蒸發負荷 的英文怎麼說

中文拼音 [zhēngfāfùhé]
蒸發負荷 英文
evaporation load
  • 蒸 : Ⅰ動詞1. （蒸發） evaporate2. （利用水蒸氣的熱力使食物熟或熱） steam Ⅱ名詞[中醫] （將藥物隔水蒸熟） steaming
  • 發 : 名詞（頭發） hair
  • 負 : Ⅰ名詞1 （負擔） burden; load 2 （虧損） loss 3 （失敗） defeat Ⅱ動詞1 [書面語] （背） carry on th...
  • 荷 : 荷名詞（蓮） lotus
  • 蒸發 : [物理學] [化學] evaporation; evaporate蒸發計 evaporometer; evaporimeter; atmidometer; atmometer; ...
  • 負荷 : [電學] load; charge; weight
  1. Suction gas pressure goes up as the compressor run at the lower speed in the lower burthen, and this is beneficial to lower systems energy - consume. when the system is controlled by wvf, the discharge change of the evaporator is not linear ; the electronic expansion valve is adopted to regulate the system superheat degree, and the controlled object is parameter time varying, accordingly, the time varying controller should be adopted

    在負荷較小時，壓縮機採用低速運轉，吸氣壓力升高，這對系統降低能耗是有利的；變頻控制時，蒸發器製冷劑流量的變化並非線性；系統中採用電子膨脹閥進行過熱度控制，被控對象具有參數時變的特性，相應地宜採用變結構的控制器。
  2. The analysis indicates that in the absorbing refrigeration cycle using tfe - tegdme working fluid under the same evaporating temperature and condensation temperature, the performance of the simplicity cascade cycle is the best while the heat burden of the generator is the maximum, the performance of the mid - pressure double - effect cascade cycle is the worst while the heat burden of the generator is higher than the basic gax cycle

    分析結果表明，採用以tfe - tegdme為工質吸收式製冷循環，在同樣的蒸發溫度和冷凝溫度下，單純復疊循環性能最為優越，但發生器的熱負荷也最大；中壓雙效循環性能最差，而且發生器的熱負荷要比基本gax循環大，運行的經濟性差。
  3. Based on the analysis of pool water evaporation heat transfer and the sensible heat transfer between indoor air and pool water, deduces the calculation formula of latent load by pool water evaporation

    摘要通過對游泳館內池水蒸發換熱及池水與室內空氣之間的顯熱換熱分析，推導出池水蒸發潛熱負荷計算公式。
  4. According to the thermodynamics theory of vapor compression refrigeration cycle, hfc - r134a is chosen as refrigerant fluid and the thermodynamics calculation of refrigeration system is accomplished, which is based on the table of r134a thermodynamics characteristics and estimate of portable refrigerator ' s calorific burthen

    本文根據蒸汽壓縮式製冷循環的熱力學原理，從小冷量、小體積的便攜式冷藏箱的熱負荷計算出發，以所選用製冷劑（ r134a ）的熱力性質表為依據，進行了製冷系統的基本熱力計算。
  5. With fast development of our country " s gas industry and air ' s increasingly serious contamination in city, using gas instead of coal and supplying energy in high efficiency and cleanliness has become necessary way in city. there are different problems in the current heating ( air conditioning ) systems. in the cogeneration system, heat and power affect each other, heating - pump heating ( aie conditioning ) system can not satisfy the peak load very well, the cost of gas fuel in boilor heating sestem is so high. the high generating efficiency of the diesel - engine two - sourse heating ( air conditioning ) systems is limited in range of 100kw - 1000kw, the heating scope is so limited. combined cycle of two sourse heating ( air conditioning ) system is most suitable selection to buesness community with big scope my paper aim at this syetem ' s primary question when it is applied in our country - - - - bringing project into execution and technology economy feasibility and off - design performence, combined with a certain demonstrating project in beijing buesness community, going along with calculating and analyzing, drawing out some efficient datas and conclusions, based on this, bringing out primary alements affecting combined cycle of two sourse heating ( air conditioning ) system " economics

