聯結裝置 的英文怎麼說

中文拼音 [liánjiēzhuāngzhì]
聯結裝置 英文
coupling device
  • 聯 : Ⅰ動詞（聯結; 聯合） unite; join Ⅱ名詞（對聯） antithetical couplet
  • 結 : 結動詞（長出果實或種子） bear （fruit）; form （seed）
  • 裝 : Ⅰ名詞1 （服裝） dress; outfit; attire; clothing 2 （演員的化裝品） stage makeup and costume Ⅱ動詞...
  • 置 : 動詞1. （擱; 放） place; put; lay 2. （設立; 布置） set up; establish; arrange; fix up 3. （購置） buy; purchase
  • 聯結 : bind; tie; join; jointing; anastomosis
  • 裝置 : 1 （機器設備的配件）installation; device; apparatus; equipment; arrangement; gear; appliance; rig...
  1. Driveequipment use active magnet connected - implement to firsthand fix at the axletree of electrical engine, pumproom close completely, via magnetic force coincidence to drive impeller on rotor - assembled to circumgyrate indirectly, it own the trait like tightly structure handsome exterior small bulk laigh noise unfailingly move expediently service using safety and economize etc

    ，驅動裝置採用主動磁鐵聯軸器直接裝在電機軸上，泵室完全封閉，通過磁力偶合間接驅動泵軸上帶磁鐵的葉輪旋轉，具有結構緊湊
  2. Eletrical installations of buildings - part 5 : selection and evection of electrical equipment - section 548 : earthing arrangements and equipotential bonding for information technology installations

    建築物電氣裝置第5部分:電氣設備的選擇和安裝第548節:信息技術裝置的接地配置和等電位聯結
  3. Based on the principle of afm ’ s mechanism, with the needs of 6 - dof parallel robot with cubic millimeter movement space and nano - scale movement accuracy, and considering the openness, scope bound and reliability of the adjustment device, this paper build a super - exact device for the measurement of nona - scale surface

    本論文在借鑒原子力顯微鏡原理的基礎上，結合具有立方厘米級工作空間、納米級運動解析度的6 - dof並聯工作臺的實際測量需要，綜合考慮了系統的開放性、掃描范圍和調節裝置的可靠性，研製了面向納米測量定位的高精度表面納米級形貌測量樣機。
  4. In the first part of this paper, mn ( iii ) / mn ( ii ) couple in h2so4 was firstly applied as the positive couple to this system, i. e. redox flow cell. its chemical, electrochemical properties, redox kinetics and related parameters were characterized and discussed by rotating disc electrode ( rde ), cyclic voltammetry ( cv ), a. c. impedance ( a. c. imp ), chronoamperometry, tafel curve, and galvanostatic charge / discharge techniques. conclusions have been drawn as follows : 1. the electrochemical kinetics of mn ( iii ) / mn ( ii ) redox couple in 6. 3m h2so4 solution were studied by means of rotating disc electrode ( rde ) technique on platinum electrode

    本文第一部分首次成功地將酸性介質中的mn （ iii ） / mn （ ii ）電對應用於氧化還原液流電池這一新型儲能裝置的正極活性材料，通過旋轉圓盤（ rde ） 、循環伏安（ cv ） 、交流阻抗（ a . c . imp ） 、恆電位階躍、 tafel實驗以及mn （ iii ） / mn （ ii ）單電極的恆流充放電實驗，我們得出以下結論： 1 .在旋轉圓盤電極上，不同轉速范圍，不同的極化過電位， mn （ ） / mn （ ）體系氧化還原電極過程的控制步驟不同，電荷傳遞、擴散傳質可分別或聯合成為控制步驟。
  5. Approach to improve in the linking device between the 40t scraper conveyor head and the decelerator

    刮板機機頭與減速器聯結裝置的探討
  6. Electrical installations of buildings - part 5 - 54 : selection and erection of electrical equipment - earthing arrangements, protective conductors and protective bonding conductors

    建築物電氣裝置第5 - 54部分：電氣設備的選擇和安裝-接地配置保護導體和保護聯結導體
  7. In the paper we mainly researched space gainp2 / gaas / ge high efficiency tandem cells " making process by home - made low pressure mocvd technology and new solar concentrators. firstly, we presented reseached and development of solar cells in china and foreign countries ; secondly, on the basis of fundamental priciples and theories, we discussed some factors of influcing conversion efficiency of solar cells, and analysed the i - v output feature of two - junction tandem cells ; then the design concept of gainp2 / gaas / ge two - junction tandem cells was discussed, the detailed aspects of gainp2 / gaas / ge tandem cells epitaxy growth by low pressure mocvd was studied, and some questions on epitaxy growth ( such as crystal qualities, interface stress, element interdiffusion, n - and p - type doping et all ) were solved ; after that, the cell fabrication process was described ; finally, we reseached the hot pressing and mould process technology of an arched line - focus fresnel lens made by pmma, designed and fixed new solar concentrators

    本文致力於用自製的低壓mocvd裝置進行cainp _ 2 / gaas / ge空間用高效級聯太陽能電池製作的工藝以及聚光太陽能電池組件的研究。首先，介紹了國內外太陽能電池的研究現狀及應用情況；其次，運用太陽能電池基本原理討論影響電池轉換效率的因素，分析了級聯電池的伏安特性；隨后，討論了cainp _ 2 / gaas / ge雙結級聯電池的結構設計理念，研究了採用低壓mocvd技術生長cainp _ 2 / gaas / ge級聯太陽電池材料的工藝過程，解決了異質材料生長的結晶質量、界面應力、材料互擴散以及材料n 、 p型摻雜等一系列問題；然後總結了級聯電池的后工藝製作；最後，研究了以pmma為材料的菲涅耳線聚焦透鏡的熱壓成型工藝及其模具的加工工藝，設計並安裝完成新型聚光太陽能電池組件。
  8. Universal interconnecting device

