能量釋放的 的英文怎麼說

中文拼音 [néngliángshìfàngde]
能量釋放的 英文
exergonic
  • : 能名詞(姓氏) a surname
  • : 量動1. (度量) measure 2. (估量) estimate; size up
  • : Ⅰ動詞1 (解釋) explain; elucidate 2 (消除) clear up; dispel 3 (放開; 放下) let go; be reliev...
  • : releaseset freelet go
  • : 4次方是 The fourth power of 2 is direction
  • 能量 : 1 [物理學] energy; amount of energy 2 (能力) capabilities; capacity; 能量不滅 conservation of e...
  • 釋放 : 1 (恢復被拘押者的人身自由) release; deliver; clearing; set free 2 [物理學] relief; rid; detachm...
  1. Mechanism of energy release during coal gas outbursts

    瓦斯突出過程中機理
  2. It is this release of energy that maintains the arc often seen when a switch is opened in an inductive circuit.

    在電感電路中,打開電鍵時,就有這種,引起經常所見電弧。
  3. The methods - three dimension fabric - enforced laminates, and sparse fabric - enforced laminates, layer - enforced laminates ? to enhance the interlaminar toughness of fabric - reinforced laminates were discussed in this paper. the stitching method to enhance interlaminar toughness of stitched - laminates was mainly discussed in this paper based on our research and experiment. the middle - alkali glass fabric used as enforced - material with thickness of 0. 2mm, 3 section 600 deniner kevlar yarn is used as stitching thread in this research, which improved lock stitching way and different kinds of stitching mode were adopted

    以提高層合板復合材料層間斷裂韌性(率)為目標,採用中堿玻璃布為增強材料,對疊層后玻璃布,採用凱芙拉縫合線、改進鎖型縫合方法、不同縫合工藝進行了縫合;基體採用是不飽和樹脂,固化劑為過氧化甲乙酮,促進劑為環烷酸鈷液;在室溫下採用真空輔助rtm ( resigntransfermolding )成型固化方法,製作了不同縫合工藝玻璃布增強復合材料層合板。
  4. Premeditation will have its energy requirement removed, changed to an instant cast, and range increased. its cooldown will remain the same. premeditation will now be pre - reqd by preperation

    預謀變成順發,且不需要距離增加。冷卻時間不變,需要有「預備」天賦!
  5. Energy release rate and bifurcation angles of dynamic electroelastic for piezoelectric materials with

    壓電材料反平面運動裂紋率與分叉角
  6. 2. because the fracture mode of 3d braided cmc is the interfacial fracture of mode i and mode ii, energy release rate gc and complex stress intensity factor kc was designated as characterization parameters of fracture toughness in the linear fracture theories. 3

    根據三維編織c sic復合材料斷裂韌性表徵問題屬于線彈性理論范疇以及材料斷裂模式是界面損傷破壞模式實驗研究結果,提出了該材料表徵參應該使用與界面相關型和型混合斷裂率g _ c ,或者使用復應力強度因子k _ c 。
  7. The pilot fuel model has been given to calculate the distribution of the liquid fuel and time of fuel pre - combustion, at the same time, analyzing the important action to the combustion of the natural gas in the combustion chamber of engine, determining the best quantity of pilot fuel. the explosive combustion model has been established to compute the pressure of the cylinder during the combustion, determining the main influence factors. the emission model has been established to forecast the co, nox emission

    理論方面,提出了基於化學反應燃燒模型?多組分氣相反應系統化學反應動力學模型,以此進行雙燃料發動機熱力學?化學反應動力計算;引燃油燃燒模型,計算引燃油液滴分佈規律和滯燃期,驗證引燃油在雙燃料發動機燃燒過程中作用,揭示不同噴油規律對雙燃料發動機影響,確定在不同負荷下合理引燃油;爆震模型,揭示爆震與工質關系和影響爆震各種運轉因素,確定合理爆震依據,減小爆震傾向。
  8. Finally, an energy approach is combined with the fem in the simulation of the crack propagation along the fiber / matrix interface in a pull out process. the simulated results are in nice conformity with experimental results. the second part of the research deals with the characterization of the failure process in the fragmentation tests, which is one of the most frequently used test methods in studying thermal mechanical properties of fiber / matrix interfaces

    在這一部分工作最後,採用法與有限元法結合起來,模擬纖維抽拔試驗中裂紋擴展:針對以往研究工作中不足之處,在模擬中使用率,在表徵界面破壞時,所使用應力強度因子考慮了纖維和基體兩種材料不同屬性,並考慮裂紋尖端單元奇異性,來研究裂紋長度和溫度對裂紋擴展影響。
  9. A pressure disturbance cannot drive the energy release profile uniformly to the anti-node region to result in a sustained longitudinal wave.

