耦合點 的英文怎麼說

中文拼音 [ǒugědiǎn]
耦合點 英文
coupling point
  • 耦 : Ⅰ動詞[書面語] （兩人並耕） plough side by sideⅡ名詞1 （古農具名） plough2 [書面語] （兩人一組） a...
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 點 : Ⅰ名詞1 （液體的小滴） drop （of liquid） 2 （細小的痕跡） spot; dot; speck 3 （漢字的筆畫「、」）...
  • 耦合 : [物理學] coupling; interconnection; catena; linkage; linking
  1. The ieee, 2005, 93 : pp. 669 - 681. 15 foster i. globus toolkit version 4 : software for service - oriented systems. journal of computer science and technology, july 2006, 21 : 513 - 520

    其要點是一種松耦合的軟體套件體系結構，以及虛擬化資源空間網程grip社區agora協程funnel四種系統抽象。
  2. A new numerical procedure for analyzing the coupled vibration of a framed arch bridge with a single moving vehicle is presented to solve the equations of motion of a bridge with many degrees of freedom. the procedure consists in dividing the bridge - vehicle systems, which are solved separately, into 2 subsystems at the interface of the bridge and vehicle. the compatibility at the interface is obtained by an iterative procedure with aitken acceleration

    本文提出新的計算橋梁車激振動反應的方法，車?橋系統被分成兩個相互作用的子系統，這兩個子系統通過接觸點的協調條件耦合在一起，從而應用aiken動態加速法對橋梁運動方程、車輛運動方程和車?橋耦合方程進行高效迭代求解。
  3. Introducing the theory and application of boundary element method on the sound radiation, giving the process of solving vibration noise radiation problem using boundary element analysis software ; presenting the coupling theory and the combination analysis of finite element method and boundary element method, and doing relevant analysis based on close drum shell ; programming the noise data simulation program using the numerical calculation software, simulating the acoustic and pressure data of a key point in the transient response acoustic field of the close drum shell, realizing the audibility of the noise, using the virtual reality tools to simulate the vibration noise of the drum shell ; combining the finite element method and boundary element method to analyze the vibration noise radiation of some gear box, and completing the whole simulation process of the vibration noise of the gear box

    綜合介紹了邊界元法在聲輻射問題上的理論及應用；並給出了運用邊界元法分析軟體求解振動聲輻射問題的過程。闡述了有限元法和邊界元法的耦合理論及組合分析方法，並以封閉鼓形薄殼為分析對象進行了相應的分析。利用數字計算軟體編制了噪聲數據模擬程序，並模擬了通過組合方法分析封閉鼓形薄殼瞬態響應聲場而獲得一關鍵點的聲壓數據，實現聲音的可聽化，隨后通過虛擬現實工具實現了該情形下橢球殼振動噪聲的虛擬模擬。
  4. As a new component of sensor, fiber grating have many instinctive advantages, such as light in weight, anti - cauterization, anti - interference in electromagnetism, high - sensitivity and compaction in construction. it is very easy to be coupled with fibers and the coupling - loss is slight. using fiber grating ’ s character of sensitivity for stress ; people have done some envelope experiments on structural systems ( such as storied buildings, bridge, railway and dam )

    光纖光柵傳感器除了具有重量輕、耐腐蝕、抗電磁干擾、靈敏度高、結構緊湊等優點外，還有其獨特的優越性，如探頭尺寸小，其直徑與光纖等同;易於與光纖耦合，耦合損耗小;波長調制型，抗干擾能力強;集傳感與傳輸於一體且具有極強的復用能力，易於構成傳感網路;測量對象廣泛，易於實現多參數傳感測量等等。
  5. 3. as to vehicle - bridge system coupling vibration, this difficulty in engineering industry, it was abstractly summarized in this thesis, and introduce a method to establish and resolve equations about such coupling vibration, bring forward a flow chart to write correlative software ; with the help of ansys, make out some work about preparatory simulation, so as to research basic point of chicle - bridge system coupling vibration

    3 、對車橋耦合振動這一業內的難點進行了理論上的分析，引入了一種建立和求解車橋耦合振動系統方程的較為典型的方法，提出了一份自行編製程序的流程簡圖；借用ansys軟體對該橋做了車橋耦合振動的初步模擬計算，探索車橋共振的基本特點。
  6. For many purposes, however, the above description is quite adequate in explaining the major features of the prism coupler.

    然而，對許多用途而言，用上述的說明來解釋棱鏡耦合器的主要特點是完全足夠的。
  7. Because the beam formed by a tapered coupler is produced by many rays that emerge at slightly different angles, the outgoing beam is characterized by a relatively large divergence.

    因為尖劈耦合器形成的光束是由許多出射角稍有不同的光線組成的，放出射光束的特點是具有較大的發散度。
  8. Second, the starting and stopping behaviors under disturbed condition are analyzed and calculated by using the dynamic concentrative parameter model, which gives some advice to better prescribe refrigeration system and set theoretic foundation for carrying out automatic control of refrigeration system. third, the normal running process is analyzed and calculated by means of rational matching theory, which gives some advice on how to better understand the parameter change under steady state and the affection of inlet - parameter on evaporator. fourth, the simulation software with dynamic characteristic is designed, which can be applied to calculate thernio - parameter of cryogen, air humidity and frost thickness under different initial and boundary conditions, and to carry out dynamic simulation under conditions of dryness, wetness and frostiness, at the same time, to achieve detection and simulation at any stage from starting to stopping

