脈動流出 的英文怎麼說

中文拼音 [màidòngliúchū]
脈動流出 英文
positive discharge
  • 脈 : 脈名詞1. （動脈和靜脈的統稱） arteries and veins2. （脈搏的簡稱） pulse 3. （像血管的組織; 連貫成系統的東西） vein
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 脈動 : [物理學] [天文學] pulsation; pulsing; pulse; ripple; impulsive motion; pulsating; panting; loping...
  • 流出 : outflow; effusion; runout; vegetate; runoff; profluvium; discharge
  1. Fluid noise mainly comes from out put pulsation of rate of flow, the main reason of out put pulsation of rate of flow is the instant high pressure return flow that obturation cubage produced when the big round curve pressure transition. the v trough on the port plate can reduce the fluid noise. in this paper, the author based on the acting of dam a river and condensability of liquid and used matlab language as tool to calculate the v trough on the original port plate and drew out the p - t diagrammatic curve and analyzed its shortcoming and improved the design of original v trough and got that the best size of its angle was 12. 3 and its length was 5mm and the cross section was an equilateral triangle

    流體噪聲主要來源於輸出流量脈動，造成輸出流量脈動的主要原因是閉死容積在大圓弧段壓力切換時產生的瞬時高壓迴流，在配流盤上開設v型尖槽可降低因高壓迴流而引起的流體噪聲，本文以截流作用和液體的可壓縮性為理論依據，以matlab語言為工具，對原配流盤上的v型尖槽進行了理論計算，繪制出p - t圖線，分析了它的不足，並對原有v型尖槽進行了優化設計，得出了v型尖槽的最佳幾何尺寸：配流盤平面上的v型尖槽的兩邊的夾角為12 . 3 ，槽長5mm ，槽的橫截面為等邊三角形。
  2. This paper supplied a new way through variable frequency variable speed ( vfvs ) to change its output flow rate and adding a constant - pressure - drop valve, which could solve the defects in hydraulic pressure servo control system, such as low efficiency in control system, short life, poor ability in resisting pollution, low efficiency in driving system and flow rate, pressure pulse. and this way was proved to be effective

    本論文針對傳統伺服控制系統效率不高、元件壽命短、抗污染能力差、驅動系統效率低、存在流量及壓力脈動等缺陷，利用先進的交流變頻調速技術改變液壓泵轉速的容積調速新方法，提出了在液壓系統中加一個定差減壓閥的新思路，較好地解決了液壓伺服系統存在的上述問題。
  3. Water feeding framework takes electromagnetism water valve as administration component and is added relief valve for stabilizing hydraulic pressure ; the system has large, middle and small water valve that changes unlock combination of electromagnetically operated valve, which can get seven different water flux ; if it is necessary, it should adopt microseism water feeding that can make water feeding get stepless timing

    3加水機構加水機構採用電磁水閥作為執行元件，加入調壓閥穩定水壓，系統共設大中小三路加水閥，變化電磁閥的開啟組合，可以得出7種不同的加水流量，必要時採用脈動加水法，可使加水達到無級調速。
  4. Value of construetion of bypass circuit outflow tract in femoral - popliteal arterial grafting operation

    股?動脈旁路轉流術中側支循環流出道重建的臨床效果
  5. The algorithm of svpwm that is adopted by the system implements motor speed - regulation by control of magnitude and phase of motor flux. it can generate less harmonics in the output current of power inverter and less losses of ac motor, reduce pulsant component in output torque and raise availability of dc supply voltage

    系統採用的svpwm演算法通過對空間磁鏈矢量幅值和相位的控制來調節電機轉速，減少了逆變器輸出電流的諧波，降低了脈動轉矩，提高了電壓的利用率。
  6. They generally arise when a continuous pressure differential allows blood to flow constantly from a high to a low pressure area, as may occur in a variety of congenital defects, most commonly patent ductus arteriosus, anomalous origin of the left coronary artery, or coronary arteriovenous fistula

    一般出現在持續壓力差使血液從一高壓區不斷流向低壓區時，也可以出現在一些有先天性缺陷的病，最常見的有動脈導管未閉、左冠狀動脈起端異常，或冠狀靜脈動脈瘺。
  7. Pulsating spray drying technique makes use of the unstable hot gas stream generated by a pulse combustor to atomi / e and dry a liquid material

    脈動燃燒乾燥技術是近年來出現的一種新型乾燥技術，它利用脈動燃燒器產生的高溫，高頻脈動尾氣流直接霧化和乾燥液態物料。
  8. Aim at to turn a dense oil pump in the movement the metal bellow expansion joint and buffer tank was installed in the dense oil pump export because of the violent vibration and noise cause by the discharge and the pressure pulsation, the result show lowered the vibration and noise availably was obvious

    摘要針對轉子式稠油泵在運行中因流量和壓力脈動所引起的劇烈震動和噪聲，在稠油泵出口安裝金屬伸縮節和緩沖罐，有效地降低了震動和噪聲。
  9. For the bldcm which has a pseudo - sinusoidal back - emf waveform, this dissertation presents a svpwm control method using six discrete position signals for minimizing the torque ripple. the main aspects for the implementation of this method are analyzed, including the initial orientation of the voltage vector, reasonable choice of the impedance angle and the advance commutation angle, and estimation of the successive rotor positions

    針對反電動勢類似正弦的準正弦波反電動勢無刷直流電動機，本文提出一種基於六個離散位置信號的自同步svpwm （電壓空間矢量法）控制方法，用以削弱電磁轉矩脈動，分析了實現這種方法的主要控制環節，包括起動時電壓空間矢量的初始定位，阻抗角與電流超前角的合理選擇以及連續轉子位置的估計等。
  10. For the bldcm which has a general crest width of the back - emf waveform, two kinds of torque ripple conditions when drived by sine - wave current as well as by square - wave current are deduced based on the mathematical models. in addition, a comparison is carried out between these two conditions, which indicates that sinusoidal current driving is more favorable to minimizing the torque ripple when the crest width of the back - emf waveform is less than a certain value

