenon on the diode voltage pulse was very apparent for using the carbon fiber cathode, that is to say, the pulse duration of the diode voltage was widened ; moreover, under the condition of the same power of microwave, the pulse duration of the out - put microwave was prolonged by about 30 % ; the peak power of the microwave was enhanced by 3db

    通過在裝置上做的兩種陰極的對比實驗，結果顯示:碳纖維陰極的使用，改善了電子束質量，使輻射微波的脈寬增加了30 %以上，輻射主瓣方向上的功率密度提高了3db以上，頻譜分佈較純凈，實現了微波的高效輸出。
  2. Ray width 1 - 3 cells ; body ray cells procumbent with 1 - 9 rows of upright and / or square

    木纖維細胞壁中等厚度。射線寬l 3細胞。
  3. Here the hsc of sompa is achieved through adding super - effective water reducer, fined slag and silicon fume, and decreasing the water / cement ratio. by varying the area ( spacing ) of tension bars, compressive bars, vertical links and distribution steel and embedding steel fiber and polypropylene fiber we try to improve the behaviors of reinforced high performance concrete one - way spanning slabs in bending, so that its ductility be greater than 5. with the same arrangement of steel the width of bending member is varied to observe the effect of the width / depth ratio on the ultimate compressive strain of concrete

    通過變化受拉筋含筋率和受壓筋、箍筋（鉤筋、分佈筋）含量，或摻加纖維使之成為鋼纖維高強混凝土（ sfrhsc ）和聚丙烯纖維高強混凝土（ pfrhsc ） ，對高強混凝土雙筋截面梁、板的受彎性能進行了試驗研究，試圖改善高強混凝土受彎構件的延性，使其延性比大於5 ；並在相同配筋情況下，通過變化截面寬度，研究了高強混凝土受彎構件的寬高比對壓區混凝土極限應變的影響；並對試驗構件的裂縫發展情況進行了觀測。
  4. The new phenomena, never previously reported in the references, of the pa66 phase morphology in the pp / pa66 in - situ composites varying with pa66 contents ( cd ) are revealed as follows : the diameter or width of pa66 fibers has dispersity, which becomes smaller first and then larger lately with cd. additionally, the number of pa66 unfibrillized paticles increases with cd

    發現和分析討論了pp仔a66原位復合材料中pa66相形態隨其含量ud ）的變化中出現的未見文獻報導的新現象： pa66纖維直徑或寬度存在分散性，此分散性隨cd先變小后變大，另外pa66未成纖粒子數隨cd而趨增多。
  5. Test and analysis results indicate that some little polypropylene fiber in cement concrete can not only reinforce the load _ carrying capacity and rigidity, but also control the crack width and strengthen the ductibility of beams

    對比分析結果表明，適量聚丙烯纖維的摻入能夠提高梁的承載能力和剛度，並能限制裂縫寬度，增加梁的延性。
  6. Here, fem is applied in the analyses of i ) fiber axial stress and interphase shear stress in fragmentation tests during initially applied strain, ii ) influence of temperature on the stress transfer across the interface, iii ) modulus and thickness of the interphase and their influence on interfacial stress transfer, iv ) interfacial debonding process, and v ) fragment aspect ratio, contact friction along the interface and their influences to the interfacial stress transfer efficiency

    在論文的這部分工作中，使用有限元法描述和分析了逐節斷裂試驗中初始應變下的纖維軸向應力和界面相剪切應力，溫度對界面應力傳遞的影響，界面相模量和厚度、纖維節長寬比、界面脫粘過程、界面接觸中的摩擦效應等因素對逐節斷裂試驗中應力傳遞的影響。
  7. ( 1 ) systematic triaxial compression tests are made for the sand reinforced by various national geosynthetics. comprehensive investigations into the interaction characteristics are also made between sand / lime fly ash and various national geosynthetics by direct shear tests and pull out tests, which can help choosing geosynthetic type and understanding the geosynthetic reinforcement mechanism ; ( 2 ) this paper is also firstly systematically presents the results of a comprehensive investigation into the interaction characteristics between lime fly ash and various national geosynthetics ; ( 3 ) by non - linear fem, the influence of the modulus of geosynthetics, the thickness of the soft ground and the width of the foundation on the effectiveness of geosynthetic reinforcement are also studied ; ( 4 ) the main conclusions are as followed : ( geotextiles are likely to be suited for projects allowing high displacement, polyester warp knitting geogrids and oriented geogrids for projects allowing medium displacement, glass fiber geogrids for projects allowing low displacement and geonets for secondary projects. ( the confining effect of fill material to act on different kinds of geosynthetics varies largely, which must be considered

    （ 1 ）本文利用三軸壓縮試驗，比較各種國產土工合成材料對砂土的加筋效果；利用直剪試驗和拉拔試驗，比較各種國產土工合成材料與砂土或石灰粉煤灰的界面摩擦特性，深入研究土工合成材料的加筋機理，首次明確提出加筋土工合成材料的選型原則； （ 2 ）本文首次系統地研究了石灰粉煤灰與各種國產土工合成材料的界面摩擦特性； （ 3 ）本文採用有限元法，系統研究了加筋模量、軟土地基厚度、基礎寬度等因素對土工合成材料加固軟土地基效果的影響； （ 4 ）本文主要結論如下： （無紡土工織物適合用於允許大變形的加筋土工程；滌綸纖維經編土工格柵和塑料拉伸土工格柵適合用於對變形有較嚴格要求的加筋土工程；玻璃纖維經編土工格柵適合用於對變形有嚴格要求的加筋工程；土工網適合用於低等級的加筋土工程。
  8. Optical fibres - measurement methods and test procedures - bandwidth

