耐折性能 的英文怎麼說

中文拼音 [nàizhéxìngnéng]
耐折性能 英文
bending quality
  • 耐 : 動詞（受得住; 禁得起） be able to bear or endure
  • 折 : 折動詞[口語]1. （翻轉） roll over; turn over 2. （倒過來倒過去） pour back and forth between two containers
  • 性 : Ⅰ名詞1 （性格） nature; character; disposition 2 （性能; 性質） property; quality 3 （性別） sex ...
  • 能 : 能名詞（姓氏） a surname
  1. Results show that : ( 1 ) for each particle size of andalusite, variation tendency of the properties of the material is generally the same : the maximum of bulk density, compressive strength and rupture strength appears in the range of 5 % - 10 % content of fiber, these properties of the material remarkably decrease as the fiber content exceed 10 % ; while at the same fiber content, the properties of the material increase with the increase of firing temperature

    結果表明： （ 1 ）對于不同粒度的原料，性能變化規律大致相同：在同一燒成溫度下，體積密度、常溫耐壓強度、常溫抗折強度在5 10之間出現峰值，加入量超過10之後材料的性能明顯下降；在相同的纖維含量下，隨著燒成溫度的提高，試樣的各項性能均有所上升。
  2. Butyl acrylate was selected as the tender monomer in prepared bpua, and when the viscosity of middle multipolymer is 800 - 1000mpa. s, the last prepolymer had good capability. in the applied research, some influencing factors such as diluent, photoinitiator and photoinitiators that match to different pigments on the coating film were studied

    根據研究的結果，進行大量的配方實驗，研製了適合於皮革使用的uv上光油，經性能測試顯示：光澤度110 、耐折性3萬次、耐溶劑性200次、附著力合格，達到皮革上光油的使用要求。
  3. Energy consume, electric strength, insulation resistance, ground conductivity, leakage current, microwave leakage, power input, normal temperature, humidity treatment, glow wire, horizontal flame, vertical flame, tracking, ball pressure, rainproof, water splash, dustproof, salt fog, endurance, motor load test, cord flexing, cord pulling, pull & torque test, lamp replacement, construction check etc

    能耗、電氣強度、絕緣電阻、接地連續性、泄漏電流、微波泄漏、功率、溫升、濕熱試驗、灼熱絲、水平燃燒、垂直燃燒、漏電起痕、球壓試驗、防雨淋、防濺水、粉塵、鹽霧、耐久性（壽命）試驗、電機負載試驗、電源線彎折、電源線提拉、拉扭力測試、燈頭互換性、安全結構檢查等。
  4. Especially on high - class sofa leather, the coating of the finishing process shall not be too thick, and it must cover up the natural defects shown at the surface and to evenly distribute the surface color, regulate the touch and glow of the leather surface, above all, it must have the best cohesion, bend - resist characters, also, it must have resistance for abrasive light, aging and color - migration, etc.

    尤其高級沙發皮，塗飾的薄膜不可太厚，且要遮蓋皮面一些天然的瑕疵和均勻表面的色澤，調整皮面的手感和光澤，更須要有很好的接著力、耐曲折性，又要有極佳耐刮摩性和耐光度，且能耐老化性、不吐色等之物性。
  5. The performance of concrete at the later age ( after 60 days ) is improved when fly ash is added into concrete, and the abrasion resistance of concrete is perfect at 28 days. entraining air into concrete, the compressive strength is reduced but the flexural strength is improved when the air content less than 5. 5 %

    摻粉煤灰混凝土的各項性能在後期（ 60d后）均有所改善，其中耐磨性在28d時表現了較好的結果。在混凝土中引氣后，混凝土的抗壓強度下降較多但抗折強度在適宜的含氣量范圍內（小於5 . 5 % ）有所提高，混凝土的抗凍性顯著提高，同時不會降低混凝土的耐磨性。
  6. The membrane layer is formed by the vacuum forming technology. by controlling the weight and the ratio of long path of ceramics fiber, changing the operation factor reasonably of vacuum forming, we can obtain the ceramic fiber composite membrane layer, which has pore diameters of about 5 to about 30um, porosity i s 50 - 80 %, and tensile strength is about 4. 1to 18. 1mpa and thickness of membrane layer is 0. 5 - 2 mm, has the good thermal shock resistance and peal off

    膜層採用真空抽濾成型工藝，通過控制膜組分中陶瓷纖維長徑比、纖維加入量、成型時料漿濃度、成型壓力及成型時間等可以獲得膜孔徑5 ? 30 m 、氣孔率50 ? 80 、抗折強度4 . 3 ? 18mpa 、膜層厚度0 . 5 ? 2mm 、具有良好熱性能和耐剝離性能的陶瓷纖維復合微濾膜材料。
  7. Our carborundum planks bonded of oxide can offer high mechanical strength at high temperature, excellent heat stability, oxidization resistance, good distortion resistance at high temperature ; high thermal conductivity, excellent corrosion resistance at high temperature ; excellent corrosion resistance against chemicals ; high abrasion resistance

