耦合負載 的英文怎麼說

中文拼音 [ǒugěfùzǎi]
耦合負載 英文
coupled load
  • 耦 : Ⅰ動詞[書面語] （兩人並耕） plough side by sideⅡ名詞1 （古農具名） plough2 [書面語] （兩人一組） a...
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 負 : Ⅰ名詞1 （負擔） burden; load 2 （虧損） loss 3 （失敗） defeat Ⅱ動詞1 [書面語] （背） carry on th...
  • 載 : 載Ⅰ名詞（年） year : 一年半載 six to twelve months; six months to a year; 三年五載 three to five ...
  • 耦合 : [物理學] coupling; interconnection; catena; linkage; linking
  • 負載 : [電學] load
  1. A high impedance coupling device will limit loading.

    一個高阻抗的耦合裝置將限制負載。
  2. Road vehicles - electrical heavy - duty connector, 2 to 4 poles with pins and bayonet coupling - dimensions

    道路車輛.帶插銷和卡口耦合器的4至6極高負載電氣連接
  3. Road vehicles - electrical heavy - duty connector, 2 to 4 poles with pins and bayonet coupling - requirements and tests

    道路車輛.帶插銷和卡口耦合器的4至6極高負載電氣連接
  4. In some military application such as aviation 、 space flight 、 missile 、 radar and so on, the 10kv isolation voltage is needed, on the basis of it, linearity, capacity of driving load capacitance and reliability are presented

    同時，在航空航天、導彈、雷達等軍事應用上，對光電耦合器提出了10kv以上的隔離電壓的要求，在此基礎上，對線性度、驅動容性負載的能力以及可靠性都有很高的要求。
  5. In the paper, prescale technology, interpolate method, averaging method and multiple period synchronization method are used to measure the frequency accurately. diode demodulating technology, and power attenuated method or probe coupling & water load technology are employed to measure the power of high power microwave. isothermal technology is used to improve the stability of demodulator and to expend the range of square linear region

    本文採用預分頻法、內插法、多周期同步法、平均法實現了頻率的精確測量;利用二極體檢波技術，結合衰減法或探針耦合+水負載技術實現了大功率微波功率的測量;採用恆溫技術提高了二極體檢波器穩定度;完成了單片機串口通信協議設計和系統電磁兼容的分析和設計。
  6. The transient cfd simulation including the spiral case, stay vane, guide vane, runner vane and draft tube at different operation points is studied fitly, then the result of the pressure distribution on runner blade is provided for the runner transient structural simulation by fluid - structure interaction ( fsi ) method

    文中首先對高水頭小負荷的渦帶工況下混流式水輪機內流場進行非定常cfd計算，得到渦帶工況下葉片表面不同時刻的水壓力載荷，並利用流固耦合方法對轉輪進行結構場瞬態特性計算，分析轉輪葉片的動應力特性。
  7. Five different structures are described : standard transformer coupling, parafeed, resistively loaded stage capacitively coupled to the output transformer, tube ( valve ) based constant current source load capacitively coupled to the output transformer, and solid state ( mos fet ) constant current source load capacitively coupled to the output transformer

    我們將討論五種不同的方式：標準變壓器耦合；旁饋耦合；電阻性負載電容性耦合至輸出變壓器；膽恆流源負載電容性耦合至輸出變壓器；以及晶體管恆流源負載電容性耦合至輸出變壓器。
  8. This paper presents design thinking, operation and structure of a load self - locked brake type elevator which features endless stroke, single sheave and rope - groove friction

    摘要介紹1種直重機械中的無限行程單卷盤回轉型繩槽耦合式負載自鎖制動提升機的設計思想、工作原理和結構形式。
  9. It was difficult to measure the load voltage directly between inner and outer conductor of cable induced by shield current under low flux x ray. this paper introduces a measurement, pouring a current, which was same as cable approximately photocurrent in x ray test, into the shield of cable with a triocoaxial system, and the load voltage was got. finally the measured result of typical cable and comparison with the calculation was given with a special load

    在簡要介紹屏蔽電纜的轉移阻抗和轉移導納耦合的基礎上，描述了利用三同軸系統對雙電纜和等效負載組成的電纜系統進行電流注入，模擬電纜屏蔽層發射電流，測量芯線等效負載感應信號的實驗，給出實驗結果及分析，並對理論結果與實驗進行了比較。
  10. On the base of model, considering the disturbance from the other 5 legs and variating load, we design an h - inf controller integrated with ip controller, which makes the system with the advantage of both h - inf control and ip control, and restrains the bad effect from variating disturbance. the simulation shows that this stradgy enhances the system robustness. in another solution, the coupling and load disturbances are regarded as the parameter variations of motor model, and the variation is observed, thus, the coupled dynamics of vamt is decoupled to 6 single motor systems

    在建立了模型的基礎上，本文針對單滑塊控制系統要受到其它滑塊及負載擾動的影響，採用h _控制方法設計的h _控制器與傳統ip位置控制器結合，使得系統具有ip位置控制器和h _控制的雙重優勢，有效地抑制了變化擾動對位置輸出的影響，模擬結果表明該方法大大提高了系統的魯棒性；本文提出的另一種方案是將桿間的耦合作用和負載擾動看作電機參數變化，利用觀測器進行觀測，從而將耦合的機床動力學系統解耦成為6個獨立的電機動力學系統。
  11. The essence of grid computing lies in the efficient and optimal utilization of a wide range of heterogeneous, loosely coupled resources in an organization tied to sophisticated workload - management capabilities or information virtualization

