脈動空泡 的英文怎麼說

中文拼音 [màidòngkōngpāo]
脈動空泡 英文
pulsating cavity
  • : 脈名詞1. (動脈和靜脈的統稱) arteries and veins2. (脈搏的簡稱) pulse 3. (像血管的組織; 連貫成系統的東西) vein
  • : 空Ⅰ形容詞(不包含什麼; 裏面沒有東西或沒有內容; 不切實際的) empty; hollow; void Ⅱ名詞1 (天空) s...
  • : 泡Ⅰ名詞1 (氣泡) bubble 2 (像泡一樣的東西) sth shaped like a bubble Ⅱ動詞1 (較長時間地放在液...
  • 脈動 : [物理學] [天文學] pulsation; pulsing; pulse; ripple; impulsive motion; pulsating; panting; loping...
  • 空泡 : [醫學] vacuole; physalides; vacuolus
  1. This high magnification of the atheroma shows numerous foam cells and an occasional cholesterol cleft. a few dark blue inflammatory cells are scattered within the atheroma

    圖示:粥樣硬化高倍鏡顯示多量沫細胞,偶見膽固醇結晶(棱狀隙) 。一些暗藍色的炎細胞散在分佈於粥樣硬化病灶內。
  2. The advantage and disadvantage of measurement of propeller - induced pressure by using different equipment is discussed. the method to obtain self - propulsion point for full scale in depressurized towing tank is studied. the measurements of pressure of two propeller models are carried out, the results of the measurement agree with those obtained by cavitation tunnel very well, which proves this measurement is successful, and the theoretical prediction is verified too

    比較了不同測試設備用於螺旋槳壓力測試的優缺點,探討了在減壓拖曳水池中實現實船自航點的方法,並進行了兩只螺旋槳模型的壓力測試,經與水洞中壓力的測試結果進行比較,說明該項測試是成功的,同時也對壓力的理論預報結果做了驗證。
  3. The prediction error percentage of the 52000t all - purpose cargo ship compared with the model test result is 21. 8 %, 300000t vlcc compared with the measured value is merely 3. 64 %

    用該公式預報的5 . 2萬噸多用途貨船的壓力值與水筒中的實驗值相比誤差為21 . 8 % ;預報了30萬噸超大型油船的激振力並由該激振力算出的尾端振速度值與實測值相比誤差僅為3 . 64 % 。
  4. 3 ) open - water and self - propulsion tests for the hd propeller and mau propeller. 4 ) cavitation observation and pulsing pressure measurement

    3 )滬東型( hd ) mau圖譜槳的敞水試驗和自航試驗4 )滬東型( hd )螺旋槳的觀察與壓力測量。
  5. An experimental study on fluctuating hydrodynamic loads on cavitating axisymmetric slender bodies

    軸對稱細長體水的實驗研究
  6. Presently most of the theoretical method to predict the propeller - induced hull pressure fluctuation is based on the calculation method in which the pressure is induced by pulsating source in infinite flow. the calculation method is adopted and the corresponded computer program is complied. the propeller - induced hull pressure fluctuation due to blade thickness, blade load, cavity thickness and the change of the cavity volume can be analyzed respectively in the computer program

    目前,螺旋槳誘導的船體表面壓力的理論預報方法,大多是以無限流場中點源誘導的周圍流場的壓力的計算方法為基礎的,本文採用該方法編制了計算程序,可以分別考慮槳葉厚度、槳葉負荷、槳葉上厚度及其體積變化在船體表面指定位置上產生的壓力。
  7. We believed that laser manipulation of a bubble might present a way to control the dynamic process of the bubble and clarify the origin of single - bubble luminescence. - especially, the liquid - to - vapor phase transition of a micro system ( such as a vapor bubble ) could be studied by using our method

    最近,本研究組提出利用紅外激光產生的熱鑷作用於思想,並成功實現了利用熱鑷操縱沖激光產生的單個,分析了熱鑷的起源,研究了相變的力學過程。
  8. With the fund item sponsored by the national laboratory of hydrodynamics, the study on measurement method of propeller - induced pressure with using self - propulsion model has been carried out in depressurized towing tank

    壓力的模型測試研究方面,本文在水力學國家重點實驗室基金項目的資助下,對在減壓拖曳水池中利用自航模進行螺旋槳誘導的壓力的測試方法進行了研究。
  9. The prediction of propeller - induced hull pressure fluctuation in non - uniform flow is studied by using theoretical calculation and model experiment systematically. an intact method and computer program for the prediction of unsteady cavitating propeller - induced hull pressure fluctuation in non - uniform flow is set up in this paper. the measurement of propeller induced hull pressure fluctuation in depressurized towing tank carried out in this paper is the first time inland

    本文從理論計算和模型試驗兩個方面系統地研究了不均勻流場中螺旋槳誘導的船體表面壓力的預報問題,建立了一套完整的預報非定常螺旋槳誘導的船體表面壓力的方法和程序,並在國內首次完成了在減壓拖曳水池中進行螺旋槳誘導的船體表面壓力測試。
  10. The better agreement between the calculated value and the measurement result of propeller - induced hull pressure fluctuation proves that the program in this paper can be suitable for engineering application

    經與水洞中螺旋槳模型壓力測試結果比較,表明本文的計算程序可以用於工程實際。
  11. The finite difference method and matlab / simulink are used to simulate the pressure transients accompanying the growing and collapsing of gas bubbles and cavitation in low pressure hydraulic pipelines. a method using selector block in matlab simulink to solve the equations in spatial dimension is developed. the pressure transients under different conditions such as different initial flow rate, different viscosity and different initial gas bubble volume are simulated

    採用有限差分及matlab / simulink模擬方法,提出了採用simulink中selector模塊求解間域上積分的方法,對低壓液壓管路有氣和氣穴產生的瞬態壓力過程進行了時間域和間域上的求解,對不同起始流量、不同液壓油粘度和不同初始氣量等條件下的瞬態壓力過程進行了模擬研究。
分享友人