翅氣管 的英文怎麼說

中文拼音 [chìqìguǎn]
翅氣管 英文
wing tracheae
  • 翅 : 名詞1. （翅膀） wing 2. （魚翅） shark's fins3. [動物學] （翼; 翅） ala4. [植物學] （翼瓣） ala
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 管 : Ⅰ名詞1 （管子） pipe; tube 2 （吹奏的樂器） wind musical instrument 3 （形狀似管的電器件） valve;...
  • 氣管 : air tube; windpipe; trachea; weasand; tracheal sac氣管病 tracheopathy; tracheopathia; 氣管切開術 ...
  1. Second, the starting and stopping behaviors under disturbed condition are analyzed and calculated by using the dynamic concentrative parameter model, which gives some advice to better prescribe refrigeration system and set theoretic foundation for carrying out automatic control of refrigeration system. third, the normal running process is analyzed and calculated by means of rational matching theory, which gives some advice on how to better understand the parameter change under steady state and the affection of inlet - parameter on evaporator. fourth, the simulation software with dynamic characteristic is designed, which can be applied to calculate thernio - parameter of cryogen, air humidity and frost thickness under different initial and boundary conditions, and to carry out dynamic simulation under conditions of dryness, wetness and frostiness, at the same time, to achieve detection and simulation at any stage from starting to stopping

    本文的主要內容如下： 1 ）對翅片管蒸發器結構特點進行分析，選取適當的微元控制體，就干、濕和霜工況下對每個微元分別進行傳熱傳質分析，基於經驗關系式確定霜的有關參數，對于霜工況下的霜生長建立模型，經適當假設，運用質量守恆、能量守恆和動量守恆方程建立適合動態模擬的蒸發器數學模型，為系統模擬奠定基礎； 2 ）對蒸發在大擾動下的開、停機過程，運用動態集中參數模型進行分析和計算，為更好地描述製冷系統運行的全過程奠定基礎，同時也為製冷系統實現自動控制提供一定的理論基礎； 3 ）對蒸發器正常運行過程，運用動態分佈參數和參數間定量耦合的觀點來分析和計算，為更好地了解穩態工況下各點參數的變化情況及各入口參數對蒸發器動態特性的影響即蒸發器性能對各參數變化的敏感性； 4 ）編寫翅片管蒸發器動態特性模擬計算程序，可以計算不同邊界條件和初始條件下的製冷劑熱力參數、空氣溫濕度和霜厚度分佈場，實現對翅片管蒸發器在干、濕和霜工況下的動態模擬。
  2. Our main products are micro barometer low pressure gauge low pressure capsule gauge vacuum pressure with low pressure gauge pressure gauge with electrical contact shock - proof electric contact gauge stainless steel pressure gauge dry and glycerin filled pressure gauge normal pressure gauge freon pressure gauge oxygen - acetylene pressure gauge stainless steel vacuum pressure gauges series diaphragm seal pressure gauge diaphragm pressure gauge with electrical contact pp diaphragm seal pressure gauge shock - proof pressure gauge with electrical contact diaphragm seal pressure gauge explosion - proof electric contact pressure gauge minitype pressure gauge accurate pressure gauge test pressure gauges as well as pressure gauge switch pressure separator tube pressure gauge radiator double - metal thermometer all the products can meet both national and international stands,

    一般壓力表氣壓表抗震壓力表充油壓力表全不銹鋼壓力表膜盒微壓表電接點壓力表冷媒壓力表真空壓力表壓力真空表隔膜壓力表微型壓力表差壓表微差壓表絕壓表精密壓力表耐高溫壓力表蒸氣壓力表汽車燃氣壓力表醫用壓力表遠傳壓力表衛生型壓力表壓力表緩沖管壓力表冷凝散熱器壓力表翅片散熱器壓力表開關不銹鋼連接彎管不銹鋼連接軟管轉換接頭油壓連接頭壓力表針閥節流閥及過壓保護附件濾油網加油口油溫油麵計雙金屬溫度計等。
  3. The components of this system are a cross - flow finned - tube evaporator, cross - flow finned - tube gascooler, a reciprocation compressor, a gas - liquid seperator, a double pipe internal heat exchanger and a throttling valve

