膠體當量 的英文怎麼說
中文拼音 [jiāotǐdāngliáng]
膠體當量
英文
colloid equivalent-
3 flexible liposome constituted with pc + dona were exhibited under transmission electron microscopy. 4 pfg - nmr analysis indicated that the use of 25 : 1 of tween - 20 : ( - ) c, most of it ( > 90 % ) has been incorporated in the tween - 20 micelle structures
4 、以pnnmr分析了膠束體帥）結構對卜幾類物質的荷載量，發現當t een一20使用量為兒茶素卜）的50倍時，絕大部分卜） c （ 90以上）己嵌禾在tween 20形成的膠束體（ 。Tensile properties and impact properties measurements were done at room temperature. the volume resistivity of rectangular samples was measured using a zc36 electrometer and a high 240a voltage supply, for samples with a low resistivity level a dt - 9205b digital multimeter was used, silver paint was applied to ensure complete contact between sample and electrodes, namely, to eliminate the contact resistance. the phase morphology of blends was also studied using a jeol jsm - 5900lv scanning electron microscope ( sem )
體積電阻率的測定：當r _ v 10 ~ 8時，製成100 100 4mm板材，用zc36型高阻儀測量；當r _ v 10 ~ 8時，用dt - 9205b型數字式萬用表測試試樣的體積電阻，為了減小接觸電阻對測試的影響，採用銀導電膠將銅片粘接在試樣的兩個端面上，靜置24小時，待銀導電膠凝固，試謝長瓊:熱拉仲對pet / pe / cb復合導電體系形態和性能的影響樣的電阻穩定后再測量。The amino acid composition of collagen is very special, including 30 percent glycin, and 25 percent of praline and hydroxyproline
膠原占健康人體蛋白質總量的25 % 30 % ，相當于體重的6 % ，是人體內含量最多的蛋白質。Inorganic anti - cracking reinforced chemical additive, called wj, generates some tittle expansive crystals in hydration process in concrete to reduce the porosity and improve the distribution of pore size. the expansive power is process in common to tumefaction that petty crystalloid aft suck water and pressure to concrete pores that aft crystal gather volume. its adding weight was 8 % - - 12 % in cement, its restrained expansive ratio was about 0. 02 % - - 0. 06 %, and relevantil brought self - stress 0. 2mpa ?. 6mpa
無機增強抗裂材料wj摻入普通混凝土中，在水化硬化過程中生成一定量的微膨脹結晶體，降低空隙率，改善混凝土中孔結構分佈。其膨脹驅動力是凝膠尺寸的晶體鈣礬石吸水腫脹和結晶狀鈣礬石對孔隙產生膨脹壓的共同作用。當wj摻量為8一12兒在鋼筋和鄰位的限制下，使混凝土產生019. adjustable cement plate generally, the cement plate on an automatic toe cementing lasting machine is usually fixed and stable. the structure of being adjustable quite fits the production for different shoes mixing on the same production line. without any tool, the plate can be easily and quickly adjusted to have an appropriate cementing position for different sizes of shoes, which will produce perfect cementing effect and will not have to change plate for making different sizes of shoes
一般使用自動上膠之前幫機膠盤均為固定式，不可任意調整，本機膠盤大小可調整結構為適應大小號鞋子于生產線上，同時混合生產時，不需要運用工具而可簡單快速的調整膠盤的大小寬度以使膠著貼能隨大小號鞋子塗在適當位置，使黏著效果更為完美，而同一型體之鞋子也不必因量多而更換膠盤。The sol - gel method and solid - state thermal reaction technique were used to prepare the composite oxides with variable lithium content. the doping treatments of some compounds were conducted. dta and tg were used to analyse synthesis mechanism, xrd to analyse phase composition, sem to observe morphology, li - b / licl - kcl / oxide simulated thermal cells to analyse the lithium - intercalation mechanism and properties of cathode material
實驗中採用溶膠?凝膠工藝和固相熱反應技術制取相應的不同鋰含量的復合氧化物，並嘗試對某些化合物進行適當的摻雜處理，應用dta和tg分析合成機制、 xrd分析所得物的物相組成、 sem觀察其形貌，模擬li - b / licl - kcl /氧化物的單體熱電池來分析陰極材料的嵌鋰機制及其電極性質。The influence of preparing conditions on aluminum titanate composing was inquired. by analyzing element content of alumina and titania source, arranging a stoichiometric dosage, and keeping the chemical homogeneity from sol to mixed ti - al oxide precursor, a high activity powder was prepared. after calcining the precursor powder at 1250 for 2h, aluminum titanate phase is formed
