膜強度 的英文怎麼說

中文拼音 [móqiángdù]
膜強度 英文
film strength
  • 膜 : 名詞1. [生物學] （像薄皮的組織） membrane 2. （像膜的薄皮） film; thin coating
  • 強 : 強形容詞（強硬不屈;固執） stubborn; unyielding
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  1. A detailed introduction was made to the properties of the wet coated sand suitable for multi - station shell mould shooting machine ; the development of a sort of high strength coated sand with low resin content : the shaping index and wetness adjusting process : analysis and prevention of peel back defect of shells made with overturning hopper process ; test method of peel back resistance of coated sand : pinhole defect analysis of high ni ductile iron shell mould castings and application of anti - pinhole coated sand

    詳細介紹適用於吹砂式多工位殼型機的濕態覆膜砂性能；高強度低樹脂量覆膜砂的研製；濕態殼型覆膜砂的成形性指數與調濕工藝；翻鬥法制殼時的脫殼問題分析和解決辦法；覆膜砂脫殼性檢測方法；高鎳球鐵件殼型鑄造表面針孔原因分析與抗針孔覆膜砂的應用。
  2. However, for its thin thickness of bound water membrane for the surface of tamped soil particles, its small expulsive force between grains and fast resumption of the strength, tamped soil shows a good thixotropy

    但夯後由于土顆粒表面的結合水膜厚度薄，粒間斥力小，強度恢復較快，因而又表現出較好的觸變性。
  3. The degree of ultrastructural changes of rhabdom during light and dark adaptation of compound eye had something to do with the intensity and wavelength of environmental light in m. nipponense

    線粒體為光感受膜的合成和降解過程提供能量。日本沼蝦復眼感桿束明、暗適應時結構變化程度與外界光強度和光波長度有關。
  4. It was found : 1 ) the film restrained evaporation surface intensity and had obvious function of rising and keeping moisture, 2 ) the drip irrigation could supply water according to growing requirement and augment of water conflux intensity around crop root, it also had strongly controllable operation and wasted fewer water

    覆膜抑制了土壤表面的蒸發面匯，具有明顯的提墑保墑作用，滴灌能隨時根據作物生長需要及作物根系匯流強度的增大而補充匯流源，可控性很強，水的浪費率很低。
  5. Interfacial atoms diffusion or covalence by a circulated - argon ion bombardment process could improve the adhesion strength between the coatings and the uranium substrate

    循環氬離子轟擊鍍方法可促進使膜-基界面原子間的擴散或鍵合，有利於提高膜-基結合強度。
  6. The results showed that the fluorescent intensity of dph decreased and the fluorescent intensity of mc540 increased under sound stimulation, which indicated that the vesicles got looser, the charge density of membrane surface and the plasmalemma hydrophobicity decreased but the membrane fluidity increased

    結果表明，聲波刺激使標記質膜的dph熒光偏振值降低、 mc540熒光強度增加。表明一定強度和頻率的聲波刺激使質膜變的疏鬆，膜表面電荷密度降低，疏水性降低，流動性增加。
  7. It is found that the ca ( no3 ) 2 - po ( oh ) x ( oet ) 3 - x - c2h5oh system with cf3cooh added gives out much gas during heat - treatment which will result in films with many c

    Fha薄膜較純ha薄膜有較好的與基板的結合強度，這得益於兩方面：一方面fha熱膨脹系數較ha小，與
  8. Research on relationship between the texture and fracture strength of high quality freestanding cvd diamond films

    高質量金剛石自支撐膜織構與斷裂強度的關系研究
  9. Series of guowei dry - method composite machines as new product are explored with our many years ' experience, the requirement of the users. the first metal of this machine is adopted with : photo - ecectricity auto. tracking " correcting deviation equipment, magnetic powder tension control. pneumatic back pressure shifting blade, oven temperature controlled qutomatically, big roll with oil heating, coating composite pneumatic control as well as double frequency governor etc. it will make the machine with fast speed, lower voice, low polluted by air, shout consumptionfor energy, stable working etc. especially suitable for al - foil with smooth surface and no enough firming, glass paper, polyester ect. the composite material with hard strength, fireproof, anti - ventilation, anti - fatty, frozen, dudrable steam etc character. it is widely used in food, pharmacy, as well as daily articles to package

