脈動直流電 的英文怎麼說

中文拼音 [màidòngzhíliúdiàn]
脈動直流電 英文
pulsating direct current
  • 脈 : 脈名詞1. （動脈和靜脈的統稱） arteries and veins2. （脈搏的簡稱） pulse 3. （像血管的組織; 連貫成系統的東西） vein
  • 直 : Ⅰ形容詞1 （成直線的; 硬挺的） straight; stiff 2 （跟地面垂直的; 從上到下的; 從前到后的） erect; v...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 脈動 : [物理學] [天文學] pulsation; pulsing; pulse; ripple; impulsive motion; pulsating; panting; loping...
  • 直流 : direct current （dc）; constant current; steady current; continuous current; zero frequency curre...
  1. The experiment results indicate that this method is more effective in the brushless direct current motor ' s low speed torque ripple attenuation, and its more effective in improving system dynamic performance

    運行結果表明，此方案能有效地抑制無刷直流電動機低速時的轉矩脈動，更好地改善系統的動態性能。
  2. 3000 hours. lower voltage high capacitance cdf farad - grade aluminum electrolytic capacitor. well suited for use in super car audio systems, industrid robots, telecommunication equipmemt of dc or pulse circuits

    3000小時，低電壓高電容量法拉級cdf ，廣泛用於精密汽車聲頻系統、工業機器人，電信設備的直流電或脈動電路中。
  3. Torque ripple reduction in brushless dc motor drives using a buck converter

    變換器的無刷直流電機轉矩脈動抑制方法
  4. For the bldcm which has a pseudo - sinusoidal back - emf waveform, this dissertation presents a svpwm control method using six discrete position signals for minimizing the torque ripple. the main aspects for the implementation of this method are analyzed, including the initial orientation of the voltage vector, reasonable choice of the impedance angle and the advance commutation angle, and estimation of the successive rotor positions

    針對反電動勢類似正弦的準正弦波反電動勢無刷直流電動機，本文提出一種基於六個離散位置信號的自同步svpwm （電壓空間矢量法）控制方法，用以削弱電磁轉矩脈動，分析了實現這種方法的主要控制環節，包括起動時電壓空間矢量的初始定位，阻抗角與電流超前角的合理選擇以及連續轉子位置的估計等。
  5. The simulation results prove that this control technique can effectively minimize the torque ripple for the bldcm drives whose back - emf waveform crest width is less than 120

    模擬結果表明這種控制策略能有效地抑制反電動勢平頂寬度小於120電角的無刷直流電動機的換相轉矩脈動。
  6. Furthermore, this dissertation also gives a comprehensive analysis and comparison to the torque ripple factor, torque - current ratio and other aspects for pseudo - sinusoidal emf bldcm drived by 120 conduction mode, 180 conduction mode and self - synchronous svpwm mode respectively. the simulation and the experimental results indicate that self - synchronous svpwm method is more effective for minimizing the torque ripple without any expense of the torque - current ratio when the crest width of the back - emf waveform is less than 107 electrical angles

    對準正弦波反電動勢無刷直流電動機在120導通方式、 180導通方式和自同步svpwm三種控制方式下的轉矩脈動系數、轉矩電流比等方面進行了全面的分析與比較，模擬研究和實驗結果表明，當反電動勢的平頂寬度小於107電角時，採用自同步svpwm控制方法可以在不損失轉矩電流比的基礎上，更有效地抑制電磁轉矩脈動。
  7. For the bldcm which has a general crest width of the back - emf waveform, two kinds of torque ripple conditions when drived by sine - wave current as well as by square - wave current are deduced based on the mathematical models. in addition, a comparison is carried out between these two conditions, which indicates that sinusoidal current driving is more favorable to minimizing the torque ripple when the crest width of the back - emf waveform is less than a certain value

    闡述了抑制齒槽轉矩措施對反電動勢波形的影響，利用無刷直流電機的數學模型推導並比較了任意平頂寬度梯形波反電動勢在正弦波和矩形波兩種電流驅動下的電磁轉矩脈動情況，得出在梯形波平頂寬度減小到一定數值后採用正弦電流驅動更有利於減小電磁轉矩脈動。
  8. 3. with fourier decomposition, the main component of pulsating torque, torque ripple is studied. it can be determined that torque ripple is caused by harmonic order 6n under the usual common conditions

    3 、對造成轉矩脈動的主要成分轉矩紋波進行諧波分析，得出在一般假設情況下，無刷直流電動機系統的轉矩紋波由電磁轉矩的6n次諧波造成的結論。
  9. During the circuit design, the author analyzed the basic principle of the direct current motor, pwm control, h - bridge power driver, and two control techniques of h - bridge power drive circuit, designed its general structure, so the feasibility of the design is confirmed. then, reference, oscillator, power dmos gate drive circuit ( charge pump, bootstrap ), and dead time generation circuit are designed and analyzed in the sub - circuits. a current - controlled oscillator is presented in this thesis

    在電路設計中，作者介紹了直流電機的工作原理和數學模型、脈寬調制（ pwm ）控制原理、 h橋電路基本原理和h橋功率驅動電路的兩種控制模式，設計了驅動電路的總體結構，給出了電路的功能模塊，確定了設計的可行性，然後在子電路模塊中，重點分析設計了基準源電路、振蕩器電路、高端功率管柵驅動電路（電荷泵及自舉電路） 、低端功率管柵驅動電路和死區時間產生電路。
  10. Analysis on commutation torque ripples of a pmbdc motor based on c - dump converter

    變換器供電的無刷直流電機換相轉矩脈動的分析
  11. An analysis and a compensation method for commutation torque ripple in trapezoidal bldc motor

