蒸氣噴發 的英文怎麼說

中文拼音 [zhēngpēn]
蒸氣噴發 英文
hydroeruption
  • : Ⅰ動詞1. (蒸發) evaporate2. (利用水蒸氣的熱力使食物熟或熱) steam Ⅱ名詞[中醫] (將藥物隔水蒸熟) steaming
  • : Ⅰ名詞1 (氣體) gas 2 (空氣) air 3 (氣息) breath 4 (自然界冷熱陰晴等現象) weather 5 (氣味...
  • : 噴動詞1. (液體等受壓力而射出) spurt; spout; gush; jet 2. (噴灑) spray; sprinkle
  • : 名詞(頭發) hair
  • 蒸氣 : steam; vapour蒸氣供暖 steam heating; 蒸氣管 steam pipe; 蒸氣管道 steam pipeline; 蒸氣渦輪機 steam...
  1. This paper discusses the designing and making of the dynamic testing systems of engine electronic control system. base on the construction and operation principle of santana 2000gsi m3. 8. 2 engine electronic control systems, design and manufacture led circuit of dynamic testing and fault imitating electronic control unit. on the inspect board, design and equip with motronic 3. 8. 2 ecu i / o measuring joints, design and set up obd - ii diagnostic communication link, design and install fuel pressure inspecting meter. depend on the obd - ii diagnostic communication link and ecu i / o measuring joints, this dynamic testing system can inspect engine electronic fuel injection system, distributorless ignition system, idle speed control system and evaporative emission control system, and can inspect m3. 8. 2 sensors, ecu and actuators, and can interrogate fault memory and erase fault memory ; and can analyse data stream ; and can carry out fault imitating. besides, this paper analyses sensors and actuators typical fault w aves

    2電控單元電路連接器設計製成輸入輸出電子控制檢測端子,並在檢測面板上布置了obd -診斷插座和燃油壓力表。使該動態測試系統能實現對電動機的燃油系統、直接點火系統、怠速控制系統和燃油排放控制系統的動態檢測;並通過obd -診斷座、 ecu輸入輸出檢測端子和故障模擬處理單元實現對電動機電控系統各傳感器、電控單元、執行器進行故障碼讀取與清除;動態數據讀取和波形測試和故障模擬等。此外,本論文還分析了傳感器和執行器典型故障波形。
  2. Enceladus, a moon of saturn, stunned scientists two years ago when nasa ' s cassini orbiter discovered geyser - like jets of water vapor shooting into space from its south pole

    恩克拉多斯(土衛二)是土星的一個衛星。兩年前卡西尼號人造衛星現一股泉狀的水從它的南極射向外太空,令美國宇航行局感到非常震驚。
  3. Air jet evaporation method

  4. As to the simulation, three - dimensional n - s equations and two - phase flow model, in which the liquid toluene spray as discrete particles was considered, were employed to describe the turbulent combustion processes in the combustion chamber. the mass and energy transfer between the two phases were calculated by the droplet evaporation model, and the arrehnius model was used to obtain the gas chemical reaction rate. the details of 3d flow field, the distributions of temperature and compounds were obtained by solving the equations

    數值模擬方面,應用三維湍流n - s方程以及顆粒軌道模型描述了激光器燃燒室內部的霧兩相燃燒流動過程,兩相之間的質量、能量交換由液滴模型計算,相化學反應速率由arrhnius公式計算,通過耦合求解液兩相模型方程,模擬了燃燒室三維流場,得到了燃燒室內的溫度和組分濃度分佈。
  5. The economy analysis of fog - atomizing evaporative cooler for gas turbine

    輪機進冷卻的經濟性分析
  6. ( 4 ) the influence of pulsation frequency on the drying process two special cases, in which the selected pulsation frequencies were 0 h /, and 83 h / respectively, were simulated and their simulation results indicated that the pulsating frequency of gas stream could improve the intensities of the heat and mass transfer during a pulse combustion spray drying process

