蒸汽管路 的英文怎麼說

中文拼音 [zhēngguǎn]
蒸汽管路 英文
steam line
  • : Ⅰ動詞1. (蒸發) evaporate2. (利用水蒸氣的熱力使食物熟或熱) steam Ⅱ名詞[中醫] (將藥物隔水蒸熟) steaming
  • : 名詞1. (由液體或某些固體變成的氣體) vapour2. (水蒸氣) steam
  • : Ⅰ名詞1 (管子) pipe; tube 2 (吹奏的樂器) wind musical instrument 3 (形狀似管的電器件) valve;...
  • : 1 (道路) road; way; path 2 (路程) journey; distance 3 (途徑; 門路) way; means 4 (條理) se...
  • 蒸汽 : vapour; reek; breath; steam蒸汽採暖 steam heating; 蒸汽錘 [機械工程] steam hammer; 蒸汽打樁鍾 ste...
  • 管路 : pipeline; canal; channel
  1. After the surplus size of the thick liquid trough is retrieved or put, can put the branch water properly, heat, wash the pipeline which sends the thick liquid material with pump circulation again, so as not to stop up

    漿槽的剩餘漿液回收或放掉后,可適當放入清水、用加溫,再用泵循環清洗輸送漿料的,以免堵塞。
  2. This paper mainly studies the application of distributed control system ( dcs ) in rubber sulphuration, and design out a set of small - scale dcs that can collect the temperature in the steam pipeline in real time, calculate equivalent time of sulphuration with different temperatures and communicate with low - computer through rs - 485 network to control numbers of sulphuration machines to work

    本文主要對集散控制系統( dcs )在橡膠硫化領域的應用進行了研究,設計出一套小型集散控制系統。該系統能實時採集硫化道內的溫度,計算出不同溫度下等效硫化時間,並通過rs - 485網與下位機通信達到控制多臺硫化機工作的目的。
  3. Note : when valve is installed above a horizontal line or on a vertical line, on steam service, equalizer pipe must have a water seal loop

    注:如果在應用場合,閥門安裝在水平道的上方或在垂直道上,則必須配置平衡以形成水密封迴
  4. Note : when regulator is installed above the line or in a veritcal line on steam service, the control pipe must have a loop to form a water seal to prevent steam from contacting the diaphragm

    注:在應用中,如果調節閥安裝在道的上方或安裝在垂直道上,則控制道必須有一個迴,以形成水密封,防止接觸隔膜。
  5. Road vehicles - filler pipes and openings of motor vehicle fuel tanks - vapour recovery system iso 13331 : 1995

    車輛.摩托車油箱開口和注油.回收系統
  6. Combined with the actual condition of the plant simulator, this paper analyzes the native and abroad development of the simulation device. the main content is followed : introducing the characteristics and managing specialties of the simulator project in detail ; introducing the simulation object, describing the hardware, software structure and functions of the simulation object ; describing the exploitation process and mathematic model of the main steam, reheater, by - pass system, regenerative heater extraction, deareator, pipes, network system and pumps

    本文分析了國內外模擬培訓裝置的發展狀態,並結合本廠模擬機開發的實際情況,其主要工作如下:詳細介紹了模擬機開發項目的特占和理特殊性;介紹了模擬對象和所開發模擬機的硬體結構、軟體結構,以及它的功能;詳細介紹了作者參加開發的機系統的主、再熱和旁系統,回熱抽氣和除氧系統,以及道、網和泵等模型的開發過程和數學模型。
  7. A fuel too volatile for the outside temperature, or a missing restrictor in the vapor line, will also cause improper engine idling.

