肋接 的英文怎麼說

中文拼音 [lèijiē]
肋接 英文
kneejoint
  • 肋 : 肋構詞成分。
  • 接 : Ⅰ動詞1 （靠近;接觸） come into contact with; come close to 2 （連接; 使連接） connect; join; put ...
  1. The feathers attached to the arms and the tail evidently possess the structures of " modern feathers ", which consisting of the central shafts ( rachis ) and parallel barbs. dromaeosaurids are unusual group of maniraptoran theropods. they share many similar or the same features with archaeopteryx or other primitive birds, such as : u - shaped furcula, uncinate process, laterally facing glenoid of shoulder girdle, comparatively long forelimb, large semilunate carple, retroverted pubis, ascending process of astragalus, and " modern feathers " with rachis and barbs etc. these facts indicate not only that dromaeosaurids had developed many bird - like characters in course of the advanced maniraptorans toward birds, but also that there seemed to be the co - evolutionary trend between the feathers and the skeletal bones

    奔龍類是一類較為特殊的手盜龍類（ maniraptora ） ，它具有許多與始祖鳥archaeopteryx甚至其它早期鳥類相似或接近的特徵，主要表現在：叉骨u形與始祖鳥和孔子鳥類的相同，背肋鉤狀突在孔子鳥類和個別反鳥類中也存在，肩臼窩絕大部分指向側方類似於始祖鳥，肩胛骨與烏喙骨間的夾角非常接近90也和始祖鳥的相似，前肢從比例上講顯得較長，大的半月形腕骨使肘部能向側方折過來，恥骨伸向後下方，距骨上升突與原始鳥類中的為同源結構，羽毛已有顯著的分化且具備了現代羽毛的基本結構等等。
  2. Some crack extension probably developed from the unfused section of the butt weld across the thickness of the stiffener during transport and erection.

    有些裂紋可能在運輸和安裝過程中就從加勁肋對接焊未熔透處開始發展。
  3. The main components of the latter are multi - rib sandwich panels, including floor slabs and wall slabs. reinforced concrete conformation columns are set where the longitudinal walls and latitudinal walls intersect and copulative beams are set where floor slabs and wall slabs intersect. they play a role of linking and transferring loads, bearing a small part of loads at the same time

    無骨架體系的主要承重構件是密肋夾芯板（包括樓板和墻板） ，縱、橫墻相交處設鋼筋混凝土構造（連接）柱，墻板和樓板相交處設連系（圈）梁，連系梁和柱主要起連接和傳遞荷載作用，也承擔少部分荷載。
  4. In addition to, the fatigue crack between web and upper flange of welded steel crane beam on heavy duty service was discussed, and based on long - term observation and research, the author classified fatigue crack into bearing type and middle type crack along the horizontal direction. the causation, distributive law and mechanism of the crack were analyzed, and the precautions to take and the measures to remedy crack were presented. the main defacts including damage, crack, erosion and aging in structures, especially in concrete structure were introduced ; the defact mechanism was analyzed and the precautions to take were also given

    另外，作者對重級工作制焊接鋼吊車梁腹板與上翼緣連接焊縫的縱向水平疲勞裂縫進行了長期的觀察和研究，根據疲勞裂縫產生的不同機理，將其分為支點裂縫和肋間裂縫，並討論了兩類裂縫產生的原因、分佈規律、機理以及防治的措施；對工程中經常遇到的結構構件，尤其混凝土構件的幾種主要病害（損傷、裂縫、腐蝕與老化）進行了機理分析並提出了防治措施。
  5. Based on the numerical simulation and accuracy analysis to previous slab ' s test with the ansys program, the study of composite wall, with various detail design under potential load action respectively or jointly is carried on and the wall ' s atress behavior and failure mode is obtained, also the influence to wall ' s stiffness and bearing capacity by kinds of factors, including wall ' s shear span ratio, member ' s section, bar arrangement, etc. based on the hammer blow test and stiffness test, a 1 / 3 scale ten - bay model ' s modality parameter and elastic deformation characteristic is analyzed

    在對密肋復合墻板運用ansys ~ （ （ ? ） ）程序進行數值模擬、分析驗證的基礎上，對典型組合墻體在不同連接構造和不同荷載效應組合作用下的受力形態和破壞模式進行研究；計算分析了復合墻體剪跨比、邊框柱截面尺寸、邊框柱配筋大小以及墻板內肋梁肋柱配筋等諸多因素對密肋復合墻體承載力及剛度的影響，得出其變化規律。
  6. Steel decks, in other words, orthodox isomerism structures, are welded with various transverse and longitudinal reinforcing ribs. this results in the complexity of forces and deformatiort of the pavement layer above the deck

