膠層 的英文怎麼說

中文拼音 [jiāocéng]
膠層 英文
grès; substratum; bond line; glue line
  • 膠 : Ⅰ名詞1 （某些具有黏性的物質） glue; gum 2 （橡膠） rubber 3 （姓氏） a surname Ⅱ動詞（用膠粘） st...
  • 層 : i 量詞1 （用於重疊、積累的東西 如樓層、階層、地層） storey; tier; stratum 2 （用於可以分項分步的...
  1. Two cell layers ( diploblastic ) separated by a gelatinous mesoglea

    兩層細胞（兩胚層） ，中間是凝膠狀的中膠層。
  2. Medium experiments were arranged under uniform design, and then an optimum medium was got accordingly. the culture liquid was centrifugalized at 3, 500r / min for 30min, then ammonium sulfate was added into the supernatant to a final concentration of 30 % to precipitate the others

    通過硫酸銨分級沉澱、 deaesephadexa - 50陰離子交換凝膠層析和sephadexg - 75凝膠柱層析對發酵液進行分離和純化，並得到電泳純的酶。
  3. The bsa rejection increases as / decreases. the hydrophilicity of the surface of pvdf hollow - fiber membranes has been greatly improved and the antifouling ability increased obviously

    Pvdf基膜表面引入pamps長鏈分子或者pamps凝膠層，親水性大為改善，抗污染能力明顯提高。
  4. By digitization, we optimize the intensity data of the incidence beam at the vicinity of start point and end point. 3

    通過選擇合適的塗膠參數，在凹透鏡表面上進行了薄光刻膠膠層的均勻塗布。
  5. The development in the adhesion between the polymer cords such as rayon, nylon, polyester, and aramid, to rubbers were reviewed from aspects of adhesion test and analysis, fiber and adhesives interface, dipped cord and rubber interface and the mechanical properties of resorcinol formaldehyde latex adhesives

    摘要從測試與分析方法、纖維與粘合劑的界面粘合、浸膠簾線與橡膠的粘合、間苯二酚甲醛膠乳浸膠層的物理機械性能等方面總結了人造絲、尼龍、聚酯和芳香聚酰胺等聚合物簾線與橡膠的粘合方法及最新進展。
  6. This material was loaded onto a silica gel column and the column was eluted with chloroform several times until the fraction of interest was collected. finally we obtained some light yellow green ointment liquid f i

    採用硅膠作干層析柱填充物，用氯仿作展開劑和洗脫液，反復硅膠層析，對柄海鞘鞘囊氯仿浸提物進行分離、提取與純化，最後得到一淺黃綠色的油狀液體fraction （以下均稱f ） 。
  7. A coating, as of syrup, applied to food

    凍膠層澆在食物表面的覆蓋物（如糖漿）
  8. Rubber hoses - determination of abrasion resistance of the outer cover

    橡膠軟管外膠層耐磨耗性能的測定
  9. Internal and external rubber layer

    內外膠層
  10. Laminated wood plastics. compreg determination of glueline shear strength parallel to grain

    木質層積塑料.順紋膠層剪切強度的測定
  11. It is shown that the thickness of plct ( x ) is non - linear increased with increase of layers

    發現plct x ）薄膜的厚度隨著甩膠層數的增加而呈非線性的增加。
  12. Construction : it is composed of a inner rubber layer, innerrubber protectionlayer, middle rubber layer, steel wire spirallayerand ext - ernal rubber cover

    結構：由內膠層、內膠保護層、中膠層、鋼絲纏繞層和外膠層組成。
  13. After the length of the gap increasing to a certain value the load bearing ability and actual shear strength intends to decrease

    研究中還發現間隙所處的位置對接頭的抗剪強度有較大的影響，膠層端部預留間隙使接頭的承載能力和實際強度均顯著下降。
  14. Antiflaming and antistatic high pressure wire spiral rubber hose is consist of an inner, a protectionlayer, middle layer, wire reinforcement layer, and a rubber cover