    就外界溫度而言,燃油的揮發性過高,或蒸汽管路中的節流器有故障,也會使發動機的怠速不穩。
  8. To the steam generator a heat exchanger, which converts the feed water in the secondary circuit to high - pressure steam at about 67 bar or 6 700 kpa and deliver it to the " conventional island " via steam pipe for driving the turbine and generator

    內的高壓水帶到發生器即熱交換器,發生器會將二迴給水轉化為約67巴或6 700千帕的高壓,再經過送到常規島,以推動渦輪發電機。
  9. To the steam generator ( a heat exchanger ), which converts the feed water in the secondary circuit to high - pressure steam at about 67 bar ( or 6 700 kpa ) and deliver it to the " conventional island " via steam pipe for driving the turbine and generator

    內的高壓水帶到發生器(即熱交換器) ,發生器會將二迴給水轉化為約67巴(或6700千帕)的高壓,再經過送到常規島,以推動渦輪發電機。
  10. The working parameters ( specific enthalpy, entropy, flux of working fluid, reynolds number, etc. ), the configuration parameters of the main components, such as steam turbine - generator group, evaporator and ehd condenser and system efficiency were calculated on the base of thermodynamics theory

    文中以熱力學理論為基礎,計算了低溫余熱發電系統的運行參數(比焓、熵、工質流量、雷諾數、壓力等)和各主要組件如輪機-發電機組、發器和ehd冷凝器的結構參數,並計算了系統的效率。
  11. Based on the analysis of the forms and facilities of the scwr system, the status of scwr was investigated in the industry of printing and dyeing. two projects of scwr system were brought forward and the thermal economics of the scwr system was studied

    首先對印染企業的冷凝水回收進行調查研究,提出了兩種冷凝水回收方案,對兩種回收系統進行了水力和熱力計算,確定了系統各點的熱力學參數。
  12. A multi - strategy learner to learn sgtr steam generator tube rupture handling knowledge via oberservation

    :可經由觀察學到產生器破裂的處理知識
  13. Test investigation on sgtr of single tube break and three - tube break is carried out on hpitf of ciae to deeply understand the thermal - hydraulic behavior during pressurized - water - reactor ( pwr ) sgtr and to provide an integral data base for code assessment and development. the facility, a full height and 1 / 1000 - scale ( by volume ) of qinshan nuclear power plant, incorporates two identical loops with active pumps and steam generators ( sg ). the initial steady state of the test basically simulated that of the reference plant operation

    為了深入了解核電廠發生器傳熱破裂事故發生后的熱工水力現象,以及對壓水堆( pwr )核電廠系統分析程序進行分析和評價,在高壓綜合試驗裝置上開展了發生器傳熱破裂試驗研究高壓綜合試驗裝置以秦山核電廠主迴系統為模擬對象,該裝置為雙環迴系統,容積比為1 : 1000 ,高度比為1 : 1 。
  14. Each loop has a primary coolant pump, a steam generator and the interconnected piping

    每一環設有一臺主泵一臺發生器,與及連接道。
  15. Each loop has a primary coolant pump, a steam generator and the interconnected piping. a pressuriser is installed in one of the 3 loops

    每一環設有一臺主泵、一臺發生器,與及連接道。其中一個環裝設一臺穩壓器。
  16. If permissible to blow back into the line, any purging medium such as air, inert gas, steam, or flushing oil may be introduced through this connection

    如果允許吹回到內,則任何沖洗介質,如空氣,惰性氣體,,或沖刷油都可以通過這個連接引入。
  17. The experiment of condensation of steam in the presence of air was performed in a single vertical tube in a closed system consisted of the condenser tube, boiler, condensate separator drum, and connection lines from the boiler to the condenser tube

    在中壓迴上進行單根豎直內的冷凝實驗。冷凝段的主要幾何參數為:冷凝內徑為0 . 049m ,外徑為0 . 055m ,長度為3 . 5m ;外套內徑為0 . 067m 。
  18. Major : material science postgraduate : zhou xuchang advisor : zeng guangting huo yongzhong as a new type of shape memory alloy pipe coupling, nitinb pipe coupling has a good prospects on the connecting pipe. the study on the strength of nitinb connnetor system and design to optimize its structure have great meaning to its application on the connecting pipe of the steam maker in nuclear reactor on naval vessels

    Nitinb接頭是一種新型形狀記憶合金接頭,在連接上有著良好的應用前景。研究接頭系統的強度並對其結構優化設計對它在艦艇核反應堆發生器的連接上的應用有著重要的意義。
分享友人