    「國偉」 、系列乾式復合機，是我廠根據多年的復合機製造經驗及結合客戶需求，開發的新產品，該機第一基材採用了「光電自動跟蹤」糾偏放卷裝置，磁粉張力控制、氣動背壓移動式刮刀、烘箱溫度分段自動控制、大輥筒導熱油加熱、上膠復合氣動控制及雙變頻調速技術，使該機具有復合速度快、噪聲低、空氣污染小、能耗低、運行平穩等特點，適宜於表面光滑的鋁箔玻璃紙聚酰胺等與聚乙烯、聚丙烯等薄膜的復合，復合薄膜具有強度高、防水、防透氣、防油脂、可冷凍、蒸煮等優點，廣泛應用冷凍食品、乾燥食品、醫藥品及日用品的包裝。
  10. Copper has been deposited on surface of the al mmcs as interlayer by magnetron sputtering, tlp bonding of al mmcs with these interlays, the joints shear strength of tlp bonding using deposited film was as much as the joint shear strength of tlp bonding using cu foil. removing the oxidation on the surface before deposition, copper was coated by magnetron sputtering as tlp bonding interlayer

    待連接表面通過磁控濺射法沉積銅膜作為中間層進行瞬間液相連接，得到的接頭強度與銅箔中間層進行瞬間液相連接得到的接頭強度相當，而使用磁控濺射法去除待連接表面氧化膜后沉積銅膜作為中間層進行瞬間液相連接的接頭強度提高7 . 6左右。
  11. Pellicle tensile strength 186

    薄膜拉張強度：
  12. For enhancing the soakage capability and the combine intension between inorganic films and stainless steel plate, and improving the reactivity of stainless steel, to enhance the combine intension between sca film and stainless steel plate, the stainless steel plates are oxidized. the experiment prepared two oxidized stainless steels in different oxidation degree, aa and ab, respectively used as experiment plates in silver doped tio2 or sio2 antibacterial stainless steel and silver doped sca antibacterial stainless steel

    為提高無機薄膜和不銹鋼基板之間的浸潤性和結合強度，以及為使不銹鋼基板具有更高反應活性，以提高有機硅烷薄膜與不銹鋼基板間的結合能力，對不銹鋼基板進行氧化處理，制備兩種氧化程度不同的不銹鋼： aa和ab ，分別作為摻銀tio _ 2 、 sio _ 2抗菌不銹鋼和摻銀有機硅烷抗菌不銹鋼的基板材料。
  13. The factors which affect the spl : the square measure of diaphragm, the amplitude of vibration, magnetic field intensity, power, impedance, resonant chamber, the pattern and the thickness of diaphragm, and the holes

    音量會影響聲音大小的因素:膜片面積，振幅，磁場強度，功率，阻抗，音腔大小，膜片花紋/厚度，開孔
  14. The strength of flat film made by casting method is only 55mpa, while that of tubular film made by blown - extrusion method is high to 250mpa and is 2. 5 times strength of cellophane

    刮膜法制備的平膜強度較低，而吹膜法制備的管膜強度達250mpa ，是玻璃紙的2 . 5倍，這與分子鏈的取向有關。
  15. Provides the remarkable oil film strength, prevented the coupling slips

    提供卓越的油膜強度，防止離合器打滑。
  16. Film strength ability of a film of lubricants to resist rupture due to load speed and temperature

    油膜強度潤滑油油膜抵抗因負荷、速度和溫度而造成破裂的能力。
  17. For flat films, the cellulose chains are almost unoriented within the plane parallel to the film surface

    另外，刮膜速度、拉伸比和吹脹比對膜強度和超分子結構的影響也很大。
  18. Film srength ability of a film of lubricants to resist rupture rupture due to load, speed and temperature

    油膜強度潤滑油油膜抵抗因負荷、速度和溫度而造成破裂的能力。
  19. Fiber / sulfonated sbs composite membranes were made by way of integrating s - sbs with the glass fiber felts, just in connection with the problems of the brittleness and poor strength of s - sbs membranes

    針對s - sbs膜強度較低和干膜較脆的問題，通過復合玻璃纖維氈制備了纖維復合磺化sbs膜。
  20. The effects of demulsifiers on interfacial tensions and membrane strength were studied for the model and effluence systems from the three - compound - combination flooding field. the interfacial tensions owned by the two - compound - combination system decreased but those owned by the three - compound - combination system increased with increasing the demulsifier concentrations. membrane strength decreased with the increase of demulsifier. the demulsification mechanism of demulsifier is suggested that demulsifier partially replaces the stabilizers and greatly decreases the intensity of interfacial film

    針對模擬采出液和三元復合驅礦場采出液，研究了破乳劑對復合體系界面張力和膜強度的影響.破乳劑濃度增加，二元復合體系界面張力降低，而三元復合體系界面張力升高.破乳劑分子部分頂替乳化劑分子並顯著降低了界面膜強度
分享友人
分享到 Line

分享到臉書