    阻燃抗靜電高壓鋼絲纏繞膠管結構是由內膠層、內膠保護層、中膠層、鋼絲纏繞層和外膠層組成。
  15. An analytical model was developed using the first - order laminated anisotropic plate theory to determine the stress and strain distributions within frp and steel pipe joint under combined torsional and tensile loading. taking advantage of the axisym metric nature of torsional and tensile loads about the pipe centralaxis, the equilibrium equations for the three - components joint system consisting of coupling, adhesive and pipe were setup based on the displace mentrelation

    通過對各種膠接接頭形式的分析，針對玻璃鋼管與鋼管及鋼管件在實際應用中的具體情況，選擇應用內、外增強型對接接頭進行玻璃鋼管與鋼管（件）的膠接連接，並建立了一種玻璃鋼管與鋼管（件）膠接管接頭在拉伸和扭轉載荷作用下膠層內應力分析模型。
  16. The plastic qian bing of clamp of a kind of tool, what narrate plastic qian bing to be able to cover the part holding a power of park tool clamp, among them, the integral structure of plastic qian bing wraps synthesis by sub of one horniness model and photograph of sub of one soft qualitative model model, form in its whole structure have one with grasp can cover firm between the handle those who close wear a ministry, its feature depends on : sub of this horniness model is one by on, lower mould shapes directly, in its two side surround motherboard form have wear the side that cover a ministry, the mouth office that equips a ministry in its is formed have wear the side that cover a mouth, and empty section structure is shown to appear empty coping completely in its coping ; narrates weak qualitative plastic data is filled set in aforementioned to wear the side that cover a ministry, wear the side that cover a mouth and top between fully empty section, form soft wrap cladding plasticly character, shape wear the structure that cover a ministry

    一種工具鉗的塑膠鉗柄，所述塑膠鉗柄可套置於工具鉗的握柄處，其中，塑膠鉗柄的整體結構由一硬質塑膠層以及一軟質塑膠層相包合成型，並在其整體結構中形成有一與握柄間可穩固套合的穿套部，其特徵在於：該硬質塑膠層為一由上、下模直接成型、在其底板兩側邊圍形成有穿套部側邊，在其穿套部的開口處形成有穿套口側邊，以及在其頂部為一完全透空的頂部透空區段結構；所述的軟質塑膠材料填設在前述的穿套部側邊、穿套口側邊以及頂部透空區段間，構成軟質塑膠的包覆層，並成型穿套部結構。
  17. Study on fatigue damage of a laminated rubber composite

    橡膠層合復合材料的疲勞損傷
  18. This is cotton fabrics coated of coloured rubber layer with thin, light, elastic characteristics to be specifically remade for tourist rain coats and super working suits

    採用全棉色布、單面覆有彩色橡膠層、膠布輕薄彈性好，專供出口製作旅遊雨衣或防水工作服。
  19. The results showed that the creep coefficients in cfrp - confined concrete columns and in epoxy - coated concrete columns are almost same, both are less than that in plain concrete columns on the same other conditions but surface treatment, which demonstrates that the creep reduction in cfrp - confined concrete columns is due to the existence of epoxy coating not of cfrp sheet. furthermore, the physical apperence and dimension have litter effect on the creep behavior of cfrp - confined and epoxy - coated concrete columns

    結果表明:其他條件相同時， cfrp約束混凝土柱與塗膠混凝土柱的徐變基本一致，比素混凝土柱徐變小29 . 0 %和26 . 9 % 。 cfrp約束混凝土柱的徐變減小是由於粘貼cfrp布時的膠層所致而非核心混凝土的約束效應。 cfrp約束或表面塗膠的混凝土柱的外形、尺寸及體表比對其徐變的影響很小。
  20. An active metabolite was obtained by purification with precipitated by ethanol, sephadex g - 25 gel, deae - cellulose ion exchange resin and silica gel column chromatography

    經乙醇（ 95 ）沉澱、 sephadexg - 25凝膠層析、 deae -纖維素離子交換層析和硅膠層析純化，得到抑制黑麴黴生長的單一組分。
分享友人
分享到 Line

分享到臉書