膜制備 的英文怎麼說

中文拼音 [mózhìbèi]
膜制備 英文
film preparation
  • 膜 : 名詞1. [生物學] （像薄皮的組織） membrane 2. （像膜的薄皮） film; thin coating
  • 制 : Ⅰ動詞1 （製造） make; manufacture 2 （擬訂; 規定） draw up; establish 3 （用強力約束; 限定; 管束...
  • 備 : Ⅰ動詞1 （具備; 具有） have; be equipped with 2 （準備） prepare; provide with; get ready 3 （防備...
  1. Formation of gan film by ammoniating ga2o3 film on in layer deposited on si substrates

    的鋰離子凝膠膜制備與性能
  2. Preparation and photocatalytic activity studies of anatase - phased tio2 thin films

    銳鈦礦型二氧化鈦薄膜制備及其光催化性能研究
  3. ( 2 ) an aminobenthiazole schiff base has been synthesized as a new fluorescence carrier by reacting 2 - aminobenthiazole with p - allyoxybenzoldohyde. the new kind of schiff base can be utilized for preparing an optical sensor, used for determining furazolidone based on the fluorescence quenching. aminobenthiazole schiff base immobilized on a glass plate surface by covalent bonding can circumvent the leakage of the fluorephore from the sensor surface and guarantee a relatively long working lifetime

    （ 3 ）用強熒光基團2 -氨基苯並蒽酮與對烯丙氧基苯甲醛合成了另一種新的schiff堿類化合物，與甲基丙烯酸羥乙酯、丙烯酰胺、環乙二醇二丙烯酸酯共聚制得光極膜，制備了一種苯並蒽酮schiff堿光化學傳感器，可用於單質碘的測定。
  4. High temperature goggles prepared by using vacuum coating method

    真空鍍膜制備高溫護目鏡
  5. Improvement of respond uniformity of pbs photoconductive film

    光導薄膜制備工藝優化
  6. Preparation of sio2 - tio2 film and study on its photocatalysis activity

    2薄膜制備及其光催化性能研究
  7. Manufacture and anticoagulation properties of polyether urethanes liquid crystalline polymer composite membranes

    復合膜制備及其抗凝血性能
  8. As a excellent material for preparation of biomembrane, cellulose acetate ( ca ) is a fine carrier for the immobilization of cholesterol oxidase ( cod )

    醋酸纖維素（ ca ）作為一種優異的生物傳感用薄膜制備材料，是膽固醇氧化酶（ cod ）優良的固體載體。
  9. We prepare the si - sio2 and ge - sio2 thin film by using the dual ion beam co - sputtering method and the rf co - sputtering technique respectively, adjusting the substrate temperature ( ts ) and the annealing temperature ( ta ). then we analysis the structure of the thin film by using the xrd and tem

    論文採用雙離子束濺射和射頻磁控濺射沉積技術，通過改變薄膜沉積過程中基片溫度（ t _ s ）以及薄膜制備完成後退火溫度（ t _ a ）分別制備了si - sio _ 2和ge - sio _ 2薄膜。
  10. When the two layers of sio2 with different refractive index are finished, the designed mask pattern is printed on the film by photolithography. after that, icp is performed for dry etching, then, the waveguide structures are obtained. at present, the rudimental graph of edg has been obtained

    兩層不同折射率的sio _ 2薄膜制備好之後，經過光刻、等離子體刻蝕（ icp ）的工藝步驟之後，形成了波導結構，初步製作出了器件的圖形。
  11. The response of film to h ~ ion was not disturbed by common

    薄膜對氫離子的響應特性受到薄膜制備條件的影響。
  12. Influence of preparation conditions of nanosized tio2 film on performance of photocatalytic degradation of cokey waste water

    二氧化鈦納米膜制備條件對煉焦廠廢水光催化降解性能的影響
  13. The techniques of preparing film buffer layers on si were studied. the sem, tem and xrd were adopted to study the crystal structure of films. the influences of buffer layers, substrate and heat treatment condition on the crystal structure and performance of the ybco films were discussed

    進一步用掃描電鏡、透射電鏡和x射線衍射儀研究了薄膜組織結構和結晶情況，分析了緩沖層和襯底對ybco薄膜制備的影響、以及不同熱處理條件對薄膜結晶結構及性能的影響。
  14. In this paper, a positively charged composite nanofiltration membrane was developed by using poly ( n, n - dirnethylaminoethyl methacrylate ) ( pdmaema ) as the active layer material and polysulfone ( psf ) macrofiltration membrane as the support layer

    本文以聚甲基丙烯酸二甲氨基乙酯（ pdmaema ）為表層材料，以聚碸（ psf ）微孔濾膜為基膜，制備了荷正電復合納濾膜。
  15. Natural rubber latex concentrate - preparation of dry films

    干膠膜制備
  16. Preparation and pore structure control of carbon membrane

    炭膜制備及其孔結構調控
  17. Application of chelator in strontium titanate as lean - burning oxygen sensors

    螯合劑在氧敏傳感器鈦酸鍶薄膜制備中的應用
  18. Due to great advantage of the excimer laser in photoelectron material, photoelectron technology research, so in this thesis, a xecl excimer laser is designed in order to solve some problem in semiconductor film, cmr film, quartz film and other kind of film application, optical etching field, interaction between laser and material, material plasma study. the parameters of the excimer laser is e also measured and analyzed

    因此本文以氣相沉積、外延生長、巨磁薄膜、金剛石及其它薄膜制備及后續的光刻，激光與物質的相互作用，等離子體研究為目的，研製獲得了激光脈寬18ns ，單脈沖能量150mj ，矩形光斑大小2cm 1cm ，束散角3mrad ，最高重復頻率5hz的xecl準分子激光器。
  19. Study on the materials selection and pore penetration during the preparation of composite membranes for gas separation

    氣體分離復合膜制備中材料匹配和孔滲現象的研究
  20. In order to optimize parameters of sputter - depositeing used to manufacture silicon - based tm films in the next step, the dissertation analyses and explains the difference between the two surfaces of sputtered tini film from sputtering factors

    為優化濺射工藝參數以用於后續的硅基tini薄膜制備，本文從工藝因素入手，對玻璃基濺射薄膜兩個表面的質量差異進行了分析，並給出合理解釋。
分享友人
分享到 Line

分享到臉書