    鋼橋面板焊接在各種橫向、縱向加勁肋上，橋面板為正交異性板結構，決定了其上的鋪裝層受力變形的復雜性。
  7. New technique for steel wire joint - rolling press straight thread conjunction

    鋼筋等強度剝肋滾壓直螺紋連接技術的應用
  8. Reinforcing bar jointing with equal strength peel rib to roll press straight thread sleeve and site quality control

    淺談剝肋滾壓直螺紋連接技術等強度問題
  9. Now take your rib spreader, crack open he sternum allowing access to the heart

    現在（用骨釬）打開肋骨，胸骨，這樣就可以接觸到心臟。
  10. Then fourier transformation is employed to solve equations of motion of the rings, bulkheads, stringers and fluid respectively, with their reactions ( moments ) expanded by the shell ' s in - vacuo modes. by means of continuity conditions on the interfaces between the shell and the stiffeners as well as the fluid, and inverse fourier transformation, the modal reactions ( moments ) are finally expressed by the shell ' s modal velocities

    然後用fourier變換分別求解環肋、艙壁、縱骨和流場的運動方程，將它們對殼體的作用力（力矩）用殼體周向模態展開，利用它們與殼體在連接處位移連續條件以及fourier逆變換得到用殼體速度表示的模態相互作用力（力矩） 。
  11. Quality control of steel bar rolling amp; amp; linear whorl connection

    鋼筋剝肋滾壓直螺紋連接的質量控制
  12. Thecalculating results show that the composite action between concrete floor and steel beamsgreatly influence the bending bearing capacity and initial rotational stiffness of joints, it shouldbe considered in practical engineer. reinforcement ratio of lengthways reinforcing bar andthe stiffener of web have great influencer on the behavior of connections, while the thicknessof end - plate and degree of shear connection have a litter influence on its behavior

    分析計算結果表明:樓板與鋼梁的組合作用對節點的抗彎承載力及初始轉動剛度的影響非常大，實際工程中節點設計應當考慮這種組合作用;樓板內縱向鋼筋配筋率與柱腹板加勁肋對節點性能影響顯著，而連接端板厚度及剪力連接程度的影響則不是太顯著。
  13. The application of cold squeeze faucet joint technology for ribbed reinforcement in hangzhou bay cross - sea bridge

    帶肋鋼筋套筒冷擠壓連接技術在杭州灣跨海大橋中的應用
  14. The company ' s main products include : ordinary - type, forward - and - backforward - thread typeandcalibre - changed type, three series and 50 - odd varieties of steel straight thread connecting sleeve piece and steel straight thread screw rolling machine, screw rolling wheel, cutting tool, reinforced thread head special gauge, moment spanner ect., auxiliary tools which are used in construction

    公司主要產品有標準型、正反絲型、變徑型三大系列五十多個品種的建築用鋼筋直螺紋連接套筒和鋼筋直螺紋（剝肋）滾絲機及滾絲輪、切削刀具、鋼筋絲頭專用量規、力矩扳手等輔具。
  15. What welding methods do you use in connecting the plates, frames, and beams

    在焊接鋼板，肋骨，甲板橫梁時，你們用什麼焊接方法？
  16. Test on extended end - plate with end - plate stiffer beam - to - column connection

    帶端板加勁肋的外伸端板連接的樑柱節點試驗
  17. The wall was equaled to an elastic composite slab with silica bricks as main body and concrete rib beams, columns and outer frame as reinforcing fiber. ( 2 ) elastic - plastic stage. the wall was equaled to a rigid frame - oblique compression bar model in which concrete frame was equivalent to a rigid frame while silica brick was equivalent to a oblique compression bar

    （ 1 ）彈性階段? ?將墻體視為一種以輕質砌塊為基體，混凝土肋梁、肋柱、外框為增強纖維的復合材料等效彈性板； （ 2 ）彈塑性階段? ?將墻體視為一個由鋼筋混凝土剛架和與之鉸接的砌塊等效斜壓桿組成的剛架斜壓桿組合模型； （ 3 ）破壞階段? ?將墻體視為肋梁嚴重破損的梁鉸框架模型。
  18. Vats with direct suture of the flaw and pleurodesis were performed successfully

    我們成功地實施了胸腔鏡裂縫直接修補及肋膜沾黏手術。
  19. Dialysate leakage induced 5 patients to leave the pd program ( 4 cases of pleural effusions and 1 case of hydrocele )

    最後，有5例病人轉而接受備注透析（ 4例肋膜積水， 1例鼠蹊部滲漏） 。
  20. 31 cancer patients with symptomatic pericardial effusion were treated by subxiphoid pericardiotomy with simultaneous pleuropericardial window creation

    摘要31個癌癥病人因大量心胞膜積水接受劍突下心包膜切開術及肋膜心包膜開窗術。
分享友人
分享到 Line

分享到臉書