    熱電聯產系統熱電相互牽連，熱泵供暖（空調）系統不容易很好地滿足尖峰負荷，鍋爐供暖系統供熱中天然氣燃料構成的成本過高，內燃機雙源供暖（空調）系統的高發電效率僅限於100kw - 1000kw負荷范圍，供熱面積有限。對于大面積的商業園區、居民小區，燃燒天然氣的燃氣-蒸汽聯合循環雙源供暖（空調）系統是最佳選擇之一。本論文針對該系統在我國應用時的主要問題- - -方案的技術實施與技術經濟可行性，結合北京某一商業園區示範工程，進行了系統的計算與分析，得到了有效的數據與結論，在此基礎上，提出影響聯合循環雙源供暖（空調）系統經濟性的主要因素，並進行敏感性分析，得出有益的結論；最後通過各種供暖方案的比較分析回答了某些人對該系統的疑慮和不解，並指出系統的優化方向。
  6. The simulating result showed that when the unit load changes, the maximum dynamic difference of main - steam temperature drops 13. 8 %, the regulating time shortens 17 % and the control character is improved well

    模擬結果表明，在機組發生負荷擾動時，主蒸汽溫度的最大動態偏差降低了13 . 8 % ，調節時間縮短了17 % ，其調節品質明顯改善。
  7. From the calculation for the system of refrigeration, the choice of equipment, to the calculation for the temperature field and velocity field, the emphases is building model for evaporator in static state and dynamic state, do calculation and analyse for the whole space with temperature field and velocity field

    從製冷系統的負荷計算，設備的選型到溫度場和流速場的計算，其中重點是為蒸發器製冷劑側和空氣側參數建立穩態和動態數學模型，對整個冷庫的庫體空間進行溫度場和流速場的分析計算。
  8. The results are significant. the change of evaporating temperature and control precision influence the temperature fluctuation of the air, which is relevant to the heat - load matching of warehouse and refrigerating units

    溫度場的波動主要是兩個原因引起的：蒸發溫度的波動及控制的精度，也就是氣調庫的熱負荷要與機器的負荷相匹配。
  9. Mal - conditions, unsuitable material chosen, too heavy production load, inferior quality of manufacture and irrational structure are the main causes for corrosion to occur in the secondary evaporator - heater

    摘要工況惡劣、選材不當、生產負荷偏大、製造質量不佳和結構不合理是造成二段蒸發加熱器發生腐蝕的主要原因。
  10. This article emphatically discussed and analyzed following points : load command feed forward function can improve the rapid respond character of steam turbine generator ; lead of load command have advance control function on boiler main control and can highly improve the stability of main steam pressure ; the use of predict control and state space variable function can improve the quality of boiler steam temperature control effectively, control the steam temperature in the defined range and increase the boiler and turbine life and efficiency even if working state changed in a big range ; linear compensation can restrain the vibration of generator load in the condition of big loa d change

    本文重點討論、分析提出負荷指令前饋作用可以提高汽輪發電機快速響應特性；負荷指令的導前功能對鍋爐主控有超前控製作用，能顯著提高主蒸汽壓力的穩定性；採用預測及狀態空間法能有效改進鍋爐蒸汽溫度控製品質，在大幅度工況變化下仍有效控制蒸汽溫度在額定范圍內，提高鍋爐、汽輪機壽命及其效率；汽輪發電機組的快速響應性與汽輪發電機組負荷振蕩問題間的平衡關系，採用線性補償可以有效抑制在負荷變化梯度較大情況下發電機負荷振蕩問題。
  11. Second, the model for evaporator is founded based on traditional theory, including refrigerant side and air side, and the method for choosing element ; the calculation for the load of refrigeratory ; the thickness choice for heat insulation material ; the work area of evaporator is conformed ; and the matching for the other elements

    2 ）根據傳統理論建立了蒸發器的數學模型，包括冷劑側和空氣側的數學模型、微元的選取；冷庫冷負荷的計算和確定；隔熱材料合理厚度的選擇；蒸發器工作面積的確定；以及其他製冷元件的匹配理論。
  12. With a project examples, calculates the latent heat by pool water evaporation, and concludes that the pool water evaporation is an important factor influencing air conditioning load

    結合工程實例，計算了池水蒸發潛熱量，得出池水蒸發潛熱負荷是空調負荷的一個重要影響因素。
  13. Supplies steam for industrial process where load swings are common or higher quality steam for base loading of a turbine / generator for the production of electricity

    產生的蒸汽是用於負荷常變的普通工業過程還是用於要求蒸汽品質高的帶基本負荷的汽輪發電機組。
分享友人
分享到 Line

分享到臉書