膠粘的 的英文怎麼說

中文拼音 [jiāoniánde]
膠粘的 英文
adhesive
  • 膠 : Ⅰ名詞1 （某些具有黏性的物質） glue; gum 2 （橡膠） rubber 3 （姓氏） a surname Ⅱ動詞（用膠粘） st...
  • 粘 : 粘動詞（粘附） glue; stick; paste; adhere to; bond
  • 的 : 4次方是 The fourth power of 2 is direction
  1. As the rubber droplets lose the acetone solvent, they become tacky and agglomerate.

    當橡膠滴失去丙酮溶液后，變成粘的，聚集態的。
  2. Standard specification for adhesive for acoustical materials

    聲學材料用膠粘劑的標準規范
  3. They are not widely used on their own as they tend to severely affect coating and glue adhesion.

    但由於嚴重地影響塗料和膠料的粘結作用，所以一般不單獨使用。
  4. Haodin mass - produce high - quality and environmental protective veneer, which contains low formaldehyde by using low - formaldehyde agglutinant, and keeps the original agglutinate strength, both having decorating effect and environmental protection

    豪鼎大量生產優質環保貼面板，環保貼面板是指在一般貼面板的基礎上採用低甲醛膠粘劑，降低其甲醛含量。
  5. Standard test method for amylaceous matter in adhesives

    膠粘劑中澱粉物質的標準試驗方法
  6. The research results show that, from the viewpoint of second phase morphologies, there exist quite differences between the grain - type materials ( such as wc / bcu brazing deposit material, wrs1000 and 1zt tungsten carbide strengthening overlaying material, as well as the wear - resistant material of polymer adhesive coating etc. ), and the aggregation - type as well as dispersion - type ones ( such as zg35simn, wrd - 1 and khc - k2 depositing material ) in the wear - resistance and sand slurry abrasion mechanism. the sand slurry abrasion mechanisms are brought forward, of new wear - resistant materials with the features of grain - type second phase morphologies

    研究發現，與聚合型、彌散型第二相的材料（如zg35simn 、 wrd ? 1和khc ? k2熔敷材料等）相比，顆粒型第二相的材料（如wc bcu釬焊熔敷耐磨材料、 wrs1000型耐磨材料、 1zt碳化鎢顆粒增強熔敷材料及ktc ? 1耐磨膠粘塗層材料等）在耐磨性能和磨損機理等方面均有不同，總結提出了以「顆粒型第二相」為特徵的耐磨新材料泥沙磨損機理。
  7. Paper and board. characteristics of body paper for gummed paper and adhesive kraftpaper

    紙和紙板.膠粘紙和膠粘牛皮紙用原紙的特性
  8. The juncture of between two boards of the flume box was agglomerated ( ) with stickiness first. then the top and the bottom board of the box were tighten with bolts

    水槽式加熱器箱體兩板間的連接首先用粘補膠粘接，然後在箱體的四周用螺絲連接，確保機械強度和密封性能。
  9. Rather, mucus tends to occur as ropy strands of secretion exuded from the mural bronchial mucus glands.

    說得更恰當一點，粘液是壁狀支氣管粘液腺滲出的分泌物，呈膠粘體存在。
  10. Study on calcium sulphate whisker - modified epoxy resin adhesive

    硫酸鈣晶須改性環氧膠粘劑的研究
  11. Many methods are used to improve properties and performance of emulsion adhesives, including changing proportion of monomers or initiator system, improving emulsion polymerization, mixing or chemical combination with other polymers

    討論了通過改變單體組成或引發體系、改進聚合工藝、通過共混或化學結合引人其他聚合物的方式改進乳液型膠粘劑性能的方法。
  12. The incorporation of preservative components in the adhesive is virtually the only relistic method for treating chipboard.

    把這種防腐劑化合物混合到膠粘劑中對于處理碎料板是唯一有效的實用方法。
  13. Study on ternary graft modification chloroprene rubber adhesive

    三元接枝改性氯丁橡膠膠粘劑的研究
  14. Preparation of adhesive of three - units graft copolymerization of cr mma sbs

    三元接枝共聚膠粘劑的研製
  15. Study on a water - based adhesive system of corn starch synthetic rubber latex isocyanate

    多異氰酸酯膠粘劑的研究
  16. Glued laminated timber - delamination test of glue lines

    膠合板.膠粘層的剝離試驗
  17. In this paper, the viscosity changes of hydroxy ethyl cellulose sol caused by a kind of mixed salt were studied, which provided valuable basic data and an adapting equation for its practical application

    摘要研究了一種混合鹽的存在使羥乙基纖維素溶膠粘度變化的情況，為其實際應用提供了有價值的基礎數據和擬合公式。
  18. Using redox initiation, a kind of room - temperature fast curing two - component adhesive was prepared with expoxy arcylate, other active monomers and additives

    採用氧化還原的引發方式，用環氧丙烯酸酯及其它活性單體和添加劑制備出一種室溫快固型雙組分膠粘劑。
  19. Bonded wood joints - terms and definitions

    膠粘的木製品接頭.術語和定義
  20. Sticky and viscous

    粘性的；膠粘的
分享友人
分享到 Line

分享到臉書