腈橡膠纖維 的英文怎麼說

中文拼音 [xiàngjiāoxiānwéi]
腈橡膠纖維 英文
nitrile rubber fiber
  • 腈 : 名詞[化學] （含有氰基的有機化合物） nitrile
  • 橡 : 名詞1. （橡樹） oak2. （橡膠樹） rubber tree
  • 膠 : Ⅰ名詞1 （某些具有黏性的物質） glue; gum 2 （橡膠） rubber 3 （姓氏） a surname Ⅱ動詞（用膠粘） st...
  • 纖 : 纖形容詞（細小） fine; minute
  • 維 : Ⅰ動詞1 （連接） tie up; hold together; link 2 （保持; 保全） maintain; safeguard; preserve; keep ...
  • 橡膠 : rubber; vulcanizate
  • 纖維 : fibre; staple; filamentary
  1. Itaconic acid, also named “ methylene succinic acid ”, is important industrial raw material during the production of acrylic fiber, latex, synthetic resin, plastic, rubber, pharmaceutics surfactant, packing material of non - toxic food, herbicide, cleaning media, adhesive and plastic additive etc

    衣康酸，又名「甲叉丁二酸」 ，是生產腈綸等纖維、膠乳，合成樹脂、塑料、橡膠、醫藥、表面活性劑、無毒食品包裝材料、除草劑、除垢劑、粘著劑及塑料助劑等的工業原料。
  2. An excellent adhesive was prepared from bismaleimide ( bmi ), epoxy resin ( e - 51 and tde - 85 ), 4, 4 ' - diaminodiphenyl sulfone ( dds ) in this thesis. the influence of liquid rubber and polymer ether imide ( pei ) on the properties ( especially high - temperature strength and the peeling strength ) were discussed, their different toughening characteristics and mechanisms were discussed. last, the process and effection of heat - resisted structural adhesive were studied by adhesive experiment of synchronizer in automobile. the results of investigation made clear : the adhesive, has good properties, especially heat - resisted properity

    根據材料分子設計的原理，研究了二苯甲烷雙馬來酰亞胺（ bmi ） 4 ， 4 』 ?二胺基二苯基碸（ dds ） e ? 51 tde ? 85組成的環氧膠粘劑體系，研究該體系在作為高溫結構膠粘劑使用時的粘接性能；然後研究了用無規羧基液體丁腈橡膠（ ctbn ? x ）和聚醚酰亞胺（ pei ）分別來增韌該體系的增韌效果；最後通過碳纖維耐磨材料與同步器圓錐環的粘接實驗，研究了耐高溫結構膠粘劑的粘接工藝和使用效果。
  3. The blend of aramid and fiberglass was selected as reinforcement and butyronitile modified phenolic resin was selected as precursor to make high performance reinforced friction - resistance material in relacing of asbestos

    摘要針對摩阻材料無石棉化的發展趨勢，以丁腈橡膠改性酚醛為樹脂基體，芳綸漿粕玻纖混雜為增強體，研製出一種混雜纖維增強摩阻材料。
  4. When change the component of adhesive its shear strength increased from 39. 3 mpa to 53. 5 mpa at room temperature and it have long - term usage at 180 with 25 mpa and can be served at 230 in short period. the addition of liquid rubber resulted in a 300 % increase in the peeling strength. the addition of polymer ether imide led to a 260 % increase in the peeling strength, a 15 % increase in shear strength and a 10 increase in tg ( tg = 195. 54 )

    研究結果表明： bmi dds e ? 51 tde ? 85組成的膠粘劑體系的室溫剪切強度為39 . 3mpa ，當改變環氧樹脂的含量時，剪切強度提高到53 . 5mpa ；用無規羧基液體丁腈橡膠改性環氧樹脂膠粘劑時室溫剝離強度提高3 . 0倍；用聚醚酰亞胺改性環氧樹脂膠粘劑，室溫剪切強度最高可達45 . 2mpa ，剝離強度提高2 . 6倍，玻璃化轉變溫度tg = 195 . 54 ，比未增韌體系提高10以上；碳纖維耐磨材料與同步器圓錐環的粘接實驗結果表明，膠粘劑的使用工藝性能良好，滿足室溫剪切強度30mpa和180剪切強度12 . 5mpa的技術要求。
  5. Electrical properties of short carbon fiber nitrile batadiene rubber scf nbr composites

    短碳纖維增強丁腈橡膠復合材料的電性能研究
分享友人
分享到 Line

分享到臉書