蒸汽採油 的英文怎麼說

中文拼音 [zhēngcǎiyóu]
蒸汽採油 英文
steam-assisted recovery
  • : Ⅰ動詞1. (蒸發) evaporate2. (利用水蒸氣的熱力使食物熟或熱) steam Ⅱ名詞[中醫] (將藥物隔水蒸熟) steaming
  • : 名詞1. (由液體或某些固體變成的氣體) vapour2. (水蒸氣) steam
  • : Ⅰ名詞1 (脂肪; 油脂) oil; fat; grease 2 (姓氏) a surname Ⅱ動詞1 (用桐油、油漆等塗抹) apply t...
  • 蒸汽 : vapour; reek; breath; steam蒸汽採暖 steam heating; 蒸汽錘 [機械工程] steam hammer; 蒸汽打樁鍾 ste...
  1. Using structured packing column or modification of tray column can reduce the steam consumption. after modification of tray column the quality of the refined oil can he also improved

    摘要用結構填料脫臭塔或改造板式脫臭塔都可以降低消耗量。改造板式脫臭塔的同時還可以改善精煉成品的質量。
  2. The heat source may be steam, heat conduction oil, electricity or coal ( oil ) hot air furnace

    熱源可、導熱、電或燃煤()熱風爐配套。
  3. The stainless steel reaction vessel is composed of vessel cover, drum body, jacket, mixer, shaft seal actuating device and support, and the part of equipment which directly contacts with material all adopts

    我廠生產的電導熱加熱不銹鋼反應鍋由鍋蓋筒身夾套攪拌器軸封傳動裝置及支承等組成,與鍋內物料接觸處的鍋體和零部件均用0cr18ni9或1cr18ni9ti不銹耐酸鋼板製成。
  4. With the yield of concentration of sulfur compound as the evaluation index, the contrast between onion essential oil and onion oleoresin from dried onion powder by steam distillation, solvent extraction and soxhlet method was studied

    摘要以洋蔥粉為研究對象,以含硫化合物濃度為評價指標,用水餾、溶劑萃取法和索氏提取法進行洋蔥精樹脂的比較研究。
  5. Through analyzing the effect of temperature and nitrogen on crude oil viscosity the influences of different nitrogen injection volume and injection modes on steam displacement are contrasted, the mechanism of nitrogen - assisted steam stimulation is clarified, which includes : heat carrying capacity is raised, the saturation of remaining oil is reduced after nitrogen - assisted injection is made ; crude oil flow is enhanced because of nitrogen compression and dispersion and the change of oil flow shape ; water back - production rate is improved by expanding the steam sweep volume and compensating in - situ energy ; steam distillation effect is enhanced

    通過分析溫度、氮氣對原粘度的影響,對比不同注氮量、不同注入方式等對效果的影響,弄清了氮氣輔助增產的機理主要表現在:氮氣輔助后增加攜熱能力,降低殘余飽和度,氮氣的壓縮膨脹作用分散和改變了原流動形態,增強了原流動性;擴大的波及體積,補充地層能量,提高回水率,強化餾效應。
  6. Abstract : the causes for low efficiency of the heater in no. 2 crude unit of jpc refinery are described and analyzed including water leaking of steam soot blower, dew point corrosion caused by steam, soot deposits in convection chamber owning to poor soot blowing, high flue gas temperature, no heat recovery of flue gas, and poor performance of insulation lining, etc. by using sonic soot removing system, flue gas recovery system, spray coating of fiber and rock wool, as well as adjustment of flow scheme accordingly in the technical revamping. the dew point corrosion is completely eliminated, the insulation performance is improved, the heat loss is reduced by 1. 25 %, the flue gas temperature is reduced to about 170, and the heater efficiency is increased from 83 % to more than 90 %

    文摘:分析了金陵石化工公司煉廠二套常減壓裝置加熱爐存在的因吹灰器漏水,引起露點腐蝕及吹灰效果差造成對流室積灰,排煙溫度高,煙氣熱量未回收利用以及爐子保溫襯里效果差等問題,提出用聲波除灰系統、煙氣回收系統、纖維噴塗和巖棉噴塗及相應的流程調整等改造措施.測定結果表明,本次技術改造解決了因吹灰器漏水所造成的露點腐蝕問題,提高了保溫效果,減少散熱損失1 . 25 % ,排煙溫度降至170左右,裝置的爐效率由83 %左右提高到90 %以上
  7. The causes for low efficiency of the heater in no. 2 crude unit of jpc refinery are described and analyzed including water leaking of steam soot blower, dew point corrosion caused by steam, soot deposits in convection chamber owning to poor soot blowing, high flue gas temperature, no heat recovery of flue gas, and poor performance of insulation lining, etc. by using sonic soot removing system, flue gas recovery system, spray coating of fiber and rock wool, as well as adjustment of flow scheme accordingly in the technical revamping. the dew point corrosion is completely eliminated, the insulation performance is improved, the heat loss is reduced by 1. 25 %, the flue gas temperature is reduced to about 170, and the heater efficiency is increased from 83 % to more than 90 %