    系統由一個叉流翅片管式蒸發器、一個叉流翅片管式冷卻器、一臺往復式壓縮機、一個氣液分離器、一個套管式回熱器、一個節流閥組成。
  4. Analysis is made on structure characteristics of the finned - tube, and analysis has been made on the special heat and mass transfer principle of every micro - unit under both dry and wet conditions. appropriate hypothesis is made and based on the energy, mass and momentum equivalent, the evaporator models of dynamic distributed parameters are set up. in addition, the gascooler and internal exchanger models of dynamic and distributed parameters, the throttling valve models and the compressor models are set up, too

    本文的內容如下： 1對翅片管蒸發器的結構特點進行分析，選取適當的微元體，對于干、濕工況下每個微元分別進行傳熱傳質分析，通過適當的假設，利用質量守恆方程、能量守恆方程和動量守恆方程建立了蒸發器的分佈參數數學模型；對回熱器劃分微元建立了分佈參數數學模型；對氣體冷卻器建立了分佈參數數學模型；對壓縮機建立了數學模型；建立了節流閥的數學模型，為系統模擬奠定了基礎。
  5. The corrugated tank made of high quality cold - rolled - steel sheet manufactured with special production line. it can swell up or shrink compensating the oil from atmosphere. protect and delay the oil and the insulation against degradation, therefore enhance the operation reliability and free of maintenance under normal conditions

    全密封變壓器與普通油浸式變壓器相比，取消了儲油櫃，由波紋油箱的波翅代替油管作為冷卻散熱元件，波紋油箱由優質冷軋薄鋼板在專用生產線上製造，波翅可以隨變壓器油體積的脹縮而脹縮，從而使變壓器內部與大氣隔絕，防止和減緩油層的劣化和絕緣受潮，增強運行可靠性，正常運行免維護。
  6. For the reason that the defrost methods of ashp can not satisfied the need of owners, a novel adaptive defrost method is brought forward, which is grounded on the modern modeling techniques and the change rate of tube - fine temperatures. the method integrates the surrounding conditions and the response of the ashp during operation

    針對目前空氣源熱泵機組除霜過程中存在的問題，提出了一種基於現代模擬技術和管翅片溫度變化率為基礎的自適用控制技術，並探討了這種技術的如何實現問題，為實現真正的按需除霜提供了理論上的依據。
  7. It tell us : the abrasive capability of fly ash ; the similar calculation of ash erosion ; the calculation of ash erosion in the tube in turn and tube out of turn ; the reason of tube abrasion for gas flue ; the influence of air parameter for fly ash erosion ; the influence of changing temperature ; the influence of the flue gas composition, etc. next, it advances the solving measure ; reduce the flue gas velocity ; reduce the concentration of fly ash ; responsible construction : replace smooth tube with spiral tube ; use the new material of abrasion ; fuel desulfurization ; reduce so3 of flue gas ; raise flue gas temperature, making it up the dew point ; use the abrasion - resistance material to resist abrasion

    討論了飛灰磨損性能、管壁受飛灰沖蝕的近似計算、灰粒對順列管和錯列管的磨損計算、煙氣走廊引起對流管束的磨損機理、空氣動力參數對飛灰沖蝕的影響以及受熱面壁溫變化及煙氣成份對飛灰磨損的影響等問題。接著提出了解決的措施：降低平均煙氣流速；降低飛灰濃度；使用鰭片管、螺旋翅片管代替光管；選擇合適的結構及排列方式，減少煙氣中so3的含量；提高受熱面壁溫使之大於煙氣的露點溫度；採用抗腐蝕材料作受熱面等防腐蝕的措施。
  8. Effects of outdoor air parameters on frosting characteristics of fin - tube evaporator for air source heat pump unit

    室外環境參數對空氣源熱泵翅片管蒸發器動態結霜特性的影響
分享友人
分享到 Line

分享到臉書