蒸汽壓試驗 的英文怎麼說

中文拼音 [zhēngqìyāshìyàn]
蒸汽壓試驗 英文
vapour-pressure test
  • 蒸 : Ⅰ動詞1. （蒸發） evaporate2. （利用水蒸氣的熱力使食物熟或熱） steam Ⅱ名詞[中醫] （將藥物隔水蒸熟） steaming
  • 汽 : 名詞1. （由液體或某些固體變成的氣體） vapour2. （水蒸氣） steam
  • 壓 : 壓構詞成分。
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 蒸汽 : vapour; reek; breath; steam蒸汽採暖 steam heating; 蒸汽錘 [機械工程] steam hammer; 蒸汽打樁鍾 ste...
  • 試驗 : trial; experiment; test
  1. Standard test method for vapor pressure of gasoline and gasoline - oxygenate blends dry method

    汽油和汽油元氧混合物蒸氣壓力的標準試驗方法
  2. Test method for water vapor transmission of pressure - sensitive tapes

    壓感膠帶的水蒸汽穿透性的試驗方法
  3. Methods of test for petroleum and its products - bs 2000 - 69 : petroleum products - determination of vapour pressure - reid method

    石油及其產品試驗方法. bs 2000 - 69 :石油產品.蒸汽壓力的測定.瑞利法
  4. " determination of the bond behaviour between reinforcing steel and autoclaved aerated concrete by the " beam test " - part 1 : short term test "

    用射束試驗法測定鋼筋和高壓蒸汽加氣水泥間的粘結情況.第1部分:短時試驗
  5. Methods of test for masonry units - part 15 : determination of water vapour permeability of autoclaved aerated concrete masonry units

    圬工單元試驗方法.第15部分:蒸壓充氣混凝土圬工單位水蒸汽滲透性的測定
  6. The paper is on how to set up lab platform of vapour spewing to uppercooling water surface to coagulate directly and to observe and analyse which vapour coagulate on the water surface, the results enable people to know the security system of nuclear power. the range of the pressure parameters of prz is from 0. 2mpa to 0. 6mpa, and the range of the initial temperature parameters of cmt is from 23. 5 to 78. 5, all of the testing points are 30 and there are fifty thousand testing data. many results of vapour spewing to uppercooling water surface vertically to coagulate can get. for example : coagulating can make the water of cmt surge forcefully when vapour spews to uppercooling water surface, too many vapour - bubbles come into being and strike the water of cmt owing to rupture continually, all these will strengthen the surge because of the vapour pressure of cmt

    實驗中prz飽和蒸汽壓力變化范圍為: 0 . 2mpa - 0 . 6mpa ， cmt中水初始溫度變化范圍: 23 . 5 - 78 . 5 ，實驗中測試工況30個左右，實驗測試數據50萬余個，得出了很多與非能動安全系統相關的蒸汽垂直噴向過冷水表面凝結時的結論：蒸汽垂直噴入過冷水表面凝結時會造成cmt中液面的強烈波動和振蕩，產生大量蒸汽汽泡，汽泡不斷破裂對cmt中液體帶來很大沖擊，勢必引起cmt中液體的振蕩，造成cmt汽空間汽壓不均勻，加強cmt液體的振蕩和波動。
  7. Test investigation on sgtr of single tube break and three - tube break is carried out on hpitf of ciae to deeply understand the thermal - hydraulic behavior during pressurized - water - reactor ( pwr ) sgtr and to provide an integral data base for code assessment and development. the facility, a full height and 1 / 1000 - scale ( by volume ) of qinshan nuclear power plant, incorporates two identical loops with active pumps and steam generators ( sg ). the initial steady state of the test basically simulated that of the reference plant operation

    為了深入了解核電廠蒸汽發生器傳熱管破裂事故發生后的熱工水力現象，以及對壓水堆（ pwr ）核電廠系統分析程序進行分析和評價，在高壓綜合試驗裝置上開展了蒸汽發生器傳熱管破裂試驗研究高壓綜合試驗裝置以秦山核電廠主迴路系統為模擬對象，該裝置為雙環迴路系統，容積比為1 ： 1000 ，高度比為1 ： 1 。
  8. Mechanical steam compression systems driven with electric motor. test methods

    電動機帶動的機械蒸汽壓力系統.試驗方法
  9. Determination of the bond behaviour between reinforcing steel and autoclaved aerated concrete by the " beam test " - part 1 : short term test ; german version en 12269 - 1 : 2000

    通過抗彎試驗測定鋼筋和高壓蒸汽加氣混凝土粘性.第1
  10. Leng 43 block was developed in 1993 and since then conventional fracturing conduction, water flooding test, steam soaking were successively carried out, but exposing several inconsistencies such as high decline rate of output, water flooding fingering, low potential of steam soaking etc. among them the physical properties is an important factor that affecting the result of development

    該塊從1993年投入開發以來，先後進行過先期壓裂常規開采、注水開發試驗、蒸汽吞吐開采，但是暴露出常規開采產量遞減快、水驅指進、蒸汽吞吐潛力小等矛盾，其中儲層特徵是影響其開發效果的一個主要因素。
  11. Based on the furnace chamber flame monitoring system, this paper designed and analyzed a combustion control system with the main steam pressure as the primary adjusting parameter and the total radiant energy of the furnace chamber as the subsidiary parameter, and compared the advantages of the system with emulation research and the experimental test

