蒸汽出口 的英文怎麼說

中文拼音 [zhēngqìchūkǒu]
蒸汽出口 英文
vapor out
  • 蒸 : Ⅰ動詞1. （蒸發） evaporate2. （利用水蒸氣的熱力使食物熟或熱） steam Ⅱ名詞[中醫] （將藥物隔水蒸熟） steaming
  • 汽 : 名詞1. （由液體或某些固體變成的氣體） vapour2. （水蒸氣） steam
  • 口 : Ⅰ名詞1 （人或動物進飲食的器官; 嘴） mouth 2 （容器通外面的地方） mouth; rim 3 （出入通過的地方） ...
  • 蒸汽 : vapour; reek; breath; steam蒸汽採暖 steam heating; 蒸汽錘 [機械工程] steam hammer; 蒸汽打樁鍾 ste...
  1. When “ holding ” ( during normal operation ), non condensable, which are coming from air ingress and oxygen content in steam and condensate, must also be extracted normally by main ejectors

    當「建立真空」 （正常操作下）時，空氣入口處的不可凝結物和蒸汽中的氧含量以及凝結水必須由主抽汽器排出。
  2. The recovery of atmospheric light oil yield of atmospheric in the northern atmospheric distillation tower of shenghua teaching & test factory, science and technology group of china university of petroleum has been increase by about 4 or 5 percent through the following methods : changing the tray perforation of atmospheric tower, adjusting the amount of stripping steam and the outlet temperature of the atmospheric heater and merging atmospheric excess vapor into 3rd atmospheric drawn - stream to keep the fractions content of bottom oil below 5 % before 350

    摘要中國石油大學科技集團勝華教學實驗廠北常減壓蒸餾裝置換煉勝利管輸油后，通過改變常壓塔塔盤開孔率、調節常壓塔汽提蒸汽量和常壓爐出口溫度、常壓過汽化油併入常三抽出線等措施，控制常壓塔底油350前餾分含量小於5 % ，使常壓輕質油收率提高約4 % ~ 5 % 。
  3. We that one a of specialities produce little electrical home appliances the enterprises of productses, locate in and enjoy " mould of china city ", the yuyao of zhejiang of titles of " plastic of china city " ; from 60 kilometers of ports in ningbo, exports 5 kilometers from high speed yuyao of turtledove of hangzhou of shanghai, geographical environment is superior, complete auxiliary facility, produce electric sweeper, electric toothbrush, steam cleaner, car refrigerator, popcorn maker, etc

    我司地處享有「中國塑料城」 「中國模具城」之稱的浙江餘姚，距寧波港口60km ，離滬杭甬高速餘姚出口5km ，地理環境優越，配套設施完備。是一家集研發生產出口於一體的小家電系列產品的專業廠家，主要生產電動掃地機電動牙刷蒸汽清潔器爆米花機汽車冰箱等，產品通過tuv gs ce認證，質量第一，交貨及時，竭誠歡迎國內外客商與我們聯系，共同建立業務合作關系。
  4. Fuel vapors can escape from the carburetor float bowl through external vents, internal vents and fuel passages and air bleeds.

    燃料蒸汽可以從化油器浮子室通過外部通風口，內部通風口，燃料通道和空氣泄放口逸散出去。
  5. The equilibrium working temperature of the gasifier and the composition of the outlet syngas ( short for synthesis gas ) at this temperature were calculated by solving the chemical equilibrium and the energy equilibrium equations. the analysis was used to study the effect of gasifying agent mixture ratio on the outlet syngas composition, the cold gas efficiency, the thermal efficiency and the exergy efficiency. the optimum o2 / coal ratio was found for a reasonable vapor / coal ratio ( the vapor / coal ratio had little effect on the efficiencies ) for various kinds of coal to maximum the thermal efficiency and the exergy efficiency

    通過化學平衡和熱量平衡方法求解氣化爐平衡工作溫度以及該溫度下的出口煤氣成分，研究了氣化爐進口氣化劑配比對出口煤氣成分、冷煤氣效率、熱效率及火用效率的影響，指出熱效率、火用效率最優情況下適應于各煤種的最優氧煤比以及合理的水蒸汽耗量，為多聯產系統的設計優化提供參考。
  6. On describing a genetic algorithm ( ga ), we present a method for applying ga to optimize the lasers. a programming is presented for obtaining the maximum laser power. by using the method we optimize the cvl and the co2 laser, including lc circuit parameters of the cvl, the cvl system, the lasing resonator and the gas components mixtured in the co2 laser tube

    在這個部分中，首先簡述了遺傳演算法，討論了應用遺傳演算法來優化激光器的思想和方法，給出了優化大功率激光器的計算機程序設計；然後，對銅蒸汽激光器lc放電電路、大口徑激光器和激光器系統分別進行了優化；對二氧化碳激光器諧振腔和氣壓參量分別進行了優化，介紹了優化二氧化碳激光器諧振腔的實驗以及實驗所獲得的結果
  7. For improving the quality of traditional chinese roasted green tea, fresh leaf spreading, steaming to de - enzyme, and dehydrating for new - type roasted green tea process were studied

    摘要針對當前出口炒青綠茶品質存在的「色澤不綠、苦澀味重、有煙焦味」等突出問題進行鮮葉攤放、蒸汽殺青、脫水等關鍵工藝研究，綜合提出長炒青綠茶、圓炒青綠茶加工新工藝。
  8. After researching the part thermal equipments and systems include heaters, steam leakage and receiving systems, low pressure drain system etc, and computing the efficiency of the systems, find out the better choice of the imported assemblies than the domestic assemblies in parameter and the disfigurements in design and making. based on the above, point out the measure to progress them. according to the analysis, we can get some measures to increase the economical level of the systems and save more energy