    ( 4 )揭示了流脈動對乾燥過程的影響本文模擬脈動頻率為83hz的脈動流和非脈動流的兩種乾燥過程,比較兩種乾燥過程的顆粒速率和濕含量變化。模擬結果表明流脈動對霧乾燥過程有一定增強作用。
  7. The dehydration time is square of the droplets diameter so the small diameters of the droplets can cut down the drying time then reduce the height of the drying chamber. to the combined spin - flow pressure spray drying, the diameters of droplets are small and the dehydration rate is higher so keeping the qualities of the dried products we can increase the speed of the inlet wind and reduce the temperature of the outlet wind thus can improve the evaporation intensity of the drying chamber and the average energy utilization of the drying equipment

    因霧滴的脫水時間與其直徑的平方成正比,減小液滴直徑有利於縮短乾燥脫水時間,可有效降低乾燥塔的高度;由於旋流式組合壓力嘴霧化滴徑的減小,脫水速度明顯加快,在不影響乾燥物料性質的前提下,適當提高進風溫度,同時有效地降低排溫度,有利於提高幹燥塔的強度,也有利於提高幹燥設備的平均能源利用率。
  8. Simulation results show that the surge line moved up - left relative to the original one and surge margin became larger when wet compression is used, which means wet compression can extend steady - operation regions of compressors and the si a - 02 gas turbine. at last, based on the moore - greitzer model surge and rotating stall of a compression system with wet compression is modeled with consideration of inlet evaporative cooling and compressor pressure rise when wet compression is used

    哈爾濱工程大學博士學位論文最後,本文在壓縮系統moors grei上zer模型的基礎上,考慮進口冷卻的作用和壓機濕壓縮過程的作用,推導出了濕壓縮系統喘振和旋轉失速的統一模型,該模型可以模擬系統生喘振和旋轉失速時的瞬態響應以及水濕壓縮對系統瞬態響應的影響。
  9. A ejector for is applied in this theory. it can not only regulate the evaporating temperature of each high - temperature refrigeratory but also reduce the back - pressure of the compressor when a system applies this theory. at the same time, the exhaust temperature of the compressor becomes low and the refrigerating capacity per unit of swept volume becomes high

    鑒于目前這種現狀,本文提出了以射器為基礎的船舶高、低溫冷庫製冷新循環,不但可調節高溫庫的溫度,而且也可使壓縮機的回壓力得到提高,壓縮機排溫度降低,單位容積製冷量上升,製冷系數提高,火用效率提高。
  10. After the flue heat evaporates the moisture, dry sodium or calcium salts and the un - reacted absorbent are collected in the dust collector. however, very few domestic companies have the ability to manufacture the fdg system

    ,吸收劑入洗滌塔時為霧化的泥漿,水汽慢慢地被熱煙,最後以乾鈉鹽或鈣鹽及未反應的吸收劑混合物之型式,被集塵機所收集去除。
  11. Temperature analysis on gas turbine inlet air by water spray evaporative cooling

    輪機進採用冷卻方式的溫度分析
  12. They are removed using catalytic or oxidation reactions to form non - toxic nitrogen or nitrates. practical processes include ammonia and catalytic method, high - temperature nitrogen reduction method, activated carbon and incineration as well as alkaline washing

    ,吸收劑入洗滌塔時為霧化的泥漿,水汽慢慢地被熱煙,最後以乾鈉鹽或鈣鹽及未反應的吸收劑混合物之型式,被集塵機所收集去除。
  13. Used the theory of air - dynamic and the jet - ejector principle the characteristic of jet - steam, proving the noise signal have the character of chaos by using the fractal theory. noise sound pressure on the normal condition was checked by theory formula and contrasted with the experimental data. the difference was analyzed in detail

    結合空動力學流噪聲理論公式,驗算了三效降膜器正常生產時熱壓泵中拉伐爾管口處的噪聲聲壓級,與實測值進行對比,並詳細分析了兩者產生較大差異的原因。
分享友人