本試驗通過準確測定起始物的ti 、 al含量，嚴格化學配比，採取適當措施將微尺度上的組成均勻性從溶膠一直保持到混合鋁鈦氧化物前驅體的生成，使該粉體具有高活性，將其在1250煅燒2h ，已合成出以鈦酸鋁為主晶相的產物，比文獻報道的鈦酸鋁相的最低生成溫度降低了50 。Results show that self - crosslinkable latex at room temperature with high elasticity can be prepared when amount of butyl acrylate is 60 %, and amount of methyl methacrylate is 40 %, and mass ratio of nonionic emulsifier to anionic emulsifer is 3 : 1, and amount of initiator is 0. 6 %, and amount of self - crosslinkable monomer and protective colloid is 2 % and 0. 4 % respectively
研究結果表明：當丙烯酸丁酯的質量為60 % ，甲基丙烯酸甲酯的質量為40 % ，非離子乳化劑和陰離子乳化劑的質量配比為3 : 1 ，引發劑的質量為0 . 6 % ，自交聯單體的質量為2 % ，保護膠體的質量為0 . 4 %時，可以制備出高彈性自交聯乳液。Moa is kind of necessary over - voltage protector for safety running in electrical power system, it ' s used for prevent the equipment against the damage of atmosphere and operating over - voltage without gaps is belong to the third dynasty product, it ' s recognized as the up - to - data over - voltage protector, this kind of product is made up of zinc oxide films and polymer housing for example sr, epdm, hdpe it has features of small volume, simple structure, light height, pololution - prool and non - detonation and is suitable to be usde in the densely populated city
避雷器是電力系統安全運行不可缺少的過電壓保護產品，用以保護電器設備免遭大氧過電壓和操作過電壓的損害，而復合外套無間隙氧化鋅避雷器是屬于避雷器第三產品，是當今各項性能最好的產品，其核心元件電阻片全部採用氧化鋅閥片，而外殼材料是採用復合有機材料，如硅橡膠（ sr ） ，改性三元乙丙橡膠（ epdm ）高密度聚乙烯（ hdpe ）等，它具有體積小，結構簡單，重量輕，耐污積強，防爆等優點，最適合人口密度城市中使用。When change the component of adhesive its shear strength increased from 39. 3 mpa to 53. 5 mpa at room temperature and it have long - term usage at 180 with 25 mpa and can be served at 230 in short period. the addition of liquid rubber resulted in a 300 % increase in the peeling strength. the addition of polymer ether imide led to a 260 % increase in the peeling strength, a 15 % increase in shear strength and a 10 increase in tg ( tg = 195. 54 )
研究結果表明： bmi dds e ? 51 tde ? 85組成的膠粘劑體系的室溫剪切強度為39 . 3mpa ，當改變環氧樹脂的含量時，剪切強度提高到53 . 5mpa ；用無規羧基液體丁腈橡膠改性環氧樹脂膠粘劑時室溫剝離強度提高3 . 0倍；用聚醚酰亞胺改性環氧樹脂膠粘劑，室溫剪切強度最高可達45 . 2mpa ，剝離強度提高2 . 6倍，玻璃化轉變溫度tg = 195 . 54 ，比未增韌體系提高10以上；碳纖維耐磨材料與同步器圓錐環的粘接實驗結果表明，膠粘劑的使用工藝性能良好，滿足室溫剪切強度30mpa和180剪切強度12 . 5mpa的技術要求。The oxygen sensing properties of the membranes have been studied, the results indicate that the membranes with ru ( phen ) 3cl2 have better oxygen - sensitivity than those with ru ( bpy ) 3cl2, and the membranes with the formamide content of 16 % ( v / v ) and ru ( phen ) 3cl2 content of 2. 10g / l in the precursor mixture have the best structure and quality. the fiber optic gas oxygen sensor with this sensing membrane has a detection limit of 5ppm, a response time of less than 30s, excellent reproducibility and stability. ( 2 ) a new kind of organically modified oxygen - sensitive membrane based on fluorescence quenching was prepared by sol - gel method, using dds and teos as the mixed precursor, rufchenbcla as the indicator
實驗證明：該類敏感膜的tan _ 0 tan值與氧氣濃度存在良好的線性關系；包埋ru （ phen ） _ 3cl _ 2的凝膠膜的氧敏感性相對較好；當甲酰胺為16體積比含量， ru （ phen ） _ 3cl _ 2在前驅體中濃度為2 . 10g l時，制備的敏感膜結構和性能最佳；對氣態氧檢測時，該敏感膜的響應時間小於30秒，檢測下限為5ppm ，具有較好的重復性和穩定性。分享友人