能量耗散器 的英文怎麼說

中文拼音 [néngliánghàosǎnqì]
能量耗散器 英文
energy dissipator
  • 能 : 能名詞（姓氏） a surname
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 耗 : Ⅰ動1 （減損; 消耗） consume; cost 2 [方言] （拖延） waste time; dawdle Ⅱ名詞1 （壞的音信或消息） ...
  • 散 : 散動詞1. （由聚集而分離） break up; disperse 2. （散布） distribute; disseminate; give out 3. （排除） dispel; let out
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 能量 : 1 [物理學] energy; amount of energy 2 （能力） capabilities; capacity; 能量不滅 conservation of e...
  1. Some form of resonator may be used to dissipate energy in an oscillating feed system.

    某些形式的諧振器可用來耗散供應系統內的振蕩能量。
  2. Energy consumption of heating rooms will increase when air exchange rate become large. because the mechanisms of heating methods used currently, such as radiator heating, ceiling heating and warm - air heating, are different from each - other, the indoor thermal environment is not the same when each one of them employed for room heating. for enhancing energy efficiency of heating rooms, indoor thermal comfort and energy saving effects should be investigated when natural ventilation is used to make a good air quality indoors

    房間換氣次數的增加勢必導致供暖房間能耗加大，頂棚輻射、散熱器和熱風等三種採暖方式由於供暖機理不同，形成的室內熱環境特徵不同，通風換氣時產生的通風熱損失也有所區別，為了提高大換氣量房間的供暖節能效果，必須對不同供暖方式在大換氣量情況下的熱舒適性與節能效應進行研究。
  3. But an alternative simpler method is through the proton exchange ( pe ) process at lower temperature. pe waveguides exhibit larger increment of the index and lower waveguide loss than ti indiffusion waveguides. however, pe waveguide devices have n ' t been fully mature

    質子交換與傳統的鈦擴散工藝相比製作十分簡單，制備的波導具有較高的折射率增量、較小的波導損耗、較強的抗光折變能力，不但能大大降低成本而且還可以提高性能，但是質子交換波導器件目前尚未成熟。
  4. It possesses not only the self - learning ability and adaptability, but also the function of self - adjusting factors. based on fuzzy set, neural network theory, the fuzzy control model and fuzzy neural network control model of multi variable system are presented. based on the automatic core - welding line of shop floor control system in yangzhou radiator plant computer integrated manufacturing system ( ys - cims / sfcs ), the fuzzy logic theory was applied to the controlling device and established the main heating room fuzzy temperature controller and finally was put into practical use

    本文採用了基於神經網路技術的智能pid控制策略，設計了一類具有自學習和自調整比例因子功能的神經元網路自適應pid控制器的結構及演算法；為解決結構不確定性的復雜多變量系統的控制，基於模糊集及模糊系統、神經網路理論，建立了多變量系統的模糊控制模型及模糊神經網路控制模型；針對揚州水箱廠計算機集成製造系統車間管理與控制系統（ ys - cims sfcs ）中的實際工程問題，設計和開發了散熱器芯子烘焊自動線主烘腔溫度模糊控制器，解決了生產中長期存在的老大難問題，提高了產品質量，降低了單產能耗。
  5. The idea of passive control is to utilize additional facility within a structure to dissipate or absorb a large portion of the seismic energy, which has been applied to practical engineering extensively since its control devices - dampers are convenient and it does not need large energy supply and the structural system identification. now the main devices which have been developed in the passive control may be grouped into the following types : viscous, visco - elastic, metallic and frictional, and tuned mass damper ( tmd ) and tuned liquid damper ( tld )

    被動控制通過附加阻尼裝置耗散或吸收大部分的地震動能量以達到減振的目的，由於其控制裝置簡單，不需要外界能源輸入和系統識別，容易在工程上實現並已得到廣泛的應用；目前被應用於結構被動控制的阻尼器主要有：粘滯型、粘彈型、摩擦型、調諧質量阻尼器（ tmd ）和調諧液體阻尼器（ tld ） 。
  6. And, on multiprocessor systems, threads are actually able to run simultaneously, just like two or more processes can

    Powerpc處理器有非常強的嵌入式表現，因為它具有優異的性能、較低的能量損耗以及較低的散熱量。
  7. An on - line minimum - variance estimator was developed for thrust acceleration applied to orbit transfer using discrete - time radar measurements. the mass - flow - rate of propellant was selected as a state variant, which was estimated by employing an integral state model and ekf filter. the variation equations for measurement vector to mass - flow - rate have been established to linearize the discrete - time measurement equations. the algorithm has applied successfully to maneuver process in commanding satellite into geo - stationary orbit. the results show that the algorithm developed here can monitor and determine whether engine works well or failure precisely and quickly during orbit transfer process

