腐蝕試件 的英文怎麼說

中文拼音 [fǔshíshìjiàn]
腐蝕試件 英文
corrosion spool
  • 腐 : Ⅰ名詞（豆腐） bean curdⅡ動詞（腐爛; 變壞） decay Ⅲ形容詞（腐爛） rotten; corroded; putrid
  • 蝕 : Ⅰ動詞1. （損失; 虧耗） lose 2. （腐蝕） erode; corrode Ⅱ名詞（天體現象） eclipse
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 件 : Ⅰ量詞（用於個體事物） piece; article; item Ⅱ名詞1. （指可以一一計算的事物） 2. （文件） letter; correspondence; paper; document
  • 腐蝕 : 1 （通過化學作用使物體逐漸消損破壞） corrode; corrosion; corroding; deep etch; diabrosis; rot; ea...
  1. Based the eag - i etchant, a new etchant was developed, with which the etch pit pattern on ( 110 ), ( 111 ) and ( 100 ) faces of czt crystals can emerge immediately and effectually. this pager investigated relation between the ( 110 ) faces of cutting from crystals conveniently and accurately by laser reflex method. by the surface treatment, the nuclear radiation detector was fabricated with ( 110 ) of czt crystal and strong 241am responsibility was observed

    在改變e _ （ ag ）腐蝕液的配方的基礎上，研製了新的腐蝕液，可方便、快速、有效的顯示czt不同晶面的缺陷蝕坑形貌;研究了利用激光正反射法和自然解理的不同（ 110 ）面之間的關系，方便、快速、準確的進行定向切割晶體的方法;採用生長的czt單晶體自然解理的（ 110 ）面，經過表面處理，試制了探測器元件，對24lam有較強的響應。
  2. The save energy mould pump of the corrosiveness of the ministry of industry such as chemical industry and chlorine alkali, chemical fertilizer, dyestuff, reagent, pesticide, pharmacy, electroplating and environmental protection etc door transport that pf ( fs ) mould chemical industry pump can satisfy to carry many kinds of consistency sulphuric acid, hydrochloric acid, nitric acid, acetic acid, phosphoric acid, chromium acid, oxalic acid, hydrofluoric acid and the lye, organic solvent and oxidizer geometric ratio medium under - 50 s - 80 s temperature conditions and is not han s anything small and roundish medium

    型化工泵能滿足輸送- 50 80溫度條件下的多種濃度硫酸、鹽酸、硝酸、醋酸、磷酸、鉻酸、草酸、氫氟酸和堿液、有機溶劑、氧化劑等化學介質、是化工、氯堿、化肥、染料、試劑、農藥、制藥、電鍍、環保等工業部門輸送不含顆粒的腐蝕性介質的節能型泵。
  3. Aim of this study was to meet the need for development of tribological parts in pumps. at room temperature tribological properties of different sliding pairs of silicon carbide and alumina - based ceramics were tested using a laboratory tribometer in the ring - on - plate geometry under reciprocating sliding linear contact in different media, such as distilled water, aggressive media and air

    本文針對目前泵用摩擦零部件材料發展的需要，在實驗室摩擦磨損試驗機上研究了按環/塊線接觸方式作往復運動條件下的碳化硅和氧化鋁基陶瓷材料摩擦副在水、化學腐蝕性介質作潤滑劑和無潤滑時室溫下的摩擦磨損特性。
  4. Standard practice for measurement of time - of - wetness on surfaces exposed to wetting conditions as in atmospheric corrosion testing

    在大氣腐蝕測試中表面暴露在潮濕條件下濕潤時間的測量
  5. Because of its resistance to electrochemical erosion, low manpower demand for application and minimal changes in geometrical dimensions of the member, the method has been found to be economical and efficient for application, based on the previous work, we designed and conducted experiments of 10 reinforced concrete ( rc ) slabs strengthened with the common carbon fiber reinforced plastic ( cfrp ) ; and investigated the effect, failure mechanism and theory

