蒸汽腐蝕 的英文怎麼說

中文拼音 [zhēngqìfǔshí]
蒸汽腐蝕 英文
corrosion by steam
  • 蒸 : Ⅰ動詞1. （蒸發） evaporate2. （利用水蒸氣的熱力使食物熟或熱） steam Ⅱ名詞[中醫] （將藥物隔水蒸熟） steaming
  • 汽 : 名詞1. （由液體或某些固體變成的氣體） vapour2. （水蒸氣） steam
  • 腐 : Ⅰ名詞（豆腐） bean curdⅡ動詞（腐爛; 變壞） decay Ⅲ形容詞（腐爛） rotten; corroded; putrid
  • 蝕 : Ⅰ動詞1. （損失; 虧耗） lose 2. （腐蝕） erode; corrode Ⅱ名詞（天體現象） eclipse
  • 蒸汽 : vapour; reek; breath; steam蒸汽採暖 steam heating; 蒸汽錘 [機械工程] steam hammer; 蒸汽打樁鍾 ste...
  • 腐蝕 : 1 （通過化學作用使物體逐漸消損破壞） corrode; corrosion; corroding; deep etch; diabrosis; rot; ea...
  1. Abstract : through analysis of the components of coking on different parts of desullfur system of single tower and the waste water containing sulfur, we find the cause of coking in the stripping desulur system from single tower is the polymerization reaction of carbohydrate and the separattion of varied solid powders, organic compounds, and all corrosive productions of metal out of waste water in high temperature, therefore, the solving method is how to decrease the oil content, how to depolymerize form the carbohydrate and how to antisepticize by vapour of waste water

    文摘:對單塔脫硫系統中不同部位的垢物及現場催化含硫污水進行了分析測定，結果表明：塔內污垢成分及含量隨塔體部位的不同而不盡相同，單塔汽提脫硫系統中垢物的形成，主要是由於污水中所含各類粉塵、有機物、金屬腐蝕物等在高溫下因石油碳氫化合物的析出及其單體的聚合反應所致.如何降低污水中的含油成分、減少聚合反應的生成、防止污水蒸氣對塔體材料的腐蝕，是阻垢、除垢和防垢應解決的關鍵問題
  2. Abstract : the causes for low efficiency of the heater in no. 2 crude unit of jpc refinery are described and analyzed including water leaking of steam soot blower, dew point corrosion caused by steam, soot deposits in convection chamber owning to poor soot blowing, high flue gas temperature, no heat recovery of flue gas, and poor performance of insulation lining, etc. by using sonic soot removing system, flue gas recovery system, spray coating of fiber and rock wool, as well as adjustment of flow scheme accordingly in the technical revamping. the dew point corrosion is completely eliminated, the insulation performance is improved, the heat loss is reduced by 1. 25 %, the flue gas temperature is reduced to about 170, and the heater efficiency is increased from 83 % to more than 90 %

    文摘:分析了金陵石油化工公司煉油廠二套常減壓裝置加熱爐存在的因蒸汽吹灰器漏水，蒸汽引起露點腐蝕及吹灰效果差造成對流室積灰，排煙溫度高，煙氣熱量未回收利用以及爐子保溫襯里效果差等問題，提出採用聲波除灰系統、煙氣回收系統、纖維噴塗和巖棉噴塗及相應的流程調整等改造措施.測定結果表明，本次技術改造解決了因蒸汽吹灰器漏水所造成的露點腐蝕問題，提高了保溫效果，減少散熱損失1 . 25 % ，排煙溫度降至170左右，裝置的爐效率由83 %左右提高到90 %以上
  3. The causes for low efficiency of the heater in no. 2 crude unit of jpc refinery are described and analyzed including water leaking of steam soot blower, dew point corrosion caused by steam, soot deposits in convection chamber owning to poor soot blowing, high flue gas temperature, no heat recovery of flue gas, and poor performance of insulation lining, etc. by using sonic soot removing system, flue gas recovery system, spray coating of fiber and rock wool, as well as adjustment of flow scheme accordingly in the technical revamping. the dew point corrosion is completely eliminated, the insulation performance is improved, the heat loss is reduced by 1. 25 %, the flue gas temperature is reduced to about 170, and the heater efficiency is increased from 83 % to more than 90 %