    分析了金陵石化工公司煉廠二套常減壓裝置加熱爐存在的因吹灰器漏水,引起露點腐蝕及吹灰效果差造成對流室積灰,排煙溫度高,煙氣熱量未回收利用以及爐子保溫襯里效果差等問題,提出用聲波除灰系統、煙氣回收系統、纖維噴塗和巖棉噴塗及相應的流程調整等改造措施.測定結果表明,本次技術改造解決了因吹灰器漏水所造成的露點腐蝕問題,提高了保溫效果,減少散熱損失1 . 25 % ,排煙溫度降至170左右,裝置的爐效率由83 %左右提高到90 %以上
  8. Nowadays, the domestic heavy oil reservoirs are mainly exploited by steam injection process, but serious challenges come from sand problem, steam breakthrough and high production cost

    目前,我國稠藏主要取注等熱采方式,但普遍面臨著層出砂、氣竄和成本高的嚴峻挑戰。
  9. In this paper a perfect and flexible experimental system of low nox combustion is established firstly. the influences of the temperature of combustion, the air excess coefficient, a certain amount of vapor added in advance, the temperature of preheated air, adding microwave into gas before combustion, gas recycling combustion and the mode of combustion ( diffused and premixed ) on nox emission are analyzed respectively. the combustion of liquid petroleum gas is simulated with phoenics 3. 5

    首先建立了完善靈活的低no _ x燃燒實驗系統,在實驗系統上完成了燃燒溫度、過量空氣系數、預先加入一定量的水、空氣預熱溫度、對燃氣預先進行微波處理、煙氣再循環燃燒以及燃燒方式(擴散式與預混式)對no _ x生成的影響分析;用phoenics3 . 5軟體進行了液化石氣燃燒的數值模擬。
  10. In the gucheng ( ancient city ) oil field, where isotope trace injection profile test is not suit for, by having applied and spread the temperature method injection profile testing technique, a comparatively accurate injection profile result has been got. furthermore, during the process of dynamic monitor in steam injection development reservoir, the testing technologies of general well ' s temperature throughput profile in injection steam throughput production well and general well ' s temperature taking in steam profile in intermission steam pushing injection steam well are initiated, which having extended the applied field of the conventional temperature logging equipments, reduced the dynamic monitoring cost of thermal production reservoir greatly and provided much accurate and reliable data for the study of reservoir ' s behaviors and adjustment of developing projects

    在不適宜進行同位素示蹤吸水剖面測試的古城田,推廣應用了井溫法吸水剖面測試技術,取得了較為準確的吸水剖面,而且在注開發藏動態監測工作中,首創了注吞吐井普通井溫法吞吐剖面測試技術和間歇驅注井普通井溫法吸剖面測試技術,拓展了普通井溫測井裝備的應用領域,大大降低了熱藏動態監測成本,為藏動態研究和開發方案調整提供了大量準確可靠的資料。
  11. Chapter 5 discusses two kinds of learning in both knowledge creation and technical innovation : learning inward and learning outward of firm, and concludes there is a large gap between china and foreign countries in knowledge density of industries. for chinese industries, learning outward of firms have more significant effects on ircie than learning inward of ones. to a great extent, those industries which ircie are high depend on technical knowledge outside of firms, on the other hand, ones based on learning inward are low in ircie

    論文數據來源於國家統計局和科技部編纂的《中國科技統計年鑒》 ( 1991 ? 2000 ) ,扣除數據缺失的其他礦采選業和武器彈藥業,研究樣本包括煤炭采選業、石和天然氣采選業等6個掘行業,食品加工業、食品製造業等29個製造行業,以及電力熱水的生產及供應業等3個公用事業行業,共計38個工業行業。
  12. This paper summarized the forming - distributing mode and its controlling factors of the remains in the dalinhe heavy oil reservoir of the shu district in the liaohe oilfield on the basis of the character of the steam - injecting pouring and steam flooding

    摘要從吞吐和特點出發,總結了遼河田曙二區大?河稠藏剩餘形成控制因素和分佈模式。
  13. When specified, the valves are available in the alloys shown below which are suitable for steam, water, oil, oil vapor, gas and general services

    如果特別指定,這些閥門可以用下列合金鋼製造,適用於、水、氣、煤氣和通用應用。
分享友人