    在爐膛火焰監測系統的基礎上，設計分析了以主蒸汽壓力為主調、以爐膛總輻射能為副調參數的燃燒控制系統，並通過模擬研究和試驗驗證，比較了該方法的優越性。
  12. The condensation heat - exchange characteristic of a separate - type heat - pipe was studied on a 1 : 1 model. the heat pipe is heated by electricity, and working fluid is distilled water, and it is cooled by air. the experimental results show that, ( 1 ) when charging liquid ratio is 45 %, condensation heat - exchange coefficient reaches to maxium ; ( 2 ) when there is not non - condensing gas, the coeffcient decreases a little with the increase of vapour pressure, and it decreases by 9. 5 % when the pressure increases from 0. 16mpa to 0. 36mpa ; ( 3 ) when there is non - condensing gas, the coefficient decreases a little, but when the gas is discharged by an exhaust value, it can be improved, when the volume content of the gas is 2. 5 %, it can increased by 22 % ; ( 4 ) the effect of the non - condensing gas on the coefficient decreases with the increase of the pressure, and when the volume content of the gas is 5 % and the pressure increases from 0. 16mpa to 0. 36mpa, the coefficient increases by 6 %. the relative curves are given between condensation heat - exchange coefficient and air flowrate, charging liquid ratio and vapour pressure

    建立了空氣冷卻實驗臺，熱管的加熱方式為電加熱，工質為蒸餾水.在1 1模型上對分離式熱管管內凝結換熱特性、不凝性氣體對凝結換熱的影響及不凝性氣體的擴散規律進行了試驗，得出分離式熱管有一最佳充液率，其值為45 %左右；凝結換熱系數隨著蒸汽壓力的增加略有降低，在實驗的壓力范圍內，降低了9 . 5 % ；不凝性氣體對分離式熱管的凝結換熱僅影響冷凝段下部較小部分，通過排氣閥排出不凝性氣體可有效地改善冷凝段下部的凝結換熱；隨著壓力的增加，不凝性氣體對分離式熱管冷凝段的影響減少.這些結論可用於分離式熱管換熱器的工程設計和控制
  13. Abstract : the condensation heat - exchange characteristic of a separate - type heat - pipe was studied on a 1 : 1 model. the heat pipe is heated by electricity, and working fluid is distilled water, and it is cooled by air. the experimental results show that, ( 1 ) when charging liquid ratio is 45 %, condensation heat - exchange coefficient reaches to maxium ; ( 2 ) when there is not non - condensing gas, the coeffcient decreases a little with the increase of vapour pressure, and it decreases by 9. 5 % when the pressure increases from 0. 16mpa to 0. 36mpa ; ( 3 ) when there is non - condensing gas, the coefficient decreases a little, but when the gas is discharged by an exhaust value, it can be improved, when the volume content of the gas is 2. 5 %, it can increased by 22 % ; ( 4 ) the effect of the non - condensing gas on the coefficient decreases with the increase of the pressure, and when the volume content of the gas is 5 % and the pressure increases from 0. 16mpa to 0. 36mpa, the coefficient increases by 6 %. the relative curves are given between condensation heat - exchange coefficient and air flowrate, charging liquid ratio and vapour pressure

    文摘:建立了空氣冷卻實驗臺，熱管的加熱方式為電加熱，工質為蒸餾水.在1 1模型上對分離式熱管管內凝結換熱特性、不凝性氣體對凝結換熱的影響及不凝性氣體的擴散規律進行了試驗，得出分離式熱管有一最佳充液率，其值為45 %左右；凝結換熱系數隨著蒸汽壓力的增加略有降低，在實驗的壓力范圍內，降低了9 . 5 % ；不凝性氣體對分離式熱管的凝結換熱僅影響冷凝段下部較小部分，通過排氣閥排出不凝性氣體可有效地改善冷凝段下部的凝結換熱；隨著壓力的增加，不凝性氣體對分離式熱管冷凝段的影響減少.這些結論可用於分離式熱管換熱器的工程設計和控制
  14. The break was assumed to be a single tube double - ended and three - tube double - ended shear break. the diameter of the break orifice is 0. 876mm and 1. 518mm respectively. the characteristic responses of main thermal - hydraulic parameters, such as primary pressure, secondary pressure, break flow rate, pressurizer level, secondary side level of steam generator and so on, were presented in this thesis

    試驗再現了核電廠蒸汽發生器單根傳熱管雙端斷裂事故和三根傳熱管雙端斷裂事故發生后的熱工水力現象，給出了事故過程中一次系統壓力、二次系統壓力、破口流量、蒸汽發生器二次側水位、穩壓器水位、元件表面溫度等主要參數的瞬態響應。
  15. Environmental testing for electric and electronic products. part 2 : test methods. test cx : damp heat, steady state unsaturated pressurized vapour

    電工電子產品環境試驗第2部分:試驗方法試驗cx :未飽和高壓蒸汽恆定濕熱
分享友人
分享到 Line

分享到臉書