脈沖尖峰 的英文怎麼說
中文拼音 [màichōngjiānfēng]
脈沖尖峰
英文
pulse spike-
In the sub block circuit design, the contents that the author had introduced include : the principle of band gap voltage reference and the design technique in low power supply ; the analysis of spike pulse noise rejection, frequency divider and dead time in oscillator and control circuit ; the selection of the width and length ratio of four switches and 2x / 1x mode change point in driver and mode selection circuits
在子電路設計中，作者比較深入分析的內容有:基準電路的原理及低電源電壓下基準電路的設計;振蕩器和控制電路中尖峰脈沖噪聲抑制、兩分頻電路及死區時間設定;驅動及模式選擇電路中開關管的寬長比的選擇及模式轉換點的設計。In hardware, we choose anti - disturbance photoelectric isolative sensor, take rc filter to resolve high - frequency for anti - disturbance. in software, we adopt arithmetic of recursion mean value to collective signal values to resolve low - frequency ac and pinnacle pulse disturbance
在硬體方面，選用抗干擾能力強的光電隔離電量傳感器，並採取rc濾波抗干擾措施解決中高頻干擾問題；在軟體方面，對採集到的信號量採取遞推平均值演算法，解決低頻交流和尖峰脈沖干擾問題。Simulations on light intensity are validated by experiments and influence of mechanical dither on gyro frequency stabilization is studied for the first time. then it is point out that the key to improve the precision of frequency stabilization is to choose appropriate modulation frequency based on the frequency spectrum of sharp pulses, which is introduced by mechanical dither. thereafter, experiments of frequency stabilization under different modulation frequencies are made
通過實驗驗證了光強模擬結果，首次分析了機械抖動對穩頻的影響，指出提高機抖陀螺小抖動穩頻精度的關鍵在於：根據機械抖動引入的交流光強尖峰脈沖頻譜分佈選擇合適的調制頻率，並給出了不同調制頻率的穩頻實驗結果。Secondly, considering the need of frequency stabilization, mdrlg ' s light intensity is simulated. the simulations indicate that sharp pulses are produced in the ac light intensity by mechanical dither. as the pulses have a wide frequency spectrum and range over the modulation frequencies of frequency stabilization, mechanical dither may reduce the precision of frequency stabilization
其次，根據穩頻需要對機抖陀螺輸出光強進行了模擬，模擬表明機械抖動會在交流光強中引入尖峰脈沖，且尖峰脈沖頻譜分佈較寬，在小抖動穩頻調制頻率范圍內有功率輸出，因而可能降低穩頻精度。What have made a large amount of harmonic and high electro - magnetic interference ( emi ) has two reasons. the first reason is mainly the hard - switching pwm mode. the switch turns on at high voltage and turns off at high current in a short time ( ns ), which leads to a high du / dt and di / dt and emi
其原因一是由於硬開關的pwm調節方式，電子開關速度很快（ ns數量級）在高電壓下導通，大電流下關斷，導致很高的du dt和di dt ，產生很強的尖峰脈沖，對周圍環境造成電磁干擾。分享友人