膠團量 的英文怎麼說
中文拼音 [jiāotuánliáng]
膠團量
英文
micelle weight-
A method to calculate quantitatively the adsorption volume or adsorption space of per mass of adsorbent derived from both the adsorbed molecule volume and the maximum adsorbance of a solute in an adsorption isotherm under a given experimential condition is presented firstly for a solid / liquid adsorption system of the solute in a dilute aqueous solution. this method is suitable for not only mono - layer adsorption, but also mani - layer adsorption and micelle adsorpion of surfactant constructed by hydrophile and lipophile groups. therefore, the surface concentration of the adsorbate, cs, deduced from the adsorption volume is possessed of the meaning of true concentration, and the value of the patition coefficient of the adsorbate between solid and liquid phass, p, attained by the cs and the c, solution concentration of the adsorbate, can be accurate. the foregoing a set of calculations are presented for the solid - liquid adsorption systems consisted of the wool fiber and separately dodecyltrimethyl - ammonium bromide ( dtab ) and hexadecyltrimethyl - ammonium bromide ( ctab ) in this paper. this provides a strong basis for adsorption thermodynamic investigation of adsorbate
對稀溶液中溶質的固/液吸附體系，首次提出了根據吸附分子體積和實驗條件下吸附等溫線中的最大吸附量計算單位質量吸附劑的吸附體積或吸附空間的方法.此法適用於單層吸附，也適用於多層吸附和具有親水親油結構的表面活性劑分子的膠團吸附.由此，吸附質的表面相濃度cs具有真實濃度的含義，相應地，計算得到的溶質的固/液分配系數p就有了準確值.分別計算由溴代十二烷基三甲銨（ dtab ）和溴代十六烷基三甲銨（ ctab ）與羊毛纖維構成的液/固體系分配系數等，為溶質吸附的熱力學研究奠定了基礎Our company mainly sells fpc base materials ( indusium, rubber latex and pi doily ), whose quality and technologyis competitive. professional after - sale service staff is organized as well, which provides the clients with complete technique support as a strong backup force for the quality of the products. the products sold by our company has, in a short term, been accepted and appreciated by its famous counterparts
公司主要銷售fpc基材（覆蓋膜、純膠膜、 pi補強片） ，公司產品品質優異，技術力量雄厚，並配有專業的售後服務團隊；將為您提供完善的技術支持，是您品質保證的強有力後盾，公司所銷售的產品在短時間內得到了業界知名企業的認可與贊同。Ajs20, the precursor contained 20wt % alunina sol seeding, was calcined at around 1000 to get free - aggregation nano - sized a - alaos powders with a median particle size of 70nm. and, calcining ajs2, the precursor contained 2wt % alumina sol seeding, at hoo ' c, we get a - alaos nano - sized powders with a particle size of loonm and good dispersion by tem. this paper also gives the proper mechanisms of these factors " influences on the transformation to alpha phase
研究結果顯示，含有20wt膠體籽晶的前驅體ajs20在1000左右煅燒就可獲得平均粒徑為70nm 、無團聚的納米- al _ 2o _ 3粉體；而含有2wt膠體籽晶的前驅體ajs2在1100即可獲得粒徑在100nm左右、幾乎單顆粒分散、有少量「樹枝狀」微結構的納米- al _ 2o _ 3粉體。By using dta, ir and xrd analysis, the result show that : in the gel glass of these two system, the phase change of the zirconia and the alumina are restricted because of the high content of silica which leads to the stabilization of the prepared materials. and the applications of these two materials is introduced briefly. by using absorption spetrum and fluorescence spetra analysis, the result show that : in the gel glass of the nd - doped sio2 - al2o3 gel bulk glass - ceramic, the strongest emmision is at about 1. 06u m, the clustering of nd3 + ion is controlled by the addition of alumina which creates the " cage effect " to nd3 + ion
同時分別對凝膠進行了dta 、 ir 、 xrd分析，結果表明：對於此兩個系統的凝膠玻璃-陶瓷，由於二氧化硅含量較高，使得氧化鋯及氧化鋁的相變受到約束，從而保證所制備材料的穩定化，同時對兩種材料的應用也作了簡單介紹；對摻釹sio _ 2 - al _ 2o _ 3激光玻璃-陶瓷進行了熒光及吸收光譜分析，結果表明：釹鋁共摻雜二氧化硅玻璃的最強發射處於1 . 06 m左右，加入的少量氧化鋁使釹離子產生「籠效應」 ，阻止釹的團聚。The nanometer tin dioxide powder aspects were prepared with the colloid - hydrothermal system which takes the merit of sol - gel law and hydrothermal method, and combine forming new preparing method - colloid - hydrothermal after the analysis of a large number of documents to the home and abroad and comparing to more than ten kinds of methods preparing the nanometer powder aspect, the nanometer stannic dioxide powder is prepared with the colloid hydrothermal system, and has avoided the pure sol - gel law to calcine with high temperature later period which causes the hard agglomeration