    無刷直流電機換相轉矩脈動的分析及其補償方法
  12. This dissertation majorly researchs and designs full digital dc driving system with fuzzy control. it makes a scheme argumentation firstly, analyzing the pid algorithm and fuzzy control algorithm the ordinary digital pulse trigger algorithm and the double remainder method of pulse trigger in detail, and fuzzy control and the double remainder method are put forward to settle the under - mentioned problems, namely, the new viewpoint and the task having finished in this dissertation as follows : ( 1 ) in rder to overcome the influence of dc motor ' s parameter changing with time and nonlinear on the control system performance, this dissertation adopts fuzzy control as outside regulator and pi control as inside regulator in double regulators of the full digital dc motor driving system design ;. ( 2 ) aiming at the pulse trigger reliability of the ordinary d igital pulse trigger being low and leaking the pulse or the order of pulse confusion, this paper adopts the double remainder algorithm with short response time high pulse trigger reliability good adaptability and anti - jamming ; ( 3 ) this dissertation adopts tms320lf2407 which has good performance as major control chip this chip has power function with fast calculation capability, and accomplishes the software and hardware design in the dc motor driving system with fuzzy control ; ( 4 ) this dissertation also puts emphases on anti - jamming in hardware and software ; ( 5 ) after having designed the sample of full digital dc motor driving system with fuzzy control, a lot of experiments are performed to verify the performance and settles problems during experiment. the result of experiment proves the feasibility of design

    首先進行了方案論證，對模糊控制演算法和數字pid調節演算法、觸發脈沖的一般演算法和雙余演算法進行了詳細地研究分析，提出應用模糊控制和雙余法解決下述問題，即該論文主要的新見解和所完成的工作： （ 1 ）為了克服直流電機參數時變性和非線性因素對控制性能的影響，本設計中，雙閉環調速系統的外環採用模糊控制，內環採用pi控制，使系統在一定范圍內對直流電機參數變化和非線性因素影響有自適應能力； （ 2 ）針對常規數字觸發器演算法中觸發脈沖的可靠性不高，經常出現漏脈沖或是脈沖混亂的情況，本文採用雙余法，該演算法具有響應快，可靠性高，具有良好的適應性及抗干擾能力； （ 3 ）本設計中採用了速度快、功能強的tms320lf2407作為系統的主控晶元，應用該晶元完成系統的軟硬體設計： （ 4 ）本文對系統抗干擾的軟硬體措施進行了重點研究； （ 5 ）設計了具有模糊控制的全數字直流傳動系統原理樣機，並進行了試驗驗證，對試驗過程中出現的問題及時解決，最終實驗結果證明設計是可行的。
  13. Modified formula for sensorless dc motor speed estimation was proposed through the test for relationship between the current ripple frequency and the rotation speed in a 4 - pole dc motor

    摘要根據4極直流電動機的轉速與脈動電流頻率關系的實驗結果，對現有的無傳感器直流電動機測速公式提出了修正意見。
  14. The new modified formula not only meets with our experiment result, but also can explain the examples of relationship between the speed and the current ripple frequency of dc motors in the literature

    新的修正公式不僅能夠解釋文中的實驗結果，也能滿足以往文獻提出的直流電動機轉速與脈動電流頻率之間的關系。
  15. In addition, the effects on the torque ripple caused by the pwm modes, overlapping commutation and so on are analyzed, and the conclusion is reached : the commutation torque ripple varies with the rotor speed

    並得出結論：永磁無刷直流電機換相轉矩脈動的大小在電機確定的條件下，主要受電機轉速的影響。
  16. Although many cnc systems still use hydraulic or pulse motors, the dc drives have gained dominance on a much larger scale

    雖然許多電腦數字控制系統動仍然使用水壓或脈沖馬達，但是直流電器已在許多大型設備上佔有優勢。
  17. Gca silicon commutate battery charger are the ideal portable tools for charging, they are composed with the conditions of voltage dropping through rectifier transformer, then the bridge rectifying of rectification circuit. the output full - wave pulstin current charge the storage battery. the voltage changing composed with multiband switch. the outputcurrent can be adjusted. this kind of product used any moment onctarging anyplace

    Gca系列整流充電機是由整流變壓器的降壓，再經過流電路的橋式整流，輸出全波脈動直流對電瓶進行充電，電壓調速同多頭波段開關組，輸出流可以調節，該產品用任何需要補充充電的場所。
  18. Rules for capacitors ; part 11 : rules for capacitors of more than 600 v for the equalizing of pulsating direct voltages

    電容器的規范.第11部分:大於600 v的脈動直流電壓均
  19. Based on the dc diffusion model, we build a duplex diffusion layer model which is composed of inner pulse diffusion layer and outer stable diffusion layer. in inner pulse diffusion layer, the concentration of ions fluctuates with frequency of pulse current ; in outer stable diffusion layer, the transport speed of ions is almost stable all the time, the main purpose is to transport the ions from the mass to the pulse diffusion layer

    在直流電沉積的擴散理論基礎上，建立了脈沖電沉積的雙擴散層模型，靠近電極為脈沖擴散層，擴散層內金屬離子的濃度隨脈沖電流的頻率而波動;脈沖擴散層外麵包圍著一層穩態擴散層，其中離子的擴散速度在整個過程中基本是穩定的，作用是將主體溶液中的離子不斷向脈沖擴散層中補充。
  20. So the compensation of pulsating torque is very importance for the application of pmsms

    因此，對無刷直流電動機的應用，必須考慮其轉矩脈動的抑制問題。
分享友人
分享到 Line

分享到臉書