耐燃性試驗機 的英文怎麼說

中文拼音 [nàiránxìngshìyàn]
耐燃性試驗機 英文
flammability tester
  • : 動詞(受得住; 禁得起) be able to bear or endure
  • : 動詞1. (燃燒) burn 2. (引火點著) ignite; light
  • : Ⅰ名詞1 (性格) nature; character; disposition 2 (性能; 性質) property; quality 3 (性別) sex ...
  • : 名詞(古代占卜用的器具) astrolabe
  • : 動詞1. (察看; 查考) examine; check; test 2. (產生預期的效果) prove effective; produce the expected result
  • : machineengine
  • 試驗 : trial; experiment; test
  1. Energy consume, electric strength, insulation resistance, ground conductivity, leakage current, microwave leakage, power input, normal temperature, humidity treatment, glow wire, horizontal flame, vertical flame, tracking, ball pressure, rainproof, water splash, dustproof, salt fog, endurance, motor load test, cord flexing, cord pulling, pull & torque test, lamp replacement, construction check etc

    能耗、電氣強度、絕緣電阻、接地連續、泄漏電流、微波泄漏、功率、溫升、濕熱、灼熱絲、水平燒、垂直燒、漏電起痕、球壓、防雨淋、防濺水、粉塵、鹽霧、(壽命)、電負載、電源線彎折、電源線提拉、拉扭力測、燈頭互換、安全結構檢查等。
  2. Our main products are the physical performance index inspection apparatus and equipments of spectacles : the whole set of inspection equipment of spectacle products such as sunglasses intellect detection apparatus, lens impact test enginery, resin lens combustion - prevent test enginery, resin lens friction test enginery, spectacle easel bridge of the nose deformation test enginery, pull test enginery and so on

    主要生產檢眼鏡產品各項物理能指標的儀器設備:太陽鏡智能檢測儀、鏡片沖擊、樹脂鏡片阻、樹脂鏡片摩擦、眼鏡架疲勞、眼鏡架鼻樑變形、拉力等眼鏡產品的成套檢測設備。
  3. Full - flow lubricating oil filters for internal combustion engines - methods of test for resistance to high differential pressure and to elevated temperature

    滿流式潤滑油過濾器.第3部分:高壓差和高溫方法
  4. Methods of test for full - flow lubricating oil filters for internal combustion engines. part 3 : resistance to high pressure drop and to elevated temperature

    用全流量潤滑油過濾器的方法.第3部分:高壓降和高溫
  5. Railway applications - railway rolling stock cables having special fire performance - test methods ; german version en 50305 : 2002

    鐵路設施.具有特殊能的鐵路車電纜方法
  6. Lamp caps and holders together with gauges for the control and safety ; part 2 : lampholders iec 61 - 2 : 1969 supplements 2e : 1977 to 2k : 1992, modified

    全流式油濾清器方法第3部分:高壓差和高溫特
  7. Methods of test for full - flow lubricating oil filters for internal combustion engines - part 3 : resistance to high differential pressure and to elevated temperature

    全流式油濾清器方法第3部分:高壓差和高溫特
  8. Aerospace series - cables, electrical, aircraft use - test methods - fire resistance

    航空航天系列.飛用電纜.方法.
  9. Electromechanical components for electronic equipment - basic testing procedures and measuring methods - test 20b - flammability tests - fireproofness - section 2 : test 20b - fireproofness

    電子設備用電元件.基本程序和測量方法.20b .易..第2節:20b .
  10. The factors that have effect on the car ' s emission such as cleaning inside engine, size of three - way catalytic converter and leakage of exhaust system etc have been tested and analyzed, and some related parameters are determined. in order to ensure that the emission meets the requirements of the euro ii standard at one time, to pass the examination of 80000km durability, and to achieve excellent performance indicator while assuring the emission requirements, the design of intake manifold and camshaft profile is optimized, the test of engine performance and car ' s emission and environment performance have been conducted. through comparison by test, it is shown that the carburetor engine after retrofitting to electronic fuel injection engine has achieved good level in terms of emission and performance, and has been upgraded to the same level as the engine of japan mitsubishi and suzuki

    為了滿足國家環保法規不斷提高的要求,本文對化油器式發動改造成電控油噴射式發動進行了研究與開發;確定了工程方案和開發目標;對內凈化、三元催化器體積、排氣系統漏氣等對整車排放的影響進行了和分析,確定了相關參數;為了確保對整車排放的影響進行了和分析,確定了相關參數;為了確保排放一次通過歐標準,並完成8萬公里考核,在確保排放的同時達到良好的能指標,對進氣歧管、凸輪軸型面的設計進行了優化;並進行了發動能測,整車排入測和環境能測
分享友人