    由於具有耐腐蝕、施工簡便快捷、幾乎不改變構件原有尺寸等特點，得到廣泛的應用，具有良好的經濟效益。在前人的工作基礎上，我們設計、試驗了10採用碳纖維布加固的鋼筋混凝土單向板，探討了加固單向板的加固效果和理論分析方法。
  6. Preparation of stress - corrosion test specimens for weldments

    焊件的應力腐蝕試樣的制備
  7. Corrosion of metals and alloys - stress corrosion testing - preparation and use of specimens to evaluate weldments

    金屬和合金的腐蝕.應力腐蝕試驗.焊件評定用試樣的制備和使用
  8. Corrosion of metals and alloys - stress corrosion testing - part 8 : preparation and use of specimens to evaluate weldments

    金屬與合金的腐蝕.應力腐蝕試驗.第8部分:評估焊件試樣的制備和使用
  9. Prestressing members. stress corrosion test in distilled water

    預應力構件.蒸餾水中應力腐蝕試驗
  10. Vitreous and porcelain enamels. enamelled articles for service under highly corrosive conditions. high voltage test

    釉瓷和搪瓷.強腐蝕條件下使用的搪瓷器皿.高壓試驗
  11. Aircraft industry. paints and varnishes. stress corrosion test for painted test pieces under a constant load

    航空工業.塗料和清漆.塗漆試件在恆定負載作用下的應力腐蝕試驗
  12. Methods of testing vitreous enamel finishes - high voltage test for enamelled articles for service under highly corrosive conditions

    釉層精整試驗方法.第11部分.高腐蝕條件下設備用搪瓷物質高壓試驗
  13. Vitreous and porcelain enamel - enamelled articles for service under highly corrosive conditions - high voltage test

    用在腐蝕條件下的搪玻璃設備的高電壓試驗方法
  14. Implants for surgery - test solutions and environmental conditions for static and dynamic corrosion tests on implantable materials and medical devices

    外科植入物.可植入物質和醫療裝置的靜態和動態腐蝕試驗用試驗溶液和環境條件
  15. Testing methods for paints - part 7 : determination of resistance to cyclic corrosion conditions - section 9 : salt fog dry humidity

    塗料的試驗方法.第7部分:耐循環腐蝕條件的測定.第9節:鹽霧乾燥潮濕
  16. Methods of test for paint - durability tests on paint films - determination of resistance to cyclic corrosion conditions - wet salt fog dry humidity uv light - part f19 : determination of resistance to cyclic corrosion conditions - wet salt fog dry humidity uv light

    塗料的試驗方法.漆膜的耐久性試驗.耐循環腐蝕條件的確定.濕的
  17. Metallic and other inorganic coatings - genenal rules for corrosion tests applicable for storage conditions

    金屬和其它無機覆蓋層儲存條件下腐蝕試驗的一般規則
  18. Corrosion of metals and alloys - stress corrosion testing - preparation and use of pre - cracked specimens for tests under rising load or rising displacement

    金屬和合金的腐蝕.應力腐蝕試驗.在加大荷載或加大位移條件下試驗用預裂樣品的制備和使用
  19. Corrosion of metals and alloys - stress corrosion testing - preparation and use of pre - cracked specimens for tests under constant load or constant displacement

    金屬和合金的腐蝕.應力腐蝕試驗.恆定負荷或恆定位移條件下試驗用預破裂試樣的制備和使用
  20. Electromechanical components for electronic equipment. basic testing procedures and measuring methods. part 11 : climatic tests. section 7 : test 11g : flowing mixed gas corrosion test. european standard en 60 512 - 11 - 7

    電子設備的電機元件.基本試驗過程和測量方法.第11部分:氣候試驗.第7節:試驗11g :流動混合氣體腐蝕試驗
分享友人
分享到 Line

分享到臉書