脫樹脂 的英文怎麼說

中文拼音 [tuōshùzhī]
脫樹脂 英文
deresination
  • 脫 : Ⅰ動詞1 （脫落） cast; shed; drop; fall off 2 （取下; 除去） take off; strip; cast off 3 （脫離） ...
  • 樹 : Ⅰ名詞1 （木本植物的通稱） tree 2 （姓氏） a surname Ⅱ動詞1 （種植; 栽培） plant; cultivate 2 （樹...
  • 脂 : 名詞1. （動植物所含的油質） fat; grease; tallow 2. （胭脂） rouge 3. （姓氏） a surname
  • 樹脂 : resin; jaffaite; peucine
  1. A detailed introduction was made to the properties of the wet coated sand suitable for multi - station shell mould shooting machine ; the development of a sort of high strength coated sand with low resin content : the shaping index and wetness adjusting process : analysis and prevention of peel back defect of shells made with overturning hopper process ; test method of peel back resistance of coated sand : pinhole defect analysis of high ni ductile iron shell mould castings and application of anti - pinhole coated sand

    詳細介紹適用於吹砂式多工位殼型機的濕態覆膜砂性能；高強度低樹脂量覆膜砂的研製；濕態殼型覆膜砂的成形性指數與調濕工藝；翻鬥法制殼時的脫殼問題分析和解決辦法；覆膜砂脫殼性檢測方法；高鎳球鐵件殼型鑄造表面針孔原因分析與抗針孔覆膜砂的應用。
  2. Relation between the microscopic fracture pro cess of carbon epoxy composite laminates and their fracture toughness

    環氧樹脂復合層板脫層破斷的微觀過程與斷裂韌性的關系
  3. Material and methods normal rats of male sd were divided into young, adult, and aging groups. preparation of samples for light microscopy : animals were anesthetized by peritoneal injection of 6 % chloral hydrate ( 0. 5ml / 100g body weight ). perfusion and fixation of animals were carried out by a common procedure : 37 normal saline 50 - 100 ml and then 4 % paraformaldehyde pbs 100 - 400ml were perfused through the left ventricle of the heart, the whole procedure was lasted for about somin. the entire brain was dissected out and dipped in the fixative solution for 12h at 4. brain pieces targeted were choosen and then passed the graded alcohols for dehydration, dipping into paraffin for embeding, and reshaping the pieces

    2 ）磷酸緩沖液100400m ， 30分鐘灌注完畢，取出整腦，在上述固定劑oc ）內后固定12小時。切取觀察部位腦塊，然後，進行梯度酒精脫水，浸蠟，包埋，修塊，石蠟連續切片（德國leica石蠟切片機人切片厚度still ， zlllll ，蛋自甘油載片撈片， 60c烤箱過夜，二甲苯脫蠟，梯度酒精置換，浸水， h六染色，梯度酒精脫水，二甲苯透明，中性樹脂封片。室溫風干后，顯微鏡觀片， olympus萬能顯微鏡照相。
  4. Study on decoloration of shikimic acid by ion exchange resin

    離子交換樹脂對莽草酸粗提液的脫色研究
  5. Resin was degassed using a vacuum and the winding carried out under vacuum.

    樹脂用真空脫氣，並在真空下進行纏繞。
  6. The raw materihls can be medicine of raw materials, chinese traditional medicine, tablet of drink, immersed electuary, powder, granule, packing bottle, pigment, dyestuff, dehydration vegetable, dried fruit and melons, banger, plastic resin, electric elements, drying varnish and so on

    如原料藥、生藥、中藥飲片、浸膏、粉劑、顆粒、沖劑、水丸、包裝瓶、顏料、染料、脫水蔬菜、瓜果乾、香腸、塑料樹脂、電器原件、烘漆等。
  7. Polybenzoxazine / vermiculite hybrid nanocomposites were prepared from two kinds of polybenzoxazine precursors and two kinds of organically modified - vermiculite minerals and expanded - vermiculite which were consisted of vermiculite, hydrobiotite and phlogopite. after treatment of vermiculite minerals by hexadecyl trimethylam monium bromide ( ctab ), the d001 of vermiculite layers of vermiculite mineral increased from 1. 43nm to 2. 67nm and developed a d002 = 1. 34nm

    本文分析了蛭石精礦和膨脹蛭石的組成和結構，用十六烷基三甲基溴化銨（ ctab ）進行了有機化處理，再通過熔融或溶液混合插層苯並嗯嗪樹脂（ ben ）制備了ben插層蛭石納米復合材料，並採用蒙脫土進行了對照實驗。
  8. Dsc for the nanocomposites showed the glass transition temperature ( tg ) of the nanocomposites increases slightly as the mmt content increases. water absorption velocity and water retentivity under pressure tests showed the addition of montmorillonite ( mmt ) can improve the beginning absorption velocity and water retentivity for pure superabsorbent resin

    吸水速率和加壓保水能力測試表明，一維納米級蒙脫土片層的引入能在一定程度上提高高吸水性樹脂的初期吸水速度和加壓下的保水能力。
  9. The work was composed in five parts : ( 1 ) epoxy resin / org - mmt / diethylenetriamine ( deta ), epoxy resin / org - mmt / imidazole ( mz ) and epoxy resin / org - mmt / tung oil anhydride ( toa ) nanocomposites were prepared by in situ intercalation polymerization