    闡述了抑制齒槽轉矩措施對反電動勢波形的影響，利用無刷直流電機的數學模型推導並比較了任意平頂寬度梯形波反電動勢在正弦波和矩形波兩種電流驅動下的電磁轉矩脈動情況，得出在梯形波平頂寬度減小到一定數值后採用正弦電流驅動更有利於減小電磁轉矩脈動。
  11. In this work, a new dual triangulate bluff body vortex flowmeter was developed, the flux lower limit value of which lower by 50 % that of the old single bluff body vortex flowmeter. the linear correlation of the correlation between the velocity pressures of fluid disturbs wave and that of vortex precession in vortex precession flowmeter was brought to light, and a spectrum phase discrimination method based on fft to remove the effect of fluid pulsating interference on vortex precession flowmeter was advanced

    研製出比傳統單鈍體渦街流量計流量下限降低約50的新型雙鈍體渦街流量計；揭示出脈動流中旋進旋渦流量計流體振動特性，並在此基礎上提出基於fft相位判別的數字信號處理方法來消除流場脈動對旋進旋渦流量計的干擾的方法。
  12. 3. with fourier decomposition, the main component of pulsating torque, torque ripple is studied. it can be determined that torque ripple is caused by harmonic order 6n under the usual common conditions

    3 、對造成轉矩脈動的主要成分轉矩紋波進行諧波分析，得出在一般假設情況下，無刷直流電動機系統的轉矩紋波由電磁轉矩的6n次諧波造成的結論。
  13. The following is the detail design of the pump, and a optimum mathematical model are presented to mostly reduce the helical gear pump flow pulse

    在此基礎上進行了斜齒齒輪泵的結構設計，通過建立斜齒齒輪泵齒輪的優化數學模型，優化計算出使輸出流量脈動最小的斜齒輪參數，製造出斜齒齒輪泵樣機。
  14. At first, on the base of the analysis of the mechanism of the helical gear pump, the paper try to find the relationship of the helical gear pump flow pulse with its corresponding parameters, give the solution of the problems brought by the replace of spur gear to lay the firm basis for the structural design of helical gear pump

    本論文在對齒輪泵工作原理和流量脈動機理分析的基礎上，首先探討了斜齒齒輪泵的輸出流量脈動與斜齒輪各結構參數之間的關系，以及由於斜齒輪替代直齒輪帶來的相關問題並提出解決辦法，為斜齒齒輪泵的結構設計奠定基礎。
  15. The study shows that the output pulse value of resistance absorption equipment is related to the chopper switch conduction ration and the selection of lagging angle

    研究表明，地面電阻吸收裝置的輸出電流脈動與斬波器的導通比、各支路斬波器的開關滯后角有關。
  16. In this dissertation, the pulse jet style, the influence on the shock wave, the flow in the tube and the cooling effect was deeply studied theoretically and experimentally. the influence of the pulse jet style on the forming of shock wave and the shock wave intensity was explored. the initial disconnection style in oscillating tube vented and the initial disconnection breakdown was proposed by different pulse jet style

    本文對脈動射流的型式及其對激波、管內流動及冷效應的影響進行了較系統的理論和實驗研究，主要包括:探討了脈動射流的型式對形成管內激波形成及激波強度的影響，給出了不同脈動射流的型式下振蕩管開口端初始間斷的類型，對初始間斷進行了分解，導出了包含進氣、排氣參數及工質物性參數的管內入射激波馬赫數mj的表達式，給出了管內激波形成的三種原因及其所對應的脈動射流型式和具體的工作狀態。
  17. Motion equations for the composite laminated plates induced by oscillatng flow were derived

    摘要導出在脈動流順流向作用力下的復合材料層合板的運動方程。
  18. Through research of automatic dosing system, established by determining automatic dosage in the methods of transmittance pulsation, streaming potential and mathematical model, it can be concluded that the automatic dosing system brought forward in this paper can fulfill requirements of the technics. likely, this system can also be applied for dosing of other chemicals in water plants, chemical dosing of wastewater treatment plants and other similar places

    通過對採用透光率脈動、流動電位、數學模型等方法確定混凝劑投加量建立的自動配投系統的研究表明本文提出的自動配投系統能滿足工藝的要求：同樣該系統也適用於給水處理廠其他藥劑的投加，適用於污水處理廠及其他類似場合藥劑的投加。
  19. In chapter 3, the pressure pulse under the two situations of the system with and without damper is discussed at the basic of analyzing the flow rate pulse. then the conclusion that the system has filtering effect is drew after adding a damper in it, but its serious in power wastage because of adding a damper

    第三章，在分析液壓泵流量脈動的基礎上，討論並對比了系統加與不加阻尼兩種情況下各自的壓力脈動，得出系統中加一個阻尼后，具有一定的濾波作用，但是當流量較大時，由於阻尼的存在，系統功率損失比較嚴重。
  20. Under different positions of a tripping wire or speeds of the side jet, the controlled experiments were made, including the receptivity of the shear layer near jet exit to acoustic excitations, the spatial development of fluctuating velocity and the profiles of mean velocity

    在不同絆線位置或不同旁射流流速條件下，研究了射流出口臨近剪切層對聲激勵的感受性，脈動流速向下游的空間演化及平均流速剖面。
分享友人
分享到 Line

分享到臉書