    宜興市丁山耐火器材有限公司生產的氧化物結合碳化硅棚板具有優異的熱震穩定性和抗氧化性、極高的高溫抗折強度、高溫下抗變形性能強、熱傳導度高、抗化學侵蝕及耐磨性好等優點。
  8. The tests of e - o applications by our flux ktp has been realized, the results showed : optical waveguides fabricated by using an ion - exchange process, which have an exchange - ion concentration depth profile and refractive - index profile, is close to a complementary error - function distribution, optical homogeneity and device thermal stability is much better. amplitude modulation switch formed by our flux ktp has the contrast ratio of 150 : 1 and insert loss is 2. 5 % at 1064 nm. high quality optical pulse with 1 ns width was cut successfully by using an e - o modulator from a laser pulse with 50 ns width, this modulator had run for three years, and the crystal did n ' t blackened, it showed our low conductivity flux ktp can endure high modulation voltage for a very long time

    Ktp晶體的電光應用試驗表明：用離子交換法製作的電光波導，其離子交換濃度、折射率變化符合餘弦誤差函數，光學均勻性以及器件的溫度穩定性較好；製作的強度調制電光開關，消光比為150 ： 1 ，對1064nm激光的插入損耗為2 . 5 ；製作的電光調制器用於激光脈沖整形試驗，從脈沖寬度50ns的激光脈沖削出脈寬1ns的高質量光脈沖，該電光開關經過長達三年多的使用，沒有出現晶體變黑現象，說明本實驗的低電導率ktp晶體能夠耐受長時間的調制電壓。
  9. 4. by process - structure tactics, we obtain a structure model of middle school student ' s test mental quality. the model contains three dimension, nineteen factors : the sense of psychological control ( the ability of self - mastery, impulsion, insistence, self - confidence, the belief of control, the tendency of control and the fluctuation of emotion ) ; mental energy ( the cognitive ability, diligence, activity, metacognitive monitor, metacognitive consciousness, the desire for achievement, the control and adjust of emotion, the sense of responsibility ) ; mental resilience ( the cognitive ability, optimism, easy and excitement, independence and the control and adjust of emotion )

    4採用過程結構策略，獲得了由3個維度、 19個因素構成的中學生考試心理素質結構模型：心理控制感（自制力、自信、控制傾向、沖動性、堅持性、控制信念和情緒波動性） 、心理能量（認知能力、勤奮、情緒調控、責任感、元認知意識、挫折耐受力、活動性、成就欲和元認知監控）和心理彈性（認知能力、樂觀主義、輕松興奮、獨立性和情緒調控） 。
  10. The essay researched the compressive strength, bending strength, impact resistance and abrasion resistance of high strength polypropylene fibermesh concrete the mechanism of enhancing the properties of high strengh poloypropylence fibemesh road concrete composite was discussed and analyzed the regression on tensile strengh with portland cement mixed with fiber was derived using experiment the tensile strength of fiber soil stablization with porland cement was increased with dosage and length of fiber while the former was more effective than the latter test and analysis results indicate that polypropylene fiber can not only reinforce the strength of concrete, but also obviously promote the flexural fatigue life by the great stress the application of polypropylence fiber reinforced concrete in pavement construcion are also introduced

    文章研究了不同摻量有機纖維混凝土的抗壓、抗折強度、抗沖及性能、疲勞性能及耐磨性等各種路用性能，綜合論述了有機纖維對水泥混凝土路用性能的影響。通過試驗闡述了纖維水泥混凝土各種路用性能與纖維摻量、長度間的關系。分析表明纖維水泥混凝土隨著纖維摻量和長度增加而增加，且纖維摻量對纖維混凝土抗拉強度的影響比纖維長度的影響更大。
  11. Mechanical folding test was applied to analyze the crack behavior of dlc films. the results show that the crack appears due to the mechanical stress and the initiation and propagations of the cracks may be suppressed with higher rf power, bias voltage and gas pressure

    機械彎折試驗結果表明，沉積成膜過程中，應選擇較高的氣壓、基板負偏壓、射頻功率以及適量的n摻雜來制備抗往復彎折的、耐失效性能優越的膜層。
  12. We have been produced high fluid structural lightweight aggregate concrete which apparent density is 1800kg / m ~ 3 and 28d compressive strength is 50 ~ 60mpa by

    對軸心抗壓強度、抗折強度、彈性模量和抗滲性能的檢測表明，所配混凝土具有良好的物理力學性能和耐久性。
  13. The experiment test results of mechanical properties and durability of hprrc show : no matter at early age or later age, the ration of flexural strength to the cubic compression strength of hprrc is higher than ordinary concrete, and the brittleness of hprrc is reduced ; the bond performance of new - old concrete interface and chloride permeability are good ; its resistance to freeze and thaw, permeability are all excellent ; its volume stability is improved, and its cracking resistance is good

    配製出和易性優良（坍落度30mm ） 12 48h能滿足開放交通的hprrc 。 5 、 hprrc力學性能、耐久性能試驗結果表明：無論早期還是後期，其折壓比均比普通砼的有所提高，脆性有所降低；新老砼粘結性能優良；並具有優異的抗凍性、抗滲性、耐磨性，抗氯離子滲透能力強；體積穩定性大為提高，抗裂性好。
分享友人
分享到 Line

分享到臉書