本文通過對國內外大量文獻的分析，對制備納米粉體的十多種方法進行了比較。取溶膠?凝膠法和水熱法各自的優點，結合形成新的制備方法? ?膠體水熱法。用膠體水熱法制備納米二氧化錫粉體，避免了純溶膠?凝膠法後期用高溫煅燒得到二氧化錫超細粉體時產生的硬團聚現象。The metals transported in the various forms by the above processes can be co - consolidated with carbonate precipitation in the top soil, can easily be extracted by ho ac. the structure, weight and mineral constituents of loess change with varies on concentration of ho ac : the boundary between the grain become unclear after different gradually, but when hoac > 3 %, the weight change become smaller. also with increasing of ho ac concentration, the carbonates in loess decreases gradually, while hoac > 3 %, the change become smaller
不同濃度醋酸提取，黃土的結構、重量和礦物組成發生不同變化：黃土團粒界限變得模糊並出現孔洞，可能說明次生碳酸鹽在黃土中主要成膠結物存在；隨醋酸濃度增高，黃土重量逐漸降低，但當醋酸濃度大於3后，重量變化明顯變小；黃土中碳酸鹽礦物含量逐漸降低，當醋酸濃度3后，變化范圍明顯變小。The studies expressed that the tensile - strength declined with the growth of dose rate after the radiation treatment, and at the same time, the gel content had extreme value with the change of the dose rate. the surface of uhmwpe fibers showed some irregular micro - pits and dents after radiation treatment, narnely rough degree increasing. their number and deepness increased with increase of dose. and this phenomenon is the most obvious when the dose rate was 8. 5kgy / s and the dose was 400kgy. at the same time some containing oxygen groups, including hydroxyl group, carbonyl group and carboxyl group, were introduced into the fiber surface which was exposed to the air
研究表明， uhmwpe纖維經電子束輻照處理后，纖維的拉伸斷裂強度隨劑量率的增加呈下降趨勢，凝膠含量隨著劑量率的變化存在極值。纖維表面出現了不規則的微裂紋和凹痕，隨著劑量的增大，電子束對纖維表面的刻蝕程度增加，在本研究中以劑量為400kgy劑量率為8 . 5kgy s時刻蝕效應最為明顯。同時，在空氣中進行輻照時，纖維表面被引入了一些含氧基團，包括羥基、羰基和羧基。Heading manufacturing operations in shanghai, walters china team has experience in core manufacturing processes such as plastic injection, rubber compression molding, metal stampings, die - casting, sand casting, and lost wax casting. he handles our labor intensive, high volume projects
其在上海帶領著具有多年生產經驗的團隊如塑膠射出橡膠壓模金屬沖壓金屬壓鑄沙壓鑄脫臘壓鑄其管理titoma勞力密集與高數量之專案。The dispersion of mmt and the properties of composites were basically determined by the nature of organo - mmt and the polarity of the polymer chains. the intercalated nanocomposites could be explained in terms of the formation of " ladder " structure due to the excessive polar groups on the polymer chains which adhere adjacent silicate sheets
插層高分子鏈的極性基團含量要適宜；否則，極性基團將相鄰片層「膠粘」形成穩定的「梯形」結構，導致高分子鏈插層受阻，易形成插層型納米復合材料。The study of phase formation of the polycrystalline la1 - xagxmno a series of polycrystalline la1 - xagxmno3 samples with x range nominally from 0. 05 to 0. 45 were investigated, and found that the critical phase temperature has close relation with the content of silver in the sample. and pointed out in the case of agl + doped in lamno3, when x achieved a fixed value ( x = 0. 15 ), ag would separate out, ag - rich phase appeared, samples became compound phase
並且當銀含量達到一定程度時會有單質銀析出，我們認為這是因為銀離子在溶膠?凝膠的過程中被還原成單質，以銀團簇的形態存在於樣品中，隨著燒結溫度的提高，銀原子逐漸被氧化成銀離子，取代la ~ （ 3 + ） ，進入晶格，形成鈣鈦礦結構。Economy ? series of guar gums are absorbed very rapidly on the cellulose fibres owing to their structural similarity with cellulose and in addition they carry a large number of hydroxyl groups, suitable for the formation of hydrogen bonds
這里的瓜爾膠系列產品都能很快地被纖維細胞所吸收，是由於它們的細胞結構和纖維細胞非常相像，其次它們帶有大量的羥基團適合氫鍵的形成。Silicon dioxide spherical particles are widely used in many fields of advanced technology, such as photonic crystals, catalyst supports, chromatographic packing materials and standard materials in measurement etc. in this article, micrometer sio2 spherical particles were synthesized by polymerization - induced colloid aggregation process
由於二氧化硅球形顆粒在光子晶體、催化劑載體、色譜填料、標準計量等許多高新技術領域有著非常廣泛的應用前景。本文用聚合誘導膠體團聚法制備介孔二氧化硅球形顆粒，並對其形成機理及制備條件進行了詳細研究。The erc composite was also prepared via solution mixing with clay pre - treated by onium ions having epoxy and hydroxyl groups. the structure and mechanical properties of the composites prepared via different preparation process was investigated. results demonstrated that the reaction between onium ions and ct
結果顯示，引入反應性官能團有利於粘土與橡膠相結合，對橡膠ep的相分離有促進作用，但由於橡膠相模量增加，其增韌效果有所下降。分享友人