    飛行器軌道機動過程中，為跟蹤、定位機動目標和干預機動控制過程，需要統計處理離散的雷達觀測量實時估計推進發動機的推力，進而確定飛行器的瞬時軌道參數.本文所述演算法是該工程問題的探討和解決方案.文章建立了軌道機動過程中連續變質量運動模型和離散雷達量測模型，推進發動機的質量秒耗量作為表徵推力加速度的一個近似常量，應用擴展卡爾曼濾波對離散的雷達測量數據進行順序統計處理給出秒耗量的最小方差估計;文章詳細地推導了線性化量測模型的變分方程和觀測矩陣;模擬結果表明該演算法能快速、準確地估計推進發動機的質量秒耗量和向機動目標施加的實際推力
  8. 2. the mechanism of the msd is discussed. it is pointed out that they can add both stiffness and damping to the main structure

    分析本文軟鋼阻尼器的耗能機理，指出這種阻尼器可以給結構附加初始剛度，同時為結構提供附加阻尼耗散輸入的能量。
  9. The edd can decrease the seismic response of buildings by increasing the damping and dissipating the vibration energy of structure

    耗能阻尼器是通過增加結構阻尼，耗散結構的振動能量來達到減小結構反應目的的。
  10. The experimental results indicate that when the air flow rate is determined, the key problem for energy saving is how to keep the indoor thermal comfort at a suitable level and reduce the difference between the internal and external temperature of the room. a formula is gained for calculating the critical values of air exchange rate. when ventilating rate is greater than the value, radiating heating is the better way for energy saving, or else, convection method in heating is more suitable

    實測還指出，當通風量一定時，如何保證人體熱舒適度不變而減少室內外氣溫差將成為大通風量房間節約採暖能耗的關鍵，本文結合圍護結構傳熱機理，在對三種方式的能耗狀況進行理論分析的基礎上，提出了換氣次數的節能臨界值，若換氣次數高於此值，則輻射供暖是較好的選擇，否則，散熱器供暖是較好的方法。
  11. However, in the aseismic design of engineering structures, a new method named seismic isolation has been found to solve this problem, with which the isolators and dampers are used to isolate, absorb and disperse energy so that seismic response of structures is reduced

    為了提高結構的抗震性能，還可以探索新的途徑，那就是採用隔震技術，即利用隔震器和阻尼器來隔離、吸收和耗散地震能量，減小結構的地震反應。
  12. Compared the heating load ( and energy consumption ) of a same room with floor heating or radiator heating under same operative temperature. revealed the energy consumption of floor heating room could reduce 5 % ~ 10 % to radiator heating, and the heating load could reduce 10 % ~ 15 %. the main season of energy efficiency is due to no apparent high temperature zone in floor heating room, which avoid additional heat loss in outside envelopes, rather than the lower of indoor air temperature

    利用對連續供暖房間溫度場的研究結果，對分別採用上述兩種供暖方式的典型房間的熱負荷和能耗進行了全面分析后發現：低溫地板輻射供暖房間熱負荷比散熱器供暖房間可降低10 15 ，能耗可降低5 10 ；低溫地板輻射供暖房間節能的主要原因並不是由於房間空氣溫度可以降低，而是消除了室內空氣局部高溫區，避免了由此產生的在外圍護上的附加傳熱量。
  13. At last we introduce the realization of all the parts, the problem in the circuit design and the measured data. the results show that the designed system has met the requirement. in this dissertation, direct digital synthesis technology has been used in the phase - locked frequency synthesizer, which can make full use of the characteristics of direct digital synthesis technology such as flexible output wave shape and continuous

    本課題將直接數字式合成技術用於鎖相頻率合成器中，該方法將直接數字合成的特點，如輸出波形靈活且相位連續、頻率穩定度高、輸出頻率解析度高、頻率轉換速度快、輸出相位噪聲低、集成度高、功耗低、體積小等與鎖相環路的頻帶寬、工作頻率高、頻譜質量好等優點有機的結合起來，從而在寬帶的條件下實現了比較好的雜散性能和相噪。
  14. Besides, in this paper, the velocity distributes and recirculation areas of two phases are shown, and the differences between simulations and experiments are diminutive. turbulence kinetic energy ( ?, turbulence dissipation rate ( e ), reynolds stress and turbulence intensity are also simulated to reflect turbulence flow

    另外，本文計算了旋流燃燒器內氣固兩相的速度和迴流區的分佈，並和已有的實驗數據進行了比較，同時還計算了湍動能、湍能耗散、雷諾應力和湍流強度等反映湍流的物理量。
  15. The vibration - reduction principle of viscous damper is to consume most portion of the input energy by viscous damping material during the earthquake and wind so as to diminish vibration response of structures and insure structures " safety, and this technique has been becoming one of the main tendency of earthquake - resistant engineering research

    粘滯阻尼器的控振原理是通過粘滯阻尼來耗散輸入結構的大部分振動能量，以減少結構的振動反應，保證結構在地震和風荷載作用下的安全；消能減震技術現已成為工程抗震研究的主要發展方向之一。
分享友人
分享到 Line

分享到臉書