    分析了金陵石油化工公司煉油廠二套常減壓裝置加熱爐存在的因蒸汽吹灰器漏水，蒸汽引起露點腐蝕及吹灰效果差造成對流室積灰，排煙溫度高，煙氣熱量未回收利用以及爐子保溫襯里效果差等問題，提出採用聲波除灰系統、煙氣回收系統、纖維噴塗和巖棉噴塗及相應的流程調整等改造措施.測定結果表明，本次技術改造解決了因蒸汽吹灰器漏水所造成的露點腐蝕問題，提高了保溫效果，減少散熱損失1 . 25 % ，排煙溫度降至170左右，裝置的爐效率由83 %左右提高到90 %以上
  4. 3. bring forward a new idea : the ideology of synergetics used in atomic simulation and multi - scale simulation of materials design. on the basis of this, next tasks were put forward : ( 1 ) analyzing the changes of stress - strain curves of the interphase before and after pre - treatment ; ( 2 ) the efficient of the coupling effect of o2, na2s04 and h2o stream on the oxidation and erosion resistance of interphase ; ( 3 ) the methods of improving environment performance of interphase above 1273k

    提出將協同學的思想用於原子級模擬及跨尺度模擬的思路，並在此基礎上，提出下一步的工作設想： （ 1 ）分析熱處理前後界面相區域應力-應變曲線的變化； （ 2 ）航空發動機模擬環境中，氧、硫酸鈉蒸汽及水蒸汽耦合效應對界面相抗氧化性、抗腐蝕性的影響； （ 3 ） 1273k以上界面相環境性能提高的方法。
  5. Epdm colored granule is not only used in the track and field racetrack, all kinds of court, universities, middle and primary schools, stadium, still used in the slipresistance passway around the swimming pool, gymnasium, overpass, underpass, protecting such numerous respects as the place, ward, activity of disabled person and training court, distribution room, computer room of the army, the bathroom, kindergarten, nursery bottom game, etc

    三元乙丙橡膠可用於製造耐熱輸送帶蒸汽膠管耐化學品腐蝕的密封製品極適用於橋梁碼頭軌道枕墊等緩沖及減振材料各種防水材料各種膠板和護套等它又是電線電纜的良好絕緣材料，特別適用於高中壓電纜還可製造各種汽車配件。
  6. Since it has the advantage of no moving components, impulse signal output, strong medium adaptability, high measurement accuracy, wide measurement range, low - pressure drop, no zero drift and easy to maintenance, it is wide accepted that the vortex type fluid oscillatory flowmeter is ideal flowmeter in the measurement of gas, liquid, steam and mix / corrosive fluid

    這類的流量計兼有無運動部件，脈沖數字輸出，計量不受被測流體性質影響，測量準確度較高，量程比寬，無零點漂移，壓力損失小，便於安裝維護等優點，是測量氣體，液體，蒸汽，混合型和腐蝕性流體的理想的流量計。
  7. The original design was intermediate vapor 42t / h, but the actual output is 30 - 35t / h, at the same time the temperature and pressure of the vapor are unstable, it affects the economic efficiency, the reason were the collecting dust on the heat area and serious corrision, they led to the decrease of the boiler load, and need stop to washing the dust, the article deals with the reform of the exhaust gas boiler, at the basic of the design condition, after thermo calculation, flute gas, resistence calculationand strenth calculation, the structure of the heat surface had been rearranged, then the proof calculation was done

    原設計產中壓蒸汽42噸時，但投運后只產30 - 35噸時，並且蒸汽溫度和壓力均不穩定，影響到經濟效益。其原因是受熱面積灰和腐蝕嚴重，影響傳熱使鍋爐負荷下降，不能長時間運行，需停產清理積灰。本論文針對此余熱鍋爐的技術改造，在給定設計條件基礎上，通過熱力計算，煙氣阻力計算和強度計算，對鍋爐受熱面結構重新布置，然後再作校核計算。
  8. 1. capacitor installation is sorted into indoor and outdoor type. the ambient temperature range for capacitor installation and operation : - 40 b. there should be no corrosive gas, steam, conductive explosive dust and strong vibration exist at installation site

    1 .裝置分為戶內櫃式和戶外框架式，環境空氣溫度類別- 40 b安裝使用場所應無導電性或爆炸性塵埃應不含對金屬有嚴重腐蝕的氣體及蒸汽應無劇烈機械震動。
  9. The materials give excellent resistance to extremes of temperature, abrasion, exposure to oils, grease, water, steam and common industrial solvents and chemicals

    能在極高/低溫度（ - 40 ~ 115 ）的環境中工作，耐磨損，能暴露于油、潤滑脂、水、水蒸汽及一般溶解腐蝕性化學物質中工作。
  10. 2. there should be no corrosive gas, steam, conductive dust and strong vibration exist

    2 .周圍不含腐蝕性氣體或蒸汽，無導電塵埃，無劇烈機械震動。
  11. Surgical and dental hand instruments - determination of resistance against autoclaving, corrosion and thermal exposure iso 13402 : 1995 ; german version en iso 13402 : 2000

    外科和牙科手持器械.耐蒸汽消毒耐腐蝕和耐熱暴露性
分享友人
分享到 Line

分享到臉書