耦合轉發器 的英文怎麼說

中文拼音 [ǒugězhuǎnfāqì]
耦合轉發器 英文
coupling repeater
  • 耦 : Ⅰ動詞[書面語] （兩人並耕） plough side by sideⅡ名詞1 （古農具名） plough2 [書面語] （兩人一組） a...
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 轉 : 轉構詞成分。
  • 發 : 名詞（頭發） hair
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 耦合 : [物理學] coupling; interconnection; catena; linkage; linking
  • 轉發 : retransmission; transmit; repeat; relay
  1. According to the guidline, two nd : yag lasers have been designed and set up, one is end - pumped by lower output power ld using a selfoc micro lens, and the other is end - pumped by high output power ld using a pair of lenses are designed, and the characteristics such as output power and power stabilization of both solid - state lasers are investigated. thirdly, when an empty liquid crystal cell is inserted in the cavity of the nd : yag laser pumped by high power ld, the laser can operates in single axial mode. finally, according to the relationship between the laser output power and the longnitudinal a ld - end - pumped nd : yag laser sensor for displacement measurement has been investigated theoretically and demonstrated experimently, the results indicate that when the mean radius of pumping inside the laser cavity is far less than that of the oscilating laser mode, the exponential of the output power is a gauss function of the longitudinal positon of focused spot of ld pumping beam, both the measurement range and the sensitivity are dependent on the incident pumping power, as the incident pumping power is increased, the measurement range is enlarged and the sensitivity is improve d

    本文首先介紹了ld泵浦nd ： yag激光器的發展狀況、主要特性及其應用，從四能級速率方程出發，推導了ld泵浦nd ： yag激光器的閾值、輸出功率和斜效率的表達式，並簡述了激光器的工作原理、結構型式和倍頻方法；其次，以空間相關的速率方程為基礎，提出了ld端面泵浦nd ： yag激光器的設計方法，給出了一定泵浦耦合方式下，振蕩光模尺寸、最佳輸出耦合率、泵浦光模尺寸、泵浦光焦斑位置等參數的選取依據，以此為依據，設計了自聚焦透鏡耦合小功率ld泵浦nd ： yag激光器和透鏡組耦合高功率ld泵浦nd ： yag激光器，對激光器的輸出功率和功率穩定性等特性進行了實驗研究；再次，在帶尾纖輸出的高功率ld泵浦nd ： yag激光腔內插入一隻空液晶盒，觀察到了激光器以單縱模運轉；最後，根據泵浦光焦斑端面位置對激光輸出功率的影響規律，提出了ld端面泵浦nd ： yag激光位移傳感新方法，並進行了理論和實驗研究，研究結果表明：當激光晶體內泵浦光平均光斑半徑遠小於振西安理工大學碩士學位論文蕩光束腰半徑時，激光輸出功率的自然指數與泵浦光焦斑的縱向位置成高斯變化規律，測量范圍和靈敏度依賴于泵浦功率，隨著泵浦功率的增加，測量范圍擴大，靈敏度提高，當端面泵浦功率為7 . 24w （最大輸出功率為1 . 926w ）時，激光位移傳感器的測量范圍和靈敏度分別是13 . 045mm和0 . 148mw / pm 。
  2. Motion control is a comprehensive subject. modern ac drive is a important embranchment in the field of motion control. however, it is difficult to rea1ize high - performance ac drive systems because induction motors are a kind of strongly - coupled nonlinear system with many variables and the torque is not easy to control. with vector control technology decoupling and torque control of ac motor are solved. the basic idea of vector control is that three - phase system is equiva1ent to two - phase system by coordinate transformation and it realizes the decoupling between field current and torque current of the stator in order to control the flux and current respectively, thus induction motor can be considered dc motor and high performance is achieved easily. with the progress of electric and electronic technology and the development of computer, high - integrated special modules and high - precision digital signal processor ( dsp ) are applied to ac drive so that vector control has been developed rapidly

    但是高性能的交流調速系統實現很困難，這是因為交流電機是多變量、強耦合的非線性系統，不易實現高性能轉矩控制。矢量控制技術則解決了交流電機解耦與轉矩控制問題，其基本思路? ?應用坐標變換將三相等效為二相，實現定子勵磁電流分量與轉矩電流分量之間的解耦，達到對交流電機磁鏈與電流分別控制的目的，交流電機等效為直流電機實現高性能調速。隨著電力電子技術的進步，計算機技術飛躍發展，高度集成的專用模塊和高精度的數字信號處理器應用於交流傳動系統中，促進矢量控制迅猛發展，日趨成熟。
  3. In the second chapter, equivalent circuit of the eddy current sensor is firstly analyzed. based on that, the carrier signal generating circuit that is realized by the lc periodic circuit is introduced, thus, the carrier signal of standard frequency is obtained through the trimming capacity. subsequently, the disc type rotational armature generator and the rotational coupling transformer are separately leaded in to realize the power supplies of the carrier signal generating circuit and output of the measuring signal