    網格計算的本質在於，在依賴復雜任務負載管理能力或信息虛擬化的企業中，有效並且最佳地利用大量異構的、松耦合的資源。
  12. In the present paper, according to the characteristics of the dynamic running of the thermoelectric refrigerating devices and its components for the refrigerator is analyzed and the independent components " models are established. the entire model describing the working procedure of the refrigerating system is set up with the method of parameters coupling to combine the models of the refrigerating system, load, cabinet and air in the cabinet. the running characteristics of thermoelectric refrigerators on the effects of received current, load and ambient temperature are investigated using small - signal linearization method

    本文根據熱電製冷系統動態運行的特點，分析了電冰箱製冷系統及各個部件的熱物理過程，運用參數耦合的方法把製冷系統、負載、箱體及箱內空氣模型有機地結合在一起，建立了完整的製冷系統工作過程模型，用小階躍信號線性化法分析了電流、負載功率和環境溫度波動共同作用下的熱電製冷器工作特性。
  13. Included three positions system, the helicopter airscrew electro - hydraulic servo loading system has coupling nexus of three positions and three loadings. trough analyzing nexus of the displacement and the force, this paper designs the three channels electro - hydraulic servo loading system basing on the analysis of single channel electro - hydraulic servo loading system. surplus torque, which is produced through position disturbance, is a chief problem facing aerodynamic loading system

    直升機旋翼的操控通過三個助力器完成，模擬負載時把旋翼所受空氣動力折算到了三個助力器上，由於三個助力器是鉸點在一個模擬盤上，所以三通道加載系統與三個助力器位置系統有一定的耦合關系。
  14. Finally, in view of the absorbed po ~ ver of the terminated load and the realizablity of couplers, a proper eclectic distribution of coupling degree of couplers is computed synthetically. 2. a small, light, compact, ~ vide band and high performance h - t coupler with lognitudinal dualslot is presented

    根據天線方向圖要求，確定陣面的口徑分佈，在此基礎上，結合慢波線終端負載的吸收系數，以及耦合器耦合量的可實現性，綜合折中考慮，計算選擇出合適的耦合器耦合度分佈。
  15. Secondly, the dynamic features, surplus torque and loading gradient features of ptss are analyzed by the couple model between the rudder and the eals. it can be concluded that the surplus torque is related directly to the velocity of the rudder, and the loading gradient is the disturbing inverse ratio from the surplus torque to the closed - loop model, which shows the scaling relationship between the input and the disturbance signal act on the eals. it also can be concluded that, under the same dynamic specification, it is more difficult to realize the small loading gradient

    然後，採取把系統模型轉化為舵機和負載模擬器相互耦合作用的形式，對被動式力矩伺服系統動態特性、多餘力矩和加載梯度一一進行理論分析，得出:多餘力矩與舵機運動速度直接相關;加載梯度是在系統閉環模型中，與多餘力矩相關部分模型幅值大小成反比的系數，體現了被動式力矩伺服系統的指令信號和擾動信號之間的比值關系，從而在相同的動態指標下，小加載梯度實現更為困難。
  16. By comparison, implicit euler is better method as a kernel of transmission line simulation computing and programming to transmission line transient with different conditions of boundary and two line coupling or even more complicated internal switching or loading

    本文對傳輸線在不同邊界條件、傳輸線耦合、線路內部突然開路、短路、接內部接各種負載等情況下的暫態過程進行編程計算的到模擬波形。
  17. The dynamic distributed principia on the simulation module are given, as well as the dynamic analyses arithmetic on the load of the servers. the arithmetic which to test the data pertinence of the simulation module which driven by the data source is put forward. the dissertation also designs an efficient distributed arithmetic on the simulation module the concept of xml template is put forward to realize the save format and the backward - compatibility of visualize edit interface system

    研究過程中，作者確立了鬆散耦合分散式的系統架構；給出了模擬模塊動態分散式的原則和服務器負載狀況動態分析演算法，提出了數據源驅動的模擬模塊數據相關性檢測的演算法，設計了簡單而有效的模擬模塊動態分散式演算法；提出了xml模版的概念，實現了存儲格式和可視化編輯界面系統的向後兼容的問題；使用soap實現異構模擬組件的遠程調用與數據交換；提出模擬容器的模型來簡化異構組件間通信對二次開發造成的負擔；建立了模擬模塊自適應檢測的機制，達到模擬演算法系統的通用性。
  18. To satisfy the demand of expansibility and refresh ability about distributed data stream management system, we studied the load - balancing technology and propose the algorithm, which can balance load of tightly - coupled distributed dsms in internet ( 2 ) a load - shedding algorithm is proposed based on sub - path analysis

    針對分散式數據流系統對負載平衡可擴展性和易恢復性的需求，對負載平衡技術進行研究，提出了一種基於雙層重疊結構的負載平衡演算法，該演算法可以滿足internet環境下緊耦合分散式數據流系統進行負載平衡的需求。
  19. In this article, the coupling model of cable was introduced. finally, the calculation of results were given and compared with the experiment

    介紹了利用電纜耦合模型，對兩根電纜組成的電纜系統帶負載情況下的干擾耦合進行了計算，並與實驗數據作了對比，驗證了計算模型的正確性。
  20. The dynamic performance of the liquid power coupling speed system isanalyzed and discussed. the mathematical models and compensation methods controlled by microcomputer are proposed. the load balance of the multi - motor operation is realized in the system

    分析了液力耦合式調速系統的動態性能，提出了微機控制的數學模型和補償控制的計算方法，實現了多臺電機拖動負載平衡運行的控制目標。
分享友人
分享到 Line

分享到臉書