耗散效果 的英文怎麼說

中文拼音 [hàosǎnxiàoguǒ]
耗散效果 英文
dissipative effect
  • 耗 : Ⅰ動1 （減損; 消耗） consume; cost 2 [方言] （拖延） waste time; dawdle Ⅱ名詞1 （壞的音信或消息） ...
  • 散 : 散動詞1. （由聚集而分離） break up; disperse 2. （散布） distribute; disseminate; give out 3. （排除） dispel; let out
  • 效 : Ⅰ名詞（效果; 功用） effect; efficiency; result Ⅱ動詞1 （仿效） imitate; follow the example of 2 ...
  • 果 : Ⅰ名詞1 （果子） fruit 2 （事情的結局; 結果） result ; consequence 3 （姓氏） a surname Ⅱ動詞（吃...
  • 效果 : 1. （產生的結果） effect; result 2. [劇] sound effects
  1. This paper introduces that the diffuse heat heating furnace is reduced the consumption of fuel is debased and the preferable effect is got, using the multicrystal mullite fibrous stickup lump to heat preservation in heating furnace wall

    摘要採用多晶莫來石纖維貼面塊對加熱爐爐內壁保溫，減少了爐體的散熱損失，降低了爐子燃耗，取得了較好的效果。
  2. Energy consumption of heating rooms will increase when air exchange rate become large. because the mechanisms of heating methods used currently, such as radiator heating, ceiling heating and warm - air heating, are different from each - other, the indoor thermal environment is not the same when each one of them employed for room heating. for enhancing energy efficiency of heating rooms, indoor thermal comfort and energy saving effects should be investigated when natural ventilation is used to make a good air quality indoors

    房間換氣次數的增加勢必導致供暖房間能耗加大，頂棚輻射、散熱器和熱風等三種採暖方式由於供暖機理不同，形成的室內熱環境特徵不同，通風換氣時產生的通風熱損失也有所區別，為了提高大換氣量房間的供暖節能效果，必須對不同供暖方式在大換氣量情況下的熱舒適性與節能效應進行研究。
  3. On every step, the maximum of the turbulence dissipation rate is at the step tip. because the interaction between the skimming flow and the step tips causes the energy to dissipate continuously, so that the step can have better energy dissipation results

    在每個階梯上，紊動耗散率的最大值出現在階梯的突角處，正是由於滑移主流與階梯突角之間的相互作用使能量不斷耗散，從而使階梯具有良好的消能效果。
  4. For conductive fillers / piezoelectric ceramic / polymer composites, based on the piezoelectric and conductive theories, mechanical energy or sound energy can change into electric energy induced by piezoelectric ceramic ' s piezoelectric effect, and then these energy can be dissipated in form of heat energy through conductive network formed by conductive fillers in the system

    在導電填料/壓電陶瓷/聚合物復合材料體系中，根據壓電、導電原理，機械振動能（或聲能）可通過壓電陶瓷的壓電效應轉換為電能，並通過體系中導電填料形成的導電網路，將電能以熱的形式耗散，從而達到減振降噪的效果。
  5. To the question of the low computational efficiency, low computational speed, low stability and unsatisfactory calculation result of the traditional method to get the optimal thresholds, a new multi - dimension thresholding method based on dga ( dissipative genetic algorithm ) that has higher capability and speed of optimization is developed

    模擬結果表明採用耗散結構遺傳演算法進行優化可使圖像處理時間和計算量大大減少，而處理精度並沒有受到影響，且有效避免了遺傳演算法過早陷於局部最優的不足，增強了演算法的穩健性。
  6. A new terahertz source of folded waveguide traveling - wave - tube which based on vacuum electronics is introduced, which may answer the question for scarcity of small, economical terahertz source with continuous wave of high average power. secondly, transmission characteristics of terahertz wave in the periodic slow wave circuit of folded waveguide traveling - wave - tube have been researched combined with development of micro - fabrication technology. dispersion relation and interaction impedance of the slow wave circuit are deduced by the way of equivalent circuit, and results accounted by theory are close to those simulated by software

