聚碸纖維 的英文怎麼說

中文拼音 [fēngxiānwéi]
聚碸纖維 英文
polysulfone fibre
  • : 動詞(聚集; 聚積) assemble; gather; get together
  • : 名詞[化學] (硫酰基與烴基結合而成的有機化合物) sulphone
  • : 纖形容詞(細小) fine; minute
  • : Ⅰ動詞1 (連接) tie up; hold together; link 2 (保持; 保全) maintain; safeguard; preserve; keep ...
  • 纖維 : fibre; staple; filamentary
  1. Dependence of the properties of pes hollow fiber on the pressure of internal quench medium

    填充液壓力對中空膜微結構和性能的影響
  2. The dual - bath coagulation method suggested by j. a. va n ' t hof could be used in membranes with high selectivity clearance rate of low - molecular weight substances and moderate water flux theoretically. therefore it may be applied in the field of hemofiltration. to improve and optimize the performance of the pes ultrafiltration membrane applied in the hf, here the flat membranes and hollow fiber ( hf ) membranes are made in certain conditions based on the dual - bath coagulation method where pes is used as the membrane material, dmso as solvent and pvp & peg as additives this paper includes five parts as follow : 1

    為了改善和優化超濾膜(單浴法)在血液過濾實際應用中的性能,本論文以j . a . van ' thof等提出的雙凝固浴法為基礎,以( pes )為主要成膜材料,以二甲基亞為溶劑,並添加一定分子量的致孔劑( pvp ,乙烯吡咯烷酮)以及一定分子量的添加劑( peg ,乙二醇)按照一定配比在一定溫度下製成透明均一的鑄膜液,靜置脫泡后在一定的工藝條件下製成平板膜和中空膜,然後通過測試膜的結構和性能來評估其用於血液過濾中的前景。
  3. An excellent adhesive was prepared from bismaleimide ( bmi ), epoxy resin ( e - 51 and tde - 85 ), 4, 4 ' - diaminodiphenyl sulfone ( dds ) in this thesis. the influence of liquid rubber and polymer ether imide ( pei ) on the properties ( especially high - temperature strength and the peeling strength ) were discussed, their different toughening characteristics and mechanisms were discussed. last, the process and effection of heat - resisted structural adhesive were studied by adhesive experiment of synchronizer in automobile. the results of investigation made clear : the adhesive, has good properties, especially heat - resisted properity

    根據材料分子設計的原理,研究了二苯甲烷雙馬來酰亞胺( bmi ) 4 , 4 』 ?二胺基二苯基( dds ) e ? 51 tde ? 85組成的環氧膠粘劑體系,研究該體系在作為高溫結構膠粘劑使用時的粘接性能;然後研究了用無規羧基液體丁腈橡膠( ctbn ? x )和醚酰亞胺( pei )分別來增韌該體系的增韌效果;最後通過碳耐磨材料與同步器圓錐環的粘接實驗,研究了耐高溫結構膠粘劑的粘接工藝和使用效果。
  4. Effects of coagulation bath temperature on the structure and performance of polyethersulfone hollow - fiber membranes by dry wet process

    凝固浴溫度對相轉化中空膜結構與性能的影響
  5. Studies on the properties of ppesk cf composite

    酮樹脂基碳復合材料的性能研究
  6. Properties of continuous fiber reinforced ppesk composites

    連續增強芳醚酮復合材料的性能
  7. Sailuluo, carboxyl methyl cellulose that, nylon series products lu : yisuan, surface active agent, bringing alternative amides size, polyimide, plastics processing. mode of operation : manufacturing

    賽璐珞,羧甲基素納,尼龍系列產品,氯乙酸,表面活性劑,酰胺漿液,酰亞胺,塑料加工。經營方式:製造。
  8. In this paper, the structure and properties of polyurethane ( pu ) - sio2, polyethersulfone ( pes ) - sio2 composite membrane. including composite flat membrane and composite hollow fiber membrane, and responsivity of composite pu hollow fiber membrane pore size to pressure were studied

    本文對sio _ 2填充氨酯( pu ) 、( pes )復合膜,包括平板膜和中空膜的結構和性能及pu復合中空膜的壓力響應性進行了研究。
  9. In the paper, blend composed membranes with different ratio of pva and sa have been prepared supported by hollow fiber ultrafiltration membrane of polysufone. the characterization of the blend membranes has been studied in the dehydration of methanol, isopropanol, n - butanol and tert - butanol. the influencing factors of operating temperature, feed concentration, and feed speed rate have been researched

    此外,實驗中還制備乙烯醇與海藻酸鈉丙烯腈平板復合膜,分別對甲醇、乙醇進行滲透汽化脫水實驗,發現以丙烯腈為底膜的平板復合膜的分離因子比為底膜的中空復合膜的高。
分享友人