    所研究的內容及其結論主要包括以下五個部分： （ 1 ） xrd測試表明環氧樹脂進入了有機蒙脫土片層內，使蒙脫土層間距增大。
  10. Needy developed pu sole, taking pu as the main raw material and adopting micro porous foaming technology, solves the unglued and broken problems commonly misted in ordinary pu sole

    新研製的聚氨酯鞋底以聚氨酯樹脂為主要原料，採用微孔發泡技術，解決了目前國內普通聚氨酯鞋底容易脫膠、斷底等問題。
  11. The results showed that beginning temperature of sharp lost of weight of wpc was obviously lower than wood, and the temperature of wmc corresponded to wood

    結果發現，木材酚醛樹脂復合材料的急劇失重起始溫度明顯比木材低，而木材蒙脫土復合材料的急劇失重起始溫度與木材相當。
  12. For understanding thermal stabilities of woo - montmorillonite ( mmt ) composite ( wmc ), thermal properties of wood, wood - phenol formaldehyde resin composite ( wpc ) and wmc were analyzed and compared using thermal analysis ( ta )

    摘要為了了解木材蒙脫土復合材料的熱穩定性，本文利用熱分析方法對木材、木材酚醛樹脂復合材料、木材蒙脫土復合材料進行了對比分析。
  13. Granular anhydrous calcium chloride can be used as drying agent for drying nitrogen, oxygen, hydrogen, and sulfur dioxide gases. it also can be used as dehydrating agent in producing alcohol, ester, ether and propylene resin

    無水氯化鈣可用作多用途的乾燥劑脫水劑，如用於氮氣氧氣氫氣氯化氫二氧化硫等氣體的乾燥，在生產醇酯醚和丙烯樹脂時用作脫水劑。
  14. Influence of nano - mmt on the property of epoxy adhesive coating

    納米蒙脫土對環氧樹脂膠黏塗層性能的影響
  15. In addition, it is found that dc electric field weakens the effect of release agent and strengthens the binding strength between epoxy resins and anode in the condition of the existence of release agent. but this effect of electric field is not discovered between epoxy resins and cathode

    另外，本文通過實驗研究還證實：在有脫模劑存在的情況下，固化過程中直流電場的存在會弱化脫模劑的作用進而強化環氧樹脂固化物與金屬正電極間的粘接強度，但直流電場對環氧樹脂固化物與金屬負電極間的粘接強度沒有明顯影響。
  16. Another problem with demineralizers is that small resin particles are often dislodged from the bed and enter the water stream.

    用脫礦質器的另一個問題是，小的樹脂粒常常逸出樹脂床而進入水流。
  17. A single station turntable, vertically - split box horizontally - draw type core machine is suitable for mixed core sand which regard hot - firming resin as bond, can make quality core. and it has the merits or easy operation, high productivity, low labor strength, reliable operation, low energy consumption, low noise etc. it is a ideal lot core making equipment

    單工位、垂直分盒水平脫芯型射芯機，適合熱固性樹脂為粘結劑的芯砂混和料，能獲得高質量的砂芯，並具有操作方便、生產效率高、勞動強度低、運行平穩可靠、耗能低、噪聲小等優點，是理想的熱法制芯設備。
  18. Study on the optical properties of transparent epoxy / clay nanocomposites a new type transparent epoxy based nanocomposites has been prepared by the reaction of alkylammonium exchanged montmorillonite ( amt ) with diglycidyl ether of bisphenol a ( dgeba ) and triethylamine as the curing agent. the morphology of amt in the epoxy matrix was characterized with x - ray diffraction ( xrd ), scanning electron microscopy ( sem ) and transmission electron microscopy ( tem )

    光學透明環氧樹脂粘土納米復合材料光學性能採用十八烷基伯胺鹽、十六烷基三甲基溴化胺處理na基蒙脫土製備出兩種不同的有機土，以三乙胺為固化劑，有機土與雙酚a型環氧樹脂熔融插層聚合后制備出剝離型和插層型兩種結構的環氧樹脂粘土納米復合材料。
  19. Thermosetting resin / org - mmt nanocomposite, including exopy resin / org - mmt and phenolic resin / org - mmt, were prepared by in situ intercalation polymerization, and the intercalation and exfloliation behaviour of them were characterized by x - ray diffraction ( xrd ), dynamic mechanical thermal analysis ( dmta ), and different scanning calorimetry ( dsc )

    採用原位插層聚合法通過澆模固化成型制備了熱固性樹脂蒙脫土納米復合材料，並用xrd ， dmta ， dsc等手段研究了熱固性樹脂與有機蒙脫土的插層與剝離行為，並對固化過程進行了理論預估。
  20. This product fits for recycling resin bonded sand and used sand and it is made of two groups rotors with high rotating speed and scraper with low rotating speed. while working, the rotors with high rotating speed and scraper with low rotating speed will cooperate with each other to strike, cut, extrude and rub the sand to break and make the inert film to fall and to make the sand be recycled after separation by wind

    該系列產品主要用於樹脂砂舊砂的再生，它的工作結構是由兩組高速旋轉的轉子和低速轉動的刮板組成，工作時，高速旋轉的轉子與低速轉動的刮板配合，對砂子施以沖擊剪切積壓和搓擦，使砂粒表面的惰性膜破碎脫落經過風選分離，達到再生目的。
分享友人
分享到 Line

分享到臉書