脈時解調器 的英文怎麼說

中文拼音 [màishíjiědiào]
脈時解調器 英文
pulse time demodulator
  • : 脈名詞1. (動脈和靜脈的統稱) arteries and veins2. (脈搏的簡稱) pulse 3. (像血管的組織; 連貫成系統的東西) vein
  • : shí]Ⅰ名1 (比較長的一段時間)time; times; days:當時at that time; in those days; 古時 ancient tim...
  • : 解動詞(解送) send under guard
  • 調 : Ⅰ動詞1 (配合得均勻合適) harmonize; suit well; fit in perfectly 2 (使配合得均勻合適) mix; adju...
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  • 解調器 : demodulator; rectifier; redresser; detuner
  1. This paper starts the research of the liquid floated pendulous accelerometer testing system according to the engineering. at first, this paper gives the brief introduction of the history and present status of accelerometer and its testing technology, the working principium and math model of the liquid floated pendu - lous accelerometer, and then, decides the binary width pulse force retrim loop as the design proposal of testing system, researches the transfer function of every part in the system emphasizly, analyses the stability of the whole accelerometer testing system from the angle of control theoretics by the open loop transfer function of system, and designed the correcting net, analyses the basal problems such as resolution, sampling restraint, precision and so on, designs the hardware testing circuits such as preamplification, band - pass filter, alternating amplifier, phase sensitive demodulatorn, pulse - width modulation, frequency scale circuit, moment current generator. finally, using the graphics program language labv - iew which is designed for testing field especially by ni accomplishes the solfware design of testing system, realized the testing functions

    首先對加速度計及其測試技術的發展歷史和現狀,液浮擺式加速度計的工作原理和數學模型等作了簡要的介紹,然後確定了以二元調沖再平衡測試迴路為設計方案,並從控制理論的角度進行了分析,著重研究了系統中各部分的傳遞函數,利用系統開環傳遞函數分析了系統的穩定性,同設計了系統的校正網路;分析了二元調沖再平衡測試迴路的析度、采樣約束以及測試精度等基本問題,並按照系統分析的結果設計了包括前置放大、帶通濾波、交流放大、相敏調調制、頻標電路以及力矩電流發生等測試系統各部分硬體電路,驗證了電路的正確性,最後按照測試系統的要求,採用了美國ni公司專為測試領域所開發的虛擬儀工具? ? labview作為測試軟體開發工具,利用該圖形化編程語言完成了測試系統軟體部分的設計,實現了測試功能。
  2. 3. passive and active time - domain demodulation schemes were demonstrated based on a fiber bragg grating used as a tunable filter controlled by a piezoelectric stack, which was driven by an electrical sine wave signal. the measured strain applied on the sensor axially could be judged by observing the interval of the output between notches within a driving period in time - domain

    利用匹配濾波技術,分別採用無源和有源方式,藉助受pzt驅動的調光柵,將待測應變信息變為序負沖間隔的變化,利用常規的示波觀測同一掃描周期中兩負沖在域中間隔的變化來確定待測應變的變化。
  3. This dissertation majorly researchs and designs full digital dc driving system with fuzzy control. it makes a scheme argumentation firstly, analyzing the pid algorithm and fuzzy control algorithm the ordinary digital pulse trigger algorithm and the double remainder method of pulse trigger in detail, and fuzzy control and the double remainder method are put forward to settle the under - mentioned problems, namely, the new viewpoint and the task having finished in this dissertation as follows : ( 1 ) in rder to overcome the influence of dc motor ' s parameter changing with time and nonlinear on the control system performance, this dissertation adopts fuzzy control as outside regulator and pi control as inside regulator in double regulators of the full digital dc motor driving system design ;. ( 2 ) aiming at the pulse trigger reliability of the ordinary d igital pulse trigger being low and leaking the pulse or the order of pulse confusion, this paper adopts the double remainder algorithm with short response time high pulse trigger reliability good adaptability and anti - jamming ; ( 3 ) this dissertation adopts tms320lf2407 which has good performance as major control chip this chip has power function with fast calculation capability, and accomplishes the software and hardware design in the dc motor driving system with fuzzy control ; ( 4 ) this dissertation also puts emphases on anti - jamming in hardware and software ; ( 5 ) after having designed the sample of full digital dc motor driving system with fuzzy control, a lot of experiments are performed to verify the performance and settles problems during experiment. the result of experiment proves the feasibility of design

