苯胺試驗 的英文怎麼說

中文拼音 [běnànshìyàn]
苯胺試驗 英文
aniline test
  • : 名詞[化學] amine (氨 nh3 分子中部分或全部氫原子被烴基取代而成的有機化合物)
  • : 名詞(古代占卜用的器具) astrolabe
  • : 動詞1. (察看; 查考) examine; check; test 2. (產生預期的效果) prove effective; produce the expected result
  • 試驗 : trial; experiment; test
  1. Standard guide for microcrystal testing in the forensic analysis of methamphetamine and amphetamine

    甲基異丙法醫檢定法中微晶體的標準指南
  2. In adding - acid system : the resistivities of different lithotypes " cp tend towards being constant and equal when weight percentage of aniline exceeds 50 % ; because of the structure difference of different lithotypes, the polymerizing places and processes are different ; the resistivities of vituain / pan and fusain / pan reach the lowest point respectively when ( ntloisiog / an is 0. 6, 1. 0 ; the resistivities of cp decline fast and tend towards being constant along with the reduction of diameter of coal. in not adding - acid system : the resistivities of different lithotypes ' cp decline evenly ; it is found on the crossed experiment of cp, that ( nflsaog / an mole proportion is the most important factor to influence output ratio of cp and the weight percentage of aniline is the most important factor to influence resistivities of cp. according to the result of the crossed experiment of cp

    在有外加酸體系中:百分含量大於50時,不同煤巖組分的電阻率趨于恆定和一致;由於不同煤巖組分結構上的差異,導致聚合場所和聚合過程的不同;當過硫酸銨/摩爾比為0 . 6 , 1 . 0時,鏡煤-聚導電材料電阻率和絲炭-聚導電材料的電阻率分別達到最低值;在無外加酸體系中:不同煤巖組分/聚導電材料的電阻率隨著聚合時間的增加而均勻下降,並在8小時左右達到恆定;在對絲炭-聚導電材料進行的正交中發現:過硫酸銨/摩爾比對產率的影響最大,重量百分比對產率影響最小,而對產物電阻率影響最大的是重量百分比。
  3. Aromatic hydrocarbons. testing methods for solvent naphthas. determination of " aniline point in mixtures "

    芳香烴.溶劑石腦油的方法.混合物點的測定
  4. Standard test methods for aniline point and mixed aniline point of petroleum products and hydrocarbon solvents

    石油產品和烴類溶劑點和混合點的標準方法
  5. Aniline point and mixed aniline point of petroleum products and hydrocarbon solvents, method of test for 05. 01, 06. 04, 10. 03

    石油產品和烴類溶劑的混合點和點的方法
  6. Methods of test for petroleum and its products - petroleum products and hydrocarbon solvents - determination of aniline point and mixed aniline point

    石油及其產品的方法.石油產品和烴類溶劑.點和混合點的測定
  7. Standard test method for p - phenylenediamine antidegradants - purity by high performance liquid chromatography

    使用高效液相色譜的p -抗降解劑純度的標準方法
  8. Rubber compounding ingredients. protection agent, paraphenylenediamine type. test methods

    橡膠配合材料.對型防護劑.方法
  9. Abstract : the method of using formaldehyde buffer solution a b sorption - hydrochloric pararosaniline spectrophotometry to determine sulfur diox ide in air has higher sensitivity and good selectivity, and prevents from adoptin g mercurial absorbent. but the conditions in lab are not well controlled, the v alue of reagent blank and standard curvilinear slope can ' t accord with the one s tipulated in “ methods for air and waste gas monitoring and analysis ”. some opra tional techniques for so2 determination in lab are introduced for reference

    文摘:以甲醛緩沖溶液吸收-鹽酸副玫瑰分光光度法測定空氣中的二氧化硫,方法靈敏度高,選擇性好,避免了使用含汞的吸收液,但如果實條件控制不好,劑空白值及標準曲線的斜率就會不符合《空氣和廢氣監測分析方法》中規定的值,本文著重從操作技巧方面對二氣化硫測定的實室質量控制進行分析,僅供參考。
  10. Standard test method for mercaptobenzothiazole sulfenamide assay by reduction titration

    用還原滴定法對硫基並噻唑亞磺酰鑒定的標準方法
  11. Standard test method forp - phenylenediamine antidegradants purity by gas chromatography

    用氣相色譜法測p -抗降解劑純度的標準方法
  12. Standard test method for rubber compounding materials : 2 - benzothiazyl sulfenamide accelerators - insolubles

    橡膠合成材料2 -並噻唑基亞磺酰催速劑的標準方法.不溶解性
  13. Choose an optimum condition on the basis of that to go on an amplification experiment whose product become the raw and processed materials with which the influence between the adding of dbs a as the second dopant and the conductivity of cp is studied

    根據正交結果,選取一個最優條件並進行放大實。以該產品為原料,研究了十二烷基磺酸二次摻雜對絲炭/聚導電材料導電性能的影響。
分享友人