    光學纖維.測量方法和試驗規程.頻帶寬度
  9. Optical fibres - part 1 - 41 : measurement methods and test procedures ; bandwidth

    光學纖維.第1 - 41部分:測量方法和試驗程序.頻帶寬度
  10. Optical fibres - part 1 - 41 : measurement methods and test procedures - bandwidth iec 60793 - 1 - 41 : 2003 ; german version en 60793 - 1 - 41 : 2003

    光學纖維.第1 - 41部分:測量方法和試驗程序.頻帶寬度
  11. Ae signals released from different lay - ups composite specimens were acquired by a wideband transducer, and fracture surfaces of the specimens were observed by scanning electron microscope ( sem )

    寬帶傳感器記錄了不同角度纖維鋪層的復合材料試樣在拉伸破壞過程中的聲發射信號，用掃描電子顯微鏡（ sem ）觀察了試樣的幾種典型的損傷破壞斷面，對比分析了不同類型的損傷機制。
  12. Steel fiber scatters stress converging in the area of the top end of tiny cracks, restrict the occurrence and development of cracks, diminishes the width of cracks, and enhances the integrity of concrete with the occurrence of cracks via the effect of felting between concrete and steel fiber, and consequently the strength of concrete that resists compression, tension, and shear force increases obviously, and the capability of concrete that resists compact, and fatigue, and the ductility and durability of fissured concrete improve

    鋼纖維削弱了混凝土微裂縫尖端的應力集中、限制並約束裂縫的產生和開展、減小裂縫寬度、尤其是通過粘結作用提高了裂后混凝土的整體性，從而使混凝土的抗拉、抗彎、抗剪強度顯著提高，其抗沖擊、抗疲勞、裂后韌性和耐久性也有較大程度的改善。
  13. The in - plane equivalent elastic modulus and tensile strength of stitched composite laminates are studied, and it ' s found that the in - plane equivalent elastic modulus decreases with the increase of stitch density, stitch thread diameter, maximal misalignment angle and the distortion width, and the range is about 5 %. the tensile strength of stitched composite laminate increases with the increase of stitch step and decreases with the stitch space. the

    研究結果表明：隨著縫紉密度、縫紉線直徑、最大纖維偏轉角和縫紉變形區寬度的增加，縫紉復合材料層合板面內等效模量逐漸降低，最大降幅一般在5 %左右；縫紉復合材料層合板的拉伸強度隨縫紉針距的增加而增大，隨縫紉行距的增加而降低，因此縫紉密度對拉伸強度的影響程度要看具體的縫紉針距和行距。
  14. According to the experiment of influences of fiber structures and the width of edge channel on flow filling, it was found that even a small gap ( l or 2mm ) between the preform and the mold edge could also disrupt the flow pattern, which evidently changed the local permeability of preform. the filling process was simulated using the permeability for different edge width predicted by a. hammami or poiseuille model, which shown good agreement with the experiment results

    實驗研究了纖維鋪層結構及流道縫隙的寬度對充模流動的影響，發現在纖維預成型體和模具壁間存在的較小的縫隙也會對邊緣的流動產生干擾，進而影響增強材料主體的滲透；對于不同的縫隙寬度，分別根據a . hammami模型和poiseuille模型預測邊緣等效滲透率，並進行充模過程數值模擬，與實驗結果吻合較好。
  15. Different stand condition had significant effects on fiber length and fiber length - width ratio of different poplar clones

    結果表明，立地條件對不同的楊樹無性系的纖維長度和長寬比具有顯著影響。
  16. After pulp manufacture, the distribution of fiber length is approaching to normal distribution, and the match of actual summit data to standard summit data is less than perfect

    5個楊樹無性系制裝后的纖維長度都有所下降，纖維寬度都有所上升，長寬比下降。
  17. Base on the ideal sampling theories, fiber length distributions and figrogram of samples taking from the ideal sliver by actual sampler are studied, and factors affecting the distributions curves are researched into, some basic requests and references of sampling are concluded for the future developing of sampler

    摘要在理想的截面取樣理論基礎上，進一步研究了具有一定寬度的取樣夾持器以一定角度從「理想棉條」中取樣時試樣的理論分佈及照影機曲線，並結合實驗分析了取樣影響因素；根據研究結果得出了棉纖維長度測試的取樣要求，為取樣器的進一步開發提供了參? 。
  18. The optimization of fiber placement paths for composite around - parts is studied, and a triangle algorithm is presented which is easy to implement and can be used for the path generation of free form surface - parts. tow width control and shaping error control are also studied

    4 .提出了用於封閉殼體構件的纖維鋪放軌跡規劃的三角形法，具有通用性強、計算簡便的特點;並討論了纖維鋪放的成形精度與絲寬控制方法。
  19. The data used in the ann model are arranged in a format of 8 input parameters that cover the compressive strength, tensile strength and width of cube concrete ; the thickness, the width, the bond length and the elastic modulus of the cfrp plate. 15 sets of experimental data are used for predicting

    神經網路的建立考慮了碳纖維布的厚度、寬度、粘結長度、彈性模量、抗拉強度和混凝土試塊抗壓強度、抗拉強度、寬度這8個參數，運用了118組試驗數據對網路進行訓練，對15組數據進行了預測分析。
  20. In order to investigate fiber morphological characters of poplar before and after pulp manufacture, the fiber length, fiber width, double wall thickness and lumen diameter of fiber of two kinds of poplar from different stand conditions were determined and analyzed

    摘要為了探索制漿前後楊樹纖維形態的變化，對5個楊樹無性系在不同立地條件下的纖維長度、寬度、雙壁厚及腔徑進行了測定和分析。
分享友人
分享到 Line

分享到臉書