    對局部熱力設備及熱力系統進行分析研究，包括:加熱器設備、漏汽及回收系統、低加疏水系統、主、再熱蒸汽系統以及凝汽器等部位；並計算汽輪機本體高、中、低壓缸效率，藉此著重對汽輪機通流部分進行了剖析，找出國外進口機組動、靜葉柵、葉型的選擇比國產機組先進性以及國產機組在通流部分設計和製造中的諸多缺陷，並且指出了改進的方向，為機組提高熱經濟性、節能降耗奠定了理論基礎。
  9. By setting water level of the direct contact heat exchanger, the superheating of steam can be adjusted

    得出壓力、液位高度為主要影響參數，實現了通過調節液位高度來調節蒸汽出口過熱度。
  10. There are several important issues to that attention should be paid in the design of test bed, such as the measurement of the temperature difference between the inlet and outlet of test section and the temperature of cooling water in the inlet and outlet of condensing tubes, filled volume of the steam boiler and its level control, the determination of the natural acting head of high temperature tank and design of the cooling water flow of measuring tank

    試驗臺由高溫工質自然循環子系統、冷卻水機械循環子系統和計算機監測控制子系統構成，試驗段進出口溫差及冷凝管進出口溫度的測試、蒸汽鍋爐充注量及液位控制、高溫水箱自然作用水頭的設計、冷卻水流量計量水箱的設計等是試驗臺設計中值得重視的問題。
  11. Back pressure of steam trap

    蒸汽系統疏水器出口外凝結水的壓力
  12. The dried material is put into the middle of shell, mixing by the rake teeth and the material shaft works back and forth. the indirect heating, equal agitation of rake teeth and grinding of breaking stick makes water in material evaporation. under the effect of vacuum system, the water in the dried material and apparent water are discharged and the vapor water is discharged from outlet of vacuum pump passing dry dust collector, wet dust collector and condenser

    被乾燥物料從殼體上方正中間加入，在不斷正反轉動的耙的攪拌下，物料軸向來回走動，與殼體內壁接觸的表面不斷更新，受到蒸汽的間接加熱，耙的均勻攪拌，粉碎棒的粉碎，使物料內的水份氣化，在真空系統的作用下，使被乾燥物料內部水份和表面水份更有利的排出，氣化的水份經乾式除塵器濕式除塵器冷凝器，從真空泵出口處放空。
  13. During the research process, it is from the existing liquid sulfur heating technology - steam heating one, and comgines other several kinds of heating methods. fully comsider the relative merits of heating methods, especially do the detail discussing for utilizing the operating principle of organic carrier heating, technology process and application. giving attention to the operating specialty of harbor, at the same time consider the various kinds of requirements from customers in marker competition, to select suitable technology method in harbor transferring

    在研究過程中主要從已有的液體硫磺加熱工藝? ?蒸汽加熱工藝出發，結合其他多種加熱方式，充分考慮各種加熱方式的優缺點，尤其是對利用有機熱載體加熱的工作原理，工藝流程，應用情況進行詳細論述；兼顧港口作業生產特點，同時考慮市場競爭過程中客戶提出的各種要求等以造出適合港口中轉的工藝方式。
  14. Provide steam rings for tube side inlet and outlet flanges

    管程的入口與出口法蘭配備蒸汽環。
  15. Mount st. helens vented a new column of steam october 10, a lazy plume that rose out of the crater of the snow - dusted volcano

    10月10日，一股蒸汽從聖海倫斯火山口噴發出來，這縷煙從白雪覆蓋的火山口緩緩升起。
  16. Has analyzed the existing thermal power plant boiler superheat vapor temperature governign system control strategy, proposed exports the vapor temperature using the boiler the rate of change and the chamber exports the haze temperature to take the forward feed signal, the solution superheat vapor temperature adjustment hysteresis quality

    分析現有熱電廠鍋爐過熱蒸汽溫度調節系統的控制策略，提出利用鍋爐出口蒸汽溫度的變化率和爐膛出口煙氣溫度作為前饋信號，解決過熱蒸汽溫度調節的滯后性。
  17. The workers are arranged to this hut, in the time when the locomotive works

    如果蒸汽機車出外面的時候，由門里工作人員打開門及關門道口護護欄。
  18. The project is to employ three layer - extruded steam of nitrogen - cross - linked processed to produce cross - linked polyethylene cable partly using imported equipment

    項目主要採用三層擠出蒸汽或氮氣交聯工藝，引進部部分設備，進口交聯聚乙烯電纜料。
  19. The interactions between heat flux density, vapor pressure, vapor velocity and the coefficient of heat transfer for condensation in tube, the coefficient of heat transfer in total are investigated. the relationships between heat flux density and the total difference in temperature, the difference of temperature, pressure drop of vapor from the entrance of the tube to the exit are investigated as well

    考察了冷卻水流量、溫度恆定條件下熱流密度、蒸汽壓力、蒸汽流速對冷凝傳熱膜系數及總傳熱系數的影響關系，同時考察了總傳熱溫差、蒸汽進出口溫差及壓差隨熱流密度變化的關系。
  20. If the wand is kept near the top ? but not on the surface ? the milk will stretch naturally and in the meantime will be nicely textured without too much trouble

    如果把蒸汽出口放置在接近牛奶液表面的地方，而不是懸在上面，打出的牛奶泡沫自然就會形成很美的形狀，而不會太麻煩。
分享友人
分享到 Line

分享到臉書