    其次，結合計算機模擬技術對這種新型太赫茲輻射源的折疊波導慢波線路傳輸特性進行研究:用等效電路法從理論上推導了慢波電路場、色散關系及線路耦合阻抗，電磁模擬軟體計算得出的慢波電路色散曲線與理論計算所得結果基本上一致，表明這種尺寸的慢波電路在太赫茲頻段有著色散曲線較平坦以及寬帶、低損耗的良好傳輸特性。
  7. The ultimate carrying capacity, fracture process and stress - strain relationship on rock generic material are studied with dissipation structure theory in this paper, which shows the essence of mechanical characteristics on rock generic material can be studied deeply from the point of view of system and energy

    研究結果表明巖石類材料變形系統具有耗散結構的特性，巖石受力產生變形是非線性動力學過程，即系統內部各要素之間發生協調和相干效應，巖石承載力（強度）是外界做功功率和巖石自身耗散能率達到平衡的外在力學表現。
  8. Increasing scale of integration and consumption of power has led to the significant increase in power densities encountered in modern electronic equipment. if we do not pay attention to the thermal management of electronic equipment, the large amount of heat generated by the electronic device would not be under the control. especially in some atrocious surroundings, some devices " working temperature would exceed the rated temperature limit and lead to deteriorate the system stabilization or even make the hole system disabled

    現代電子設備的集成度不斷提高、功耗不斷加大，使得熱流密度急劇上升，如果我們在設計階段不注重電子設備的散熱設計，那麼元件所產生的熱流將得不到有效控制，特別是在工作環境比較惡劣或電子設備比較復雜的情況下某些元件的工作溫度就有可能上升到導致整個電子系統的工作不穩定乃至失效。
  9. The results indicate that thermostatic radiator valves can regulate and control indoor temperature effectively and save heating energy consumption, and that using thermostatic radiator valves can produce good economic benefit because the initial investment is lower and the payout period is shorter

    分析結果表明散熱器恆溫控制閥可以有效調控室內溫度和節約供暖能耗；恆溫控制閥初投資低和投資回收期短，在實際應用中可以產生良好的經濟效益。
  10. The numerical results under different methods, especially the simulation of recirculation region and reattachment length were carefully checked and compared. it indicated that the " variable c ? " model could effectively increase the dissipation near the wall and, more over improve the simulation of the reattachment length to close to the experimental results. 4

    比較不同修正方法下的圓管湍流計算結果，尤其是迴流區域和再附著長度的模擬結果表明：變模型常數的-模型有效地的增加了近壁區域的湍能耗散率，使再附著長度的計算結果更接近於實驗結果。
  11. The paper introduces the technique of the recommendation on the basic frame, encoder and decoder ' s main technique and regulation, the syntax and semantics of the bitstream, optional coding algorithm, and etc. in the forth part of the paper, aimed the time - costest and most important technique - discrete cosine transform ( dct ) and motion estimate algorithms, paper analyses the classical and practical algorithms and introduce the theory. then paper sum up all the algorithms character, give out the ameliorated algorithm, and simulate with the c language on the computer. these two algorithm, can be realized using hardware and can be used into the real videophone ' s video module

    論文的第四部分，針對可視電話中最耗費計算時間，也是其中最關鍵的技術? ?離散餘弦變換（ dct ）和運動估計演算法進行的仔細的研究，分析了當前出現的經典的實用演算法，並對其原理進行了研究和介紹，並總結各種演算法的特點和原理，各自提出了其的改進演算法，給出了其原理介紹和實現方法，並在計算機上使用c語言進行了模擬試驗，並達到了較為滿意的效果，這兩種演算法，完全可以通過硬體得以實現並能應用到實際的可視電話的視頻模塊壓縮演算法中去。
  12. The experimental results show that the seismic behavior of strengthened joints is improved significantly by the scheme, which successfully enhances the shear capacity by about 22 %, transforms the failure mode to be ductile, raises the ductility coefficient over 4, delays the strength degradation and stiffness degradation, and upgrades the energy dissipation capacity

    試驗結果表明：加固能夠有效地提高節點的極限受剪承載力22 %左右，改變節點的破壞模式為梁端延性破壞，提高節點的延性系數到4以上，改善節點的承載力退化和剛度退化，提高節點的能量耗散能力，從而顯著改善了樑柱節點的抗震性能。
分享友人
分享到 Line

分享到臉書