耗散功率 的英文怎麼說

中文拼音 [hàosǎngōnglǜ]
耗散功率 英文
di ipated power
  • 耗 : Ⅰ動1 （減損; 消耗） consume; cost 2 [方言] （拖延） waste time; dawdle Ⅱ名詞1 （壞的音信或消息） ...
  • 散 : 散動詞1. （由聚集而分離） break up; disperse 2. （散布） distribute; disseminate; give out 3. （排除） dispel; let out
  • 功 : 名詞1 （功勞） exploit; merit; meritorious service [deed]: 戰功 military exploits; 立功 render me...
  • 率 : 率名詞（比值） rate; ratio; proportion
  1. This diode produces about nine times more radiant power than that one.

    這只二級管的耗散功率比那隻大8倍。
  2. Extremum problem in the wheatstone bridge circuit

    惠斯通電橋電路中耗散功率的極值問題
  3. This experiment focuses on the characteristic of green refrigerant r600a in a small parallel flow aluminum closed two - phase thermosiphon and measures all the quantity of injected mass and heat dissipation, the speed of air and the difference of temperature of the electronic element ( cpu simulate chip ) surface and environment

    處理速度達到g數量級，功率消耗更達幾十瓦。如何解決cpu散熱問題，成為關注的焦點。本實驗首次研究了綠色環保工質r600a在一種鋁質重力熱管中的工作特性。
  4. Laboratory measurement of the power dissipation characteristics of aeolian vibration dampers for single conductors

    單根導線風吹震動阻尼器功率耗散特性的實驗室測量
  5. And the results of calculation and numerical simulation indicate, without increasing the intrinsic collector - junction area of power devices, collector - combed structure helps to raise the intrinsic heat - dissipating area and base ' s perimeter, improve heat - dissipating method of each cell of the chip, enhance the distribution uniformity of junction temperature and current of each cell of the chip, reduce the thermal resistance and raise the dissipation power pd and output power p0, fairly well relax the contradiction among frequency, out - put power and dissipation power of the devices, and further improve the devices " property against second breakdown

    而計算分析和二維數值模擬分析結果表明：梳狀集電結（基區）結構在不增加器件本徵集電結面積的條件下，增大了器件的本徵散熱面積和基區周長，改進了每個子器件單元內的散熱方式，提高了單元內結溫和電流分佈的均勻性，降低了器件的熱阻，增大了器件的耗散功率和輸出功率，較好地緩解了目前傳統結構中頻率與功率、功耗的矛盾，並有利於改善器件抗二次擊穿的性能。
  6. We firstly summarize the development of yb - doped fiber lasers, pumping methods and the applications of high - power fiber lasers. 2. considering the scattering loss, we deduce the relationships between laser performances of yb - doped double - clad fiber laser and parameters of laser cavity from the steady state rate equations, numerically analysis the changes of laser performances, such as laser power with the parameters of laser cavity, including output mirror reflectivity, optimum length of double clad fiber

    研究主要內容包括如下幾個方面:一、首先對摻鐿光纖及摻鐿光纖激光器的發展狀況、包層泵浦技術和高功率光纖激光器的應用等進行了綜述;二、在前人對高功率雙包層光纖激光器的理論基礎上，在考慮了光纖散射損耗因子的情況對光纖激光器理論進行了推導，給出了準解析解，進一步完善了理論分析。
  7. The temperature rises and the dc voltage are proportional to the power dissipated, which is equal to the power of the source being measured if the input impedance is suitably matched to the source impedance

    熱偶冷熱結之間的溫度差和熱電勢均正比于耗散在ta2n電阻上的微波功率，如果熱偶的工作電阻與同軸傳輸系統電阻匹配適當，該功率就等於被測源的功率。
  8. Measuring of dissipation power

    耗散功率的測定
  9. Anode dissipation power

    屏極耗散功率
  10. Blank detail specification for metal - ceramic transmitting tubes dissipation over 1kw

    陽極耗散功率大於1kw的金屬陶瓷發射管空白詳細規范
  11. Blank detail specification for glass enevelope transmitting tubes of anode dissipation over 1kw

    陽極耗散功率大於1kw的玻殼發射管空白詳細規范
  12. Blank detail specification for small power transmitting tubes of anode dissipation up to 1kw

    陽極耗散功率不大於1kw的小功率發射管空白詳細規范
  13. Measurements of the electrical properties of transmitting tubes - measuring methods of maximum grid dissipation power

    發射管電性能測試方法柵極最大耗散功率的測試方法
  14. Based on the analysis of damper movement during load test period, a concept for the dissipation power of damper is suggested

    摘要根據阻尼器的加載過程分析，提出了阻尼器耗散功率概念。
  15. Measurements of the electrical properties of transmitting tubes - measuring methods of maximum anode dissipation power and anode overload dissipation power

    發射管電性能測試方法陽極最大耗散功率和陽極過載耗散功率的測試方法
  16. Experimental sample dct375 with collector - combed structure has better parameter such as icm, pq, pd and / r etc. than traditional - structure devices and overseas devices of the same kind. collector - combed structure technology opens up a new way for the further research of new high - frequency, microwave power devices

    研製出的梳狀集電結（基區）結構試驗管dct375 ，其最大電流容量、最大輸出功率、最大耗散功率以及頻率特性等電參數明顯比傳統結構器件和國外同類產品有大的提高。
  17. The ultimate carrying capacity, fracture process and stress - strain relationship on rock generic material are studied with dissipation structure theory in this paper, which shows the essence of mechanical characteristics on rock generic material can be studied deeply from the point of view of system and energy

    研究結果表明巖石類材料變形系統具有耗散結構的特性，巖石受力產生變形是非線性動力學過程，即系統內部各要素之間發生協調和相干效應，巖石承載力（強度）是外界做功功率和巖石自身耗散能率達到平衡的外在力學表現。
  18. Comparing with the traditional method using hysteretic loop, the method of dissipation power seems obviously more useful when assessing the capacity of damper ' s power dissipation

    對耗散功率譜法和傳統滯回曲線法在評價阻尼器耗能能力方面進行了比較，特別在復雜加載情況下，耗散功率譜法具有顯著的優點。
  19. Moreover, multiple frequency stimulation method can increase consumption of ic obviously and surface diffuse reflection method can improve surface emission coefficient of ic availably

    混和信號激勵法能明顯增大三極體放大電路耗散功率，特別是第一級耗散功率；增頻激勵法能有效提高ic耗散功率；表面漫射法能有效增大元器件的發射系數。
  20. Based on the specification, the right phase control thyristor is chosen and the series number of thyristor is calculated. the paper also calculates the power loss of thyristor under the pulsing load, choosing the heat sink and forecast the temperature rising

    以此為基礎，合理選擇了所用的高壓晶閘管元件，計算了所需元件的串聯個數，對類似於脈沖負荷下的晶閘管耗散功率進行了計算，並選擇了元件的散熱器，預計了元件的溫升。
分享友人
分享到 Line

分享到臉書