置位輸出端 的英文怎麼說

中文拼音 [zhìwèishūchūduān]
置位輸出端 英文
the set output
  • 置 : 動詞1. （擱; 放） place; put; lay 2. （設立; 布置） set up; establish; arrange; fix up 3. （購置） buy; purchase
  • 位 : Ⅰ名詞1 （所在或所佔的地方） place; location 2 （職位; 地位） position; post; status 3 （特指皇帝...
  • 輸 : Ⅰ動詞1 （運輸; 運送） transport; convey 2 [書面語] （捐獻） contribute money; donate 3 （失敗） l...
  • 端 : Ⅰ名詞1 （東西的頭） end; extremity 2 （事情的開頭） beginning 3 （門類; 方面） item; point 4 （原...
  • 輸出 : 1 （從內部送到外部） export 2 [電學] output; outcome; outlet; out fan; fanout; 輸出變壓器 output ...
  1. It can also cure all sorts of gathering and no gathering inflammation, such as eyelid edge inflammation, seeping otitis media, central retina inflammation, gathering otitis media, chronic pharyngitis, oral ulcer, tongue pain, perleche, facial nerve palsy, bronchitis, rheumatoid arthritis, shoulder - joint - around inflammation, spot baldhead, belt sore, outside pudenda scratch and itch disease, foetus position abnormal etc., all about 100 diseases

    Jh30型氦氖激光治療儀，還可配合光導纖維輸出激光，除作體表照射外，可用於腔洞組織及穴位的照射治療。常規配置有一進一出光纖或一進二出光纖輸出激光。專用與穴位照射的光纖有一進四齣光纖，光纖輸出端可配接穴位固定盤。
  2. The leftmost print position on an output line is always 1

    輸出行最左端的列印位置總是1 。
  3. Second, the results of theory analysis and simulation research show that the output of one cycle controlled bridge switching power amplifier have dc offset because of the nonideal characteristic of reset signal. the magnitude of output dc offset voltage is proportional to width of reset pulse. a voltage compensation technique is used to solve this question, and the computation formula of compensation voltage is gived. the circuit compensated and not are researched through simulation and experiment, which results show that compensated circuit solve the output dc offset effectively

    其次，理論分析和模擬研究結果表明，由於復位脈沖的非理想特性，單周控制的全橋開關功率放大器輸出端存在直流偏置問題，其大小與復位脈沖的寬度成正比。針對輸出直流偏置問題，提出了電壓補償的改進方案，給出了補償電壓的具體計算公式。對補償前和補償后的方案進行了對比模擬研究和實驗研究。
  4. According to the guidline, two nd : yag lasers have been designed and set up, one is end - pumped by lower output power ld using a selfoc micro lens, and the other is end - pumped by high output power ld using a pair of lenses are designed, and the characteristics such as output power and power stabilization of both solid - state lasers are investigated. thirdly, when an empty liquid crystal cell is inserted in the cavity of the nd : yag laser pumped by high power ld, the laser can operates in single axial mode. finally, according to the relationship between the laser output power and the longnitudinal a ld - end - pumped nd : yag laser sensor for displacement measurement has been investigated theoretically and demonstrated experimently, the results indicate that when the mean radius of pumping inside the laser cavity is far less than that of the oscilating laser mode, the exponential of the output power is a gauss function of the longitudinal positon of focused spot of ld pumping beam, both the measurement range and the sensitivity are dependent on the incident pumping power, as the incident pumping power is increased, the measurement range is enlarged and the sensitivity is improve d