    在傳感器設計一章中，首先對渦流傳感器進行等效電路分析，在此基礎上分析了由電感、電容諧振電路構成的載波信號發生電路，並通過微調電容獲得了標準頻率的載波信號；接下來提出了採用盤式旋轉電樞發電機解決載波信號發生電路電源供給問題的方案，同時通過旋轉耦合變壓器的引入，使得測量信號輸出問題很好地解決；本章最後給出的一組實驗曲線充分說明了這一方案的可實現性。
  4. Based on the analysis of gas - solid multiphase catalytic reaction, the chemical reaction model is established. when the reaction is controlled by the chemical dynamic, the reaction rate is introduced by consideration of the adsorption and desorption effects. when the reaction is controlled by mass transfer, the diffusion coefficient is established which can present the flow rate increases in small reynolds domain ; for the internal diffusion, the internal diffusion coefficient is derived, and then the internal diffusion is coupled with chemical reaction to represent the phenomenon that the diffusion and the chemical reaction occur cocurrently

    本文在考慮催化轉化器載體內發生的傳熱傳質現象的基礎上，建立了催化轉化器的一維單孔道和三維多孔道傳熱傳質模型;在分析載體內以氣-固多相催化反應為特點的工作機理的基礎上，建立了催化轉化器的化學反應模型:當催化轉化處于化學動力學控制區時，引入了考慮吸附、表面反應和脫附的表面化學反應速率公式，當催化轉化處于質量輸運控制區時，引入了決定外擴散能力的擴散系數公式和和決定內擴散速率的內擴散系數公式，並與化學反應速率相耦合，得出由擴散過程決定的化學反應速率公式。
  5. However, significant changes have happened to this architecture since the end of 1990s : the border of client and server is vanishing day by day, and multi - tier distributed system is popularizing over time ; distribution has been one of the most important characteristics of network application, and the notion of distribution has generally migrated from tightly coupled, geographically close, homogeneous machines to more loosely coupled, geographically remote, heterogeneous machines

    然而到了90年代以後，客戶機/服務器結構發生了深刻變革：客戶機與服務器的界限日益模糊，多層結構開始流行；分散式成為高性能網路應用的重要特徵，其理念總體上已從緊耦合的、地域集中的、同構的機器轉移到松耦合的、遠程的、異構的機器上。
  6. The programs of system are written with assemble language. in order to resolve the problem of signal jammed, not only we used hardware ( photo couplers, watchdog, special parts, etc. ), but also used some arithmetic ( average, wavelet, etc. ). after analyzing the deficiency of the popular mechanical instrument in motorcycle, this paper focuses on researching and designing the digital instrument. the developing work of ( the research of the led digital multi - parameters instrument in motorcycle ) has been finished and is being commercializing packaged

    我們採用了專用的a / d轉換器作為模擬量的測量，採用光耦器件作為車速、發動機轉速信號的輸入，採用高亮度的led器件作為在強光下顯示器件，採用兩個獨立的微處理器以提高系統的可靠性，採用模擬條和數碼管同時顯示以符合駕駛人員的習慣，同時通過改進演算法，實時處理車速和發動機轉速與數據顯示和數據存儲等技術難點。
  7. A few kinds of signal separate measures, double caner frequency automatc switch function and relay function are taken into account on the design of wfplc - ml iniddle - voltage distribution line carrier modem. coupling equipment is designed with the filter and capacitance fitted togethel in this papef, it is also advanced an scheme about caner signal spanning the distribution line break. the equipment system has been finished and put into use, which has better result. the feasibly and necessity of the studying of this problem are posed

    Wfplc3510中壓配電載波系統利用10kv的架空線或電纜，將主控斷發出的命令信息轉換為載波信號通過三相耦合器耦合到電力傳輸線上，在被控端利用單相耦合器耦合到載波信號后轉換為介面信號發送給被控單元，被控單元亦可將返回數據通過單相耦合發送載波信號到主控端，實現信息的雙向傳遞。
  8. A novel hybrid power system with a double rotor motor as drive coupler is developed

    摘要開發出一種以雙轉子電機為動力耦合器的混合動力系統。
  9. The present invention provides a wideband wavelength converter with four - wave - mixing, which includes a modulated laser diode, a modulator, a first and second polarized controller, a first, second and third tunable lasers, a optical coupler, a soa wavelength converter and a multiplexer

    本發明系提出一種寬頻四波混合波長轉換裝置，其包含調變雷射光源、光調變器、第一及第二極化控制器、第一、第二及第三可調式雷射、光耦合器、半導體光放大器、及一多工器。
分享友人
分享到 Line

分享到臉書