    首先進行了方案論證,對模糊控制演算法和數字pid調節演算法、觸發沖的一般演算法和雙余演算法進行了詳細地研究分析,提出應用模糊控制和雙余法決下述問題,即該論文主要的新見和所完成的工作: ( 1 )為了克服直流電機參數變性和非線性因素對控制性能的影響,本設計中,雙閉環調速系統的外環採用模糊控制,內環採用pi控制,使系統在一定范圍內對直流電機參數變化和非線性因素影響有自適應能力; ( 2 )針對常規數字觸發演算法中觸發沖的可靠性不高,經常出現漏沖或是沖混亂的情況,本文採用雙余法,該演算法具有響應快,可靠性高,具有良好的適應性及抗干擾能力; ( 3 )本設計中採用了速度快、功能強的tms320lf2407作為系統的主控晶元,應用該晶元完成系統的軟硬體設計: ( 4 )本文對系統抗干擾的軟硬體措施進行了重點研究; ( 5 )設計了具有模糊控制的全數字直流傳動系統原理樣機,並進行了試驗驗證,對試驗過程中出現的問題及決,最終實驗結果證明設計是可行的。
  4. The whole pwm circuit contains two subcircuit, the front - end is pwm module that make up of the counter that based on nine mosfet true - single - phase - clock d flip - flop ; the back - end is demodulated module, which is consist of a three order chebyshev low - pass filter used trans - conductor capacitor. all the subcircuits are simulated. at last, an approving simulated result of the whole circuit is given too

    調制部分,利用九管單相鐘d觸發構成計數,並由此組成了沖寬度調制電路,同給出了在典型溫度下的模擬結果;在調部分,介紹了低通濾波從無源到有源的設計方法,設計了三階切比雪夫低通跨導電容濾波,同樣給出了相應的模擬結果;最後,作為將沖寬度調制電路和濾波作為整體電路,以調頻波為輸入進行了模擬,取得了令人滿意的結果。
  5. Firstly, this paper introduces the asynchronous motor model, and compares it with the dc motor ’ s. then the paper studies the principle of vector control, and proposes an improved current model of rotor flux observer. this paper also studies the three - level inverter ’ s topology, working principle, the neutral - potential unbalance mechanism and its controlling strategy. the paper especially studies the svpwm in details. the interface between the vector control and the three - level inverter is studied in details, including the generation of reference voltage vector, its judging of the sector and triangular regions, and the working mechanism after it sent into three - level inverter. when synthesizing the reference voltage vector, select the vector which only includes p and o states as the starting vector, thus eliminate the vector shift problem when sector changes. this paper fully takes advantages of the powerful functions of matlab / simulink to set up the simulation model. this construction is very explicit. the simulation results verify the inverter voltage output is correct, the rotor flux is steady, the asynchronous motor ’ s dynamic and steady state performances and speed modulation are excellent

    本文首先介紹了異步電機的數學模型,在此基礎上將異步電機的數學模型與直流電機的數學模型進行了比較;然後介紹了矢量控制的基本原理,採用了一種改進的轉子磁鏈電流型觀測模型;對三電平逆變的電路拓撲、工作原理、中點電位不平衡的機理及控制方法進行了介紹,詳細分析了空間矢量調制策略。本文對異步電機的矢量控制與三電平逆變之間的介面進行了詳細的研究,包括:參考電壓矢量的形成、所落扇區與具體小三角形區域的判斷、送入逆變之後的工作機理。在參考電壓矢量的合成,選擇只包含p 、 o狀態的空間電壓矢量作為起始矢量,決了扇區切換的矢量突變問題。
  6. The forming mechanism of crosstalks in the tdm system was analyzed theoretically, and the relationship between crosstalks and the extinction ratio of optical pulse modulator used in the tdm system was investigated. the interchannel and intrachannel crosstalks in the wdm system were discussed separately, and the contributions to crosstalks were appraised from architecture ’ s alteration, the finite isolation between channels in multiplexers or demultiplexers, and nonlinear effects in the system. noises in the large - scale multiplexing system were studied theoretically, and all kinds of factors were considered that have relation to noises, phase resolution, and dynamic range of the system, such as multiplexing channel number, the length of the transmission fiber, using in - line erbium - dropped fiber amplifiers or not, and so on

    本文從理論上分析了光纖水聽分復用系統串擾的形成機理,分析了光調的消光比與系統串擾的關系;分別對光纖水聽波分復用系統的異頻串擾和同頻串擾進行了理論分析,研究了光纖水聽波分復用結構、波分復用復用隔離度等因素以及非線性效應對系統串擾的影響;對大規模光纖水聽復用系統噪聲進行深入細致的理論分析,研究了系統噪聲、相位析度、動態范圍與復用數目、傳輸光纖長度、中繼光纖放大等諸多因素的關系。
  7. A new pattern position sensitive detector is introduced, so the accelerometer has many advantages including high sensitivity, high resolution and quick response speed. a binary width - modulated pulse rebalance loop is applied in the accelerometer

    該加速度計引入了新型位置敏感探測psd ,使其具有高的靈敏度、析度和響應速度;同採取了二元調沖加矩方式的再平衡迴路。
分享友人