    壓力擾動不可驅使分布圖移至波腹區域以產生持續縱向波。
  10. The southeast low - air jet accompanying the tropical cyclone transported plenty of heat and moisture for the storm, the low - level heating and wetting weakeed the stability of the air, and the weak cool air intruded from the low - level and stimulated the convection, thus leading to the heavy storm

    伴隨登陸熱帶氣旋生成低空東南急流為暴雨輸送了豐富和水汽,低層增暖增濕促使層結不穩定加劇,而西風帶弱冷空氣侵入對暖濕空氣具有抬升作用,可觸發對流發展和不穩定,導致大暴雨產生。
  11. The atoms can rid themselves of extra energy.

    原子夠把它們多餘出來。
  12. Bi - material interfacial fracture theories are researched with a phenomenon that cracks extend along interface. a gradient invading model of interface crack at the crack tip can gain stress fields along interface. so a formula of energy release rate for 3d braided cmc is deduced and the corrected formula of the energy release rate is examined with test results

    研究了裂紋沿界面擴展雙材料界面斷裂理論,利用傾斜侵入界面裂紋模型解析了裂紋尖端沿著界面應力場,推導了表徵三維編織cmc復合材料斷裂韌性率公式g _ c ,並且用試驗結果驗證了率公式正確性。
  13. Nothing can be cooler than 0k. the gas below the photosphere has a higher temperature and so will rise up to the photosphere. after releasing its energy, the gas will become cooler and darker

    光球層之下氣體溫度比光球層高,就好像沸騰水,底層氣體會向上升,當這些熾熱氣體把后,便會變冷變暗,然後沉降回光球層之下,這種對流運動產生了稱為
  14. At this stage, the countermeasures should aim at preventing triggering elements from happening or developing into the next stage. measures should be adopted to help the growth of psychological self while controlling the working of physiological self, to create positive circumstances for students " learning and activities, thus leading to the appropriate outlet of energy, and to purify the circumstances so as to reduce or avoid the outlet of energy

    這一階段對策主要目標是預防扳機因素發生或向向下一階段惡交,可以採取提高教師修養,有效引導青少年學生心理我成長,以控制生理我運行;為學生學習、活動等創設相應積極情境,引導青少年學生急劇增長恰當;凈化學校工具性情境、群集性情境,以減少或避免誘發青少年學生能量釋放的消極情境。
  15. The elastostatical problem of the energy release in a shear crack was first created by starr (1928).

    剪切裂縫中能量釋放的彈性靜力問題最先由Starr(1928)進行了研究。
  16. But what is the nature of the friction inside the accretion disks that touches off this enormous energy release

    然而,引發吸積盤內巨大能量釋放的摩擦,本質是什麼?
  17. The elastostatical problem of the energy release in a shear crack was first created by starr ( 1928 )

    剪切裂縫中能量釋放的彈性靜力問題最先由starr ( 1928 )進行了研究。
  18. After the ball leaves, the racquet mass center ( balance point ) moves at a slower speed, and this means a loss of its kinetic energy ( kinetic energy = 1 / 2 mass times velocity squared )

    球離開之後,球拍開始減速,球拍減速過程就是能量釋放的過程,值等於? (球拍)質乘以速度平方。
  19. Upon backgrounds of the research, academic points and so on, chinese and foreign academic circles have much in differences at the same time. starting with the basic hypothesis like " " spirit " and " " motivation ", this thesis brings out a new concept of spiritual motivation and holds the - view that corresponded with the material motivation ; spiritual motivation is the basic means of mental reconstruction and behavior improvement. it ' s a conduct mechanism of the transformation " from knowledge to practice ", a direct way of transforming the morale value and releasing the energy of spirit

    學界關于精神激勵學術成果較少,且散見于不同學科領域,在研究背景、學術觀點等方面中西方又有分野,本文從「精神」和「激勵」等基本命題著手,提出精神激勵新概念,認為精神激勵是與物質激勵相對應精神構建和行為驅動基本方式,是「知?行」轉化誘發機制,也是精神價值轉換和能量釋放的直接途徑,它揭示精神與行為相關性,表徵精神因素對個體行為選擇干預和影響。
  20. The event gave us a good opportunity to discuss the processes of magnetic change, energy release and particle acceleration in the corona during the preflare, especially using decimetric and microwave fine structure data. in this thesis, we report the solar type iv bursts and its associated fiber fine structures recorded on 14 july 2000

    中國國家天文臺懷柔觀測站寬帶頻譜射電望遠鏡,觀測到了來自內日冕區射電爆發及其精細結構,攜帶著耀斑爆發初期磁場變化、能量釋放的豐富信息,很有必要對其進行深入理論分析和計算。
分享友人