    本文首先介紹了ld泵浦nd ： yag激光器的發展狀況、主要特性及其應用，從四能級速率方程出發，推導了ld泵浦nd ： yag激光器的閾值、輸出功率和斜效率的表達式，並簡述了激光器的工作原理、結構型式和倍頻方法；其次，以空間相關的速率方程為基礎，提出了ld端面泵浦nd ： yag激光器的設計方法，給出了一定泵浦耦合方式下，振蕩光模尺寸、最佳輸出耦合率、泵浦光模尺寸、泵浦光焦斑位置等參數的選取依據，以此為依據，設計了自聚焦透鏡耦合小功率ld泵浦nd ： yag激光器和透鏡組耦合高功率ld泵浦nd ： yag激光器，對激光器的輸出功率和功率穩定性等特性進行了實驗研究；再次，在帶尾纖輸出的高功率ld泵浦nd ： yag激光腔內插入一隻空液晶盒，觀察到了激光器以單縱模運轉；最後，根據泵浦光焦斑端面位置對激光輸出功率的影響規律，提出了ld端面泵浦nd ： yag激光位移傳感新方法，並進行了理論和實驗研究，研究結果表明：當激光晶體內泵浦光平均光斑半徑遠小於振西安理工大學碩士學位論文蕩光束腰半徑時，激光輸出功率的自然指數與泵浦光焦斑的縱向位置成高斯變化規律，測量范圍和靈敏度依賴于泵浦功率，隨著泵浦功率的增加，測量范圍擴大，靈敏度提高，當端面泵浦功率為7 . 24w （最大輸出功率為1 . 926w ）時，激光位移傳感器的測量范圍和靈敏度分別是13 . 045mm和0 . 148mw / pm 。
  5. 3 foot is power source terminal at eight - phase left - hand end, they are zero curve 、 live wire 、 ground wire or “ _ ” 、 “ + ” and ground, 5 、 6 foot are lose electric alarming fan - out ( replay normal close point, the equipment cut - out after losing electricity

    左端8位端子的1 、 2 、 3腳為電源端子，分別為零、火、地或「 」 「 」 、地； 5 、 6腳為失電告警輸出端（繼電器常閉點，裝置失電后斷開） 。
  6. Author has investigated the air - volume affect the pressure oscillation in piping system from converse viewpoint. when the structure parameters of the air - volume are some certain value, the pressure oscillation in the exit of the piping system is magnified. this idea makes us a new way to design the power source of high pressure water - jet

    研究表明：當設計的空氣室結構參數（空氣室的容積，安裝位置等）取某組數值時，管道出口端的壓力波動幅值遠大於系統輸入壓力波動幅值，從而為設計高壓脈沖水射流的動力源提供了一條新的思路。
  7. As far as input coupling devices concerned, we design a feasible taper coupler by means of the theory of waveguide coupling and outside cavity waveguide laser and make decision of the sizes of the lens and the taper coupler, and the relative distance of them. the focus of the lens is 65mm and the radius is 5mm. the length of the taper coupler is 15mm, and the radiuses of the input and output ends separately are 17mm and 0. 65mm

    在輸入耦合器方面，藉助于波導耦合和外腔式波導激光器的相關理論，設計了工藝上可行的錐型耦合器，確定了透鏡、耦合器的尺寸以及耦合器與透鏡的相對位置：耦合透鏡的焦距為65mm ，直徑為srnm ，耦合器的長度為15mm ，輸入端直徑為17mm ，輸出端直徑為0
  8. Functions to print to files, the rightmost print position is the current width of the output file, which you can set using the

    函數列印到文件時，最右端的列印位置是輸出文件的當前寬度，可以用
  9. This ttu does well in such sides as : real time data sampling and processing, digital signal input and output, communication with pc and configuration

    最終研製的配電監測終端具有實時數據採集和處理、數字量輸入和輸出、支持標準通信規約、和上位機通訊以及在線配置系統參數等功能。
  10. This ftu does well in such sides as : realtime data sampling and processing, digital signal input and output, communication with pc and configuration

    最終研製的饋線自動化終端具有實時數據採集和處理、數字量輸入和輸出、支持標準通信規約、和上位機通訊以及在線配置系統參數等功能。
分享友人
分享到 Line

分享到臉書