    本文的主要內容如下： 1 ）對翅片管蒸發器結構特點進行分析，選取適當的微元控制體，就干、濕和霜工況下對每個微元分別進行傳熱傳質分析，基於經驗關系式確定霜的有關參數，對于霜工況下的霜生長建立模型，經適當假設，運用質量守恆、能量守恆和動量守恆方程建立適合動態模擬的蒸發器數學模型，為系統模擬奠定基礎； 2 ）對蒸發在大擾動下的開、停機過程，運用動態集中參數模型進行分析和計算，為更好地描述製冷系統運行的全過程奠定基礎，同時也為製冷系統實現自動控制提供一定的理論基礎； 3 ）對蒸發器正常運行過程，運用動態分佈參數和參數間定量耦合的觀點來分析和計算，為更好地了解穩態工況下各點參數的變化情況及各入口參數對蒸發器動態特性的影響即蒸發器性能對各參數變化的敏感性； 4 ）編寫翅片管蒸發器動態特性模擬計算程序，可以計算不同邊界條件和初始條件下的製冷劑熱力參數、空氣溫濕度和霜厚度分佈場，實現對翅片管蒸發器在干、濕和霜工況下的動態模擬。
  9. The simulation results suggest that, at the end of the scanning line, the dissymmetric temperature field and the great temperature gradient result in the balling phenomenon and great thermal stress, which could lead to the destruction of the sintering samples in this region. because of the coupling effect between scanning lines, the balling phenomenon is increased as the increase of the scanning lines, thus the over short scanning lines should be avoided in the sintering process. different scanning strategies have significant influence on the sintering

    模擬結果表明，掃描端點溫度場的不對稱及較大的溫度梯度造成了端點球化現象，並在端點處產生較大的熱應力，使燒結成形試樣易在此處破壞;激光掃描線間的耦合作用使端點球化現象隨掃描線的增加而逐漸顯著，燒結時應避免過短的掃描線;不同掃描策略對燒結成形有很大影響，交替掃描會影響燒結試樣的質量，實際製造時應採用單向掃描策略。
  10. A particular advantage of the inductive coupling is that it permits the use of em system in aircraft.

    感應耦合的一個特殊優點在於它能使我們在飛機上利用電磁系統。
  11. The exciton - phonon coupling in cdse qds and its wetting layer were investigated by pl dependent of temperature

    利用變溫實驗研究了在量子點與其浸潤層中激子與聲子耦合現象。
  12. The mode and frame can settle the questions of traditional integration such as tight coupling between applications, lack of expansibility and faintish flexibility, and have better commonability and compatibility at the same time. it is relatively low cost to realize, can satisfy integration of the distributing type

    該集成模式和框架能夠有效的解決傳統的集成方法所存在的如應用間的緊耦合，缺乏可擴展性和靈活性等問題，同時具有較好的通用性和兼容性，實現成本較低，能夠更好的滿足分散式集成等特點。
  13. The dual - core air - guided pbgfs couplers are designed and decoupling phenomenon has been found. coupling properties of the pbgfs with adjacent two air cores are evaluated. the decoupling point, where no power transfers between two cores,

    對具有兩個相鄰纖芯的空氣傳導光子帶隙光纖的傳導模式和耦合特性進行了理論分析，在所分析的結構中發現了無耦合點，在該點兩個相鄰纖芯之間不發生能量交換。
  14. Point of common coupling pcc

    公共耦合點
  15. Point of common coupling pc

    公共耦合點
  16. The key process of the algorithm, called nodes transforming to arcs, is based on the calculation loads of coupling nodes and arcs loads from the loads of switch nodes. getting the area of coupling nodes is the most important process in nodes transforming to arcs. this paper presents a new method ， which uses the adjacency matrix of distribution network and the information matrix of

    變結構耗散網路是一種新的配電網自動化演算法，由配電網開關頂點負荷求弧負荷和耦合頂點負荷的點弧變換是整個演算法中確定配電網饋線故障區域的基礎，而進行點弧變換的關鍵就在於分離耦合點區域。
  17. Integrated into the regional economy, social development and regional innovative system, the scientific research should seek the coupling point and construct information communication platform

    融入區域經濟、社會發展和區域創新系統，尋找相互發展的「耦合點」 ，構建信息化交流平臺。
  18. The dual - core air - guided photonic bandgap fiber couplers are designed and decoupling phenomenon has been found. coupling properties of the pbgfs with two adjacent air holes as fiber cores are analyzed. the decoupling point, where there is no

    對具有兩個相鄰纖芯的空氣傳導光子帶隙光纖的傳導模式和耦合特性進行了理論分析，在所分析的結構中發現了無耦合點，在該波長處兩個相鄰纖芯之間不發生能量轉移。
  19. A model is made according to the bearing and screw style, and the static analysis of the model has been done under launch environment. in the static analysis the couple point method is accepted for the solution of the relationship between the contact parts of the mechanism

    然後利用ansys軟體進行了發射荷載條件下機構的強度校驗，在其中提出了利用耦合點來解決有接觸構件的力學分析問題，可以基本滿足問題的要求。
  20. Based on the multidisciplinary design optimization, a multidisciplinary variable coupling design optimization method for non - hierarchic systems was presented, and its basic ideas and working principle were given, to handle the coupling between subsystems, a coupling function was established by the ideal point during system - level coordination, which was used to coordinate independent optimization of the subsystem and finally obtain the global optimal solution

    摘要基於多學科設計優化原理，提出了面向非層級復雜系統的多學科變量耦合優化設計方法，闡述了其優化設計的基本思路和工作原理通過設置理想耦合點，構造了耦合函數，使子系統在各自獨立優化設計的同時，在系統級的協調下達到耦合關系的滿足，並使系統得到總體上的優化。
分享友人
分享到 Line

分享到臉書