聚丙烯腈纖維 的英文怎麼說

中文拼音 [bǐngxiānwéi]
聚丙烯腈纖維 英文
acrylic fiber
  • : 動詞(聚集; 聚積) assemble; gather; get together
  • : Ⅰ名詞1. (天乾的第三位) the third of the ten heavenly stems2. (姓氏) a surname Ⅱ數詞(第三) third
  • : 名詞[化學] (有機化合物的一類) alkene; olefince
  • : 名詞[化學] (含有氰基的有機化合物) nitrile
  • : 纖形容詞(細小) fine; minute
  • : Ⅰ動詞1 (連接) tie up; hold together; link 2 (保持; 保全) maintain; safeguard; preserve; keep ...
  • 纖維 : fibre; staple; filamentary
  1. The study included polyamides, polyolefins, cellulosics, halogenated fibers, polyesters, acrylics and polyurethanes,

    上述研究樣品包括酰胺、烴,素,含鹵素等酯,氨基甲酸
  2. Textiles - tests for colour fastness - part z03 : intercompatibility of basic dyes for acrylic fibres iso 105 - z03 : 1996 ; german version en iso 105 - z03 : 1998

    紡織品.色牢度試驗.第z03部分:聚丙烯腈纖維用基本染
  3. Preparation of chelating fibers modification of polyacrylonitrile fiber

    聚丙烯腈纖維改性
  4. The electrostatic spinning technique of producing nano - pan fiber felt was introduced. the relationship of processing parameters with diameter of fiber and the amount of remaining solvent in as - spun fiber were analyzed and the influence of compound solvent of dmf and acetone on properties of fiber was investigated

    介紹了用靜電紡絲法紡制納米級聚丙烯腈纖維氈的方法,分析了紡絲工藝條件與的直徑及初生的溶劑殘留量的關系並探討了採用二甲基甲酰胺及適量的酮為復合溶劑對性能的影響。
  5. Preparation of weak alkaline ion exchange fiber based on polyacrylonitrile

    基弱堿性離子交換的制備
  6. A new method of producing polyacrylonitrile based

    新型基活碳非織造布的生產方法
  7. Occupational exposure limit for polyacrylonitrile fibre dust in the air of workplace

    車間空氣中聚丙烯腈纖維粉塵職業接觸限值
  8. Study on the cross section morphology and skin - core structure of pan fiber in wet - spinning

    濕法紡聚丙烯腈纖維的截面形貌與皮芯結構的研究
  9. The influence of heat treatment temperature on the properties of 3k pan - based carbon fibers was investigated

    摘要在不同溫度下對3k基炭進行了高溫處理,研究了熱處理溫度對炭結構和性能的影響。
  10. This paper intends to review the new development of polyacryonitrile - based carbon fibers which in the fields of development situation, manufacture process and the application of carbon fiber cloth in concrete construction

    摘要本文主要從基碳的國內外發展現狀,工藝技術概況和碳巾片在建築結構物的補強應用3個方面介紹了基碳的新進展。
  11. Abstract : coagulation and stretch are two crucial working procedures during precursor fabrication, which play important roles in precursor structure and performance. the fiber tensile strength is affected by concetration, temperature and minus stretch during coagulation, while the fiber structure and performance are obviously influenced by stretch temperature, medium and ratio

    文摘:凝固成形和拉伸是原絲生產過程中兩個十分關鍵的工序,它們對原絲的結構和性能有著重要的影響.的拉伸強度在凝固成形過程中受到凝固浴濃度、溫度和負拉伸的影響,同時在的拉伸中拉伸的倍數、溫度和介質等也影響著的結構和性能
  12. This charged fiber can be directed or accelerated by electrical forces and then collected in mats or other useful geometrical forms. the diameters of electrospun fibers are in the range of tens of nanometers to several micrometers. in this paper, polyacrylonitrile ( pan ) nanofibers are made by electrospinning pan / dimethylformamide ( dmf ) and pan / dimethylacetamide ( dmac ) with adjusting the main process parameters including electrostatic voltage ( 20 ~ 50kv ), sprinkler aperture ( 0. 5 ~ 0. 8mm ), collection distance ( 15 ~ 25cm ), solution concentration ( 6 wt % - 14 wt % )

    本文主要對( pan )二甲基甲酰胺( dmf ) 、 pan二甲基已酰胺( dmac )體系進行電紡絲,調節靜電壓( 20 50kv ) 、噴頭孔徑( 0 . 5 0 . 8mm ) 、接收距離( 15 25cm ) 、溶液濃度( 6wt 14wt )等過程參數,制得pan納米平均直徑在200 1000nm ;詳細分析了過程參數對細度、形態等的影響,認為高物溶液濃度及靜電壓對細度有決定性影響,其它過程參數如接收距離、噴射孔徑、紡絲溶液溫度、溶液電導率等的調整應以這兩參數為基礎進行。
  13. The friction properties for dry spinning polyacrylonitrile fiber are studied, and the surface properties and friction factors include gliding, cohesive, the opu, fiber types and environment condition are analyzed

    摘要對干法紡絲短表面摩擦性能進行了研究,分析了表面的形態與摩擦性能的關系,對影響摩擦性能的含油率、環境條件及規格等因素進行了探討。
  14. Near 800 patents about pan precusors, carbon fiber and accessories agents published from 1980 to 2006 were analysed and researched systematically, and classified and summsrized according to their technigues and varieties for reference

    摘要從1980年以來國外約50家單位所發表的近800篇有關( pan )原絲、碳及輔料的專利中,按其技術和性能等級進行全面、系統分析和研究,並加以匯總。
  15. In the paper, blend composed membranes with different ratio of pva and sa have been prepared supported by hollow fiber ultrafiltration membrane of polysufone. the characterization of the blend membranes has been studied in the dehydration of methanol, isopropanol, n - butanol and tert - butanol. the influencing factors of operating temperature, feed concentration, and feed speed rate have been researched

    此外,實驗中還制備醇與海藻酸鈉平板復合膜,分別對甲醇、乙醇進行滲透汽化脫水實驗,發現以為底膜的平板復合膜的分離因子比碸為底膜的中空復合膜的高。
分享友人