    通用聯結裝置
  9. The characteristics : the unit is composed of high voltage parallel capacitor, serial reactor, switch ( disconnector, grounding switch, breaker etc. ), lightning arrestor, fuse, discharging coil, current transformer, insulator, busbar and steel bracket, includes two kinds of structure : frame type and cabinet type

    產品特點：裝置由高壓並聯電容器、串聯電抗器、開關（隔離開關、接地開關、斷路器等） 、避雷器、熔斷器、放電線圈、電流互感器、絕緣子、母排和鋼架組成，裝置有框架和櫃式兩種結構。
  10. In a word, this thesis not only expounds the whole structure of stability control of power system based on the theory of control decisions, but also designs software and hardware of sub - control - station, which are different from others. there are several advantages as listed below : 1 ) distributed hardware architecture function modularization realization of communication between modules by high - speed network communication technology ( can ) ( interconnecting 256 modules or mainframes ) flexible, convenient, reliable expansibility of hardware and decreasing system risk. any broken cell only affects local cell

    總之，論文不僅在控制策略理論的基礎上，闡釋了穩定控制系統的整體架構，而且研製設計出新穎的區域穩控子站裝置軟硬體，其優點體現在： 1 ）分散式硬體結構體系功能模塊化採用高速網路通信技術（ can ）實現模塊間信息交換（最多支持256個模塊及機箱之間的互聯）硬體擴展靈活方便、可靠，降低系統風險，任一單元損壞隻影響局部2 ）實時信息網（控制網）和管理網（監測網）分開。
  11. Coupling devices for trucks and trailers ; trailer coupling ring 40 without socket, dimensions

    汽車和掛車的掛結裝置.不帶套筒的掛車聯結環40 .尺寸
  12. At present, in studying and developing heavy capacities and parallel resonant inverter, it is expected to solve the problems of researching on simple structure and easy to start frequently series resonant inverter in the fields of domestic high frequency induction heating installation. therefore, researching of the subject is to design and study a high frequency ( more than 1 mhz ) and high power topological structures of full solid - state induction heating power supply

    目前在研究和開發大容量的並聯逆變中頻電源的同時，研製結構簡單，易於頻繁起動的串聯逆變高頻電源是國內高頻感應裝置領域有待解決的問題，基於此種需要，本課題主要研究設計一種高頻（ 1mhz以上）大功率全固態感應加熱電源逆變電路的拓撲結構。
  13. Power control systems were built one by one, so there was not a general plan for interconnection of them. this made the network jumbled, too many connections, and no clear border between systems. even if we install security devices, they are easily bypassed

    由於現有電力監控系統是分批建設的，系統間互聯缺乏統一規劃，導致了網路結構混亂，互聯點多，邊界不清晰等問題，在部署安全裝置時容易因考慮不周而存在旁路。
  14. The experiment took water as the medium and experiments on two jet modes were carried out under the falling film vacuum evaporating. the experimental results indicated that the two ejectors in series compensation method could adjust the variational work situation due to the decrease of primary steam or secondary steam and insure the normal production. at the same time, the ejector ' s best work situation founded in the experiment would provide reference for ejector ' s design and usage

    本實驗建立了一套降膜真空蒸發裝置，以水為介質，對變工況下單級和串聯噴射熱泵蒸發進行了實驗，結果表明兩級串聯補償噴射裝置能對由引射蒸汽和工組蒸汽壓力降低所造成的混合蒸汽壓力降低進行調節，達到了變工況下正常生產的目的。
  15. The spatial member - story model is adopted as the dynamic analysis model for base - isolated structures by considering the isolation device as a special element, the dynamical equation is established, time - history analysis is conducted by step - by - step integration and iteration methods, and program of dynamic analysis on base - isolated structures ( dabis ) which can be used for analysis on multi - dimensional and lateral - torsional coupled seismic response of base - isolated structures is worked out

    將隔震裝置作為特殊單元，採用空間桿系?層模型作為基礎隔震結構動力分析模型，建立其運動方程，採用逐步積分法和迭代法進行時程反應分析，編制了可進行基礎隔震結構多維及平?扭耦聯地震反應分析的基礎隔震結構動力分析程序dabis 。
  16. The parallel robot has become a hot spot for a long time because of its simple structure, high stiffness, high precision, and low movement inertia. it especially adapted to the task, which required high precision, heavy load and limited space

    並聯機器人具有結構簡單、剛度好、定位精度高、動態響應快等優良特性，特別適用於高精度、大載荷且工作空間較小的場合，在裝配生產線、高精密機床、飛行模擬器、衛星天線換向裝置等等很多方面都有著巨大的應用價值。
  17. Materials for printed boards and other interconnecting structures - part 2 - 13 : sectional specification set for reinforced base materials, clad and unclad - cyanate ester non - woven aramid laminate of defined flammability, copper - clad

    印製板材料和其它互聯結構.第2 - 13部分:包被或非包被增強基底材料分規范裝置，限定可燃性的銅包被的非編織的芳香聚酰胺層狀氰酯
  18. Mechanical transmissions. coupling devices. classification. terminology. graphical symbols

    機械傳動.聯結裝置.分類.術語.圖形符號
  19. Mechanical transmissions. coupling devices. technical elements necessary for the selection of a coupler

    械械傳動.聯結裝置.選配聯結器所必須的技術要素
  20. The distinguishing features and operation are summed up of a 12 mw heat and power co - production unit

    摘要總結了12mw熱電聯產裝置的特點及運行情況。
分享友人
分享到 Line

分享到臉書