薄層結構 的英文怎麼說

中文拼音 [bócéngjiēgòu]
薄層結構 英文
shell stucture
  • 薄 : 名詞[方言] （浮萍） duckweed
  • 層 : i 量詞1 （用於重疊、積累的東西 如樓層、階層、地層） storey; tier; stratum 2 （用於可以分項分步的...
  • 結 : 結動詞（長出果實或種子） bear （fruit）; form （seed）
  • 構 : Ⅰ動詞1 （構造; 組合） construct; form; compose 2 （結成） fabricate; make up 3 （建造; 架屋） bui...
  • 薄層 : sheet; thin layer; seam; thin wall; leaf; flash; lamelli; lemell-; lamin-
  • 結構 : 1 （各組成部分的搭配形式） structure; composition; construction; formation; constitution; fabric;...
  1. A thin epitaxial layer ( 10gm ) ldmos device used n - burry layer structure was proposed in the paper during the high - voltage device design, which is helpful to improve the drive circu it ? technology

    在高壓器件研究中，提出了一種外延層厚度為10 m採用n埋層結構薄外延高壓ldmos器件，對進一步改進驅動電路的工藝有著積極的意義。
  2. It showed that 73 % increasing of toughness in modified composites was achieved without the reduction of other mechanical properties. sem has showed the periodically interleaved system where the co - continuously connected granular structure occurs layer by layer between each ply and the interlayer was relatively very thin

    電鏡分析表明離位改性的碳纖維單向布周期性增強體系，在每兩層增強體之間都有很薄一層規整的球性兩相結構，正是這個獨特的多層結構使其抗沖擊性能大幅提高，而且不會對其他重要的力學性能產生不利影響。
  3. Moke and fmr studies were performed on single crystalline fe ultathin films epitaxially grown on iii - v semiconductor gaas substrate with thickness 4. 1 - 33 monolayer ( ml ). a theoretical mode for fitting fmr experimental data was established. the results demonstrated the structures and reproduced the evolution of the magnetic properties of ultrathin films with various thickness from the state of superparamagnetic nano - cluster through coexistence of two magnetic phases to continuous film, especially the change of magnetic crystalline anisotropy from unixial to cubic

    1 - 33原子層厚度（ monolayer ，簡稱ml ）的fe單晶超薄膜進行了鐵磁共振（ fmr ）和磁光研究，建立了理論模型對鐵磁共振實驗結果進行了模擬，重現了不同厚度的超薄膜，從納米團簇到兩相共存的過度階段直至連續薄膜結構與磁性的變化，特別是磁各向異性從單軸各向異性向立方各向異性轉變的演化過程。
  4. Mechanics on noise reduction of the structure is as followed : there is a very thin air layers between the matrix, so the structure of multi - layer is formed. that is metal a - air - metal b - air - metal a or metal a - air - metal b - air - metal b - air - metal a. on the cutting motivation conditions, air layer between two metal layers is flowed to - and - fro, which can absorb a part of motivation energy, so it leads to low noise radiation

    該結構設計的消音機理為：層與層之間存在一層非常薄的空氣層，形成不同金屬與空氣的多層結構，即a金屬-空氣- b金屬-空氣- a金屬或a金屬-空氣- b金屬-空氣- b金屬-空氣- a金屬等多層結構。
  5. The thickness of film is frequent non - uniform, and factors are a good many. in practice, the production of uniform - thickness coatings from geometric position in the vacuum chamber

    研究表明，使用等離子體源輔助沉積的光學薄膜折射率明顯提高，更加接近於塊狀材料，膜層結構比傳統沉積手段更加緻密，附著力也很高。
  6. Based on experiments and theory analysis in the past, here we present the most important technology conditions that affecting photosensitivity : 1 、 cycle times, experiments showed that with the increase of cycle times, photosensitivity got worse ; 2 、 h dilution ratio, with the continuously increase of h dilution ratio, h ’ s bombardments on the growing surface enhanced continuously too. these bombardments can eliminate high - energy default configurations priorly and leave stable configurations behind. therefore, growing layer ’ s configurations are impacted ; default state density is decreased and photosensitivity is improved

    Layer - by - layer方法的制備工藝條件很多，我們在以往實驗和理論分析的基礎上，介紹了對光敏性影響最為重要的工藝條件: 1 、循環次數的影響，實驗表明隨著循環次數地增加，光敏性變差; 2 、 h稀釋比的影響，隨著h稀釋比的不斷增加， h對生長表面的轟擊不斷增強，這些轟擊能優先消除高能缺陷結構而留下穩定的結構，從而使生長層結構緻密，減少缺陷態密度，提高薄膜的光敏性。
  7. The intrinsic hysteresis of a ferroelectric bilayer with an antiferroelectric interfacial coupling is studied within the framework of tim. we find it is possible to exist triple hysteresis loops once the parameters of the two slabs are selected appropriately

    對反鐵電界面耦合的鐵電雙層結構薄膜的內稟電滯回線研究中，我們發現在適當的條件下，能出現多態電滯回線。
  8. But setting of strengthened floor will result in the sudden variation of structural stiffness and internal force, and will come into being weal story. the yield mechanism will difficultly " story column, weak beam " and " strong in resistance of shear force, weak in resistance of bending moment "

    在風荷載作用下，設置加強層是一種減少結構水平位移的有效方法；但在地震作用下，加強層的設置將會引起結構剛度、內力突變，並易形成薄弱層，結構的損壞機理難以呈現「強柱弱梁」和「強剪弱彎」的延性屈服機制。
  9. Heat mirror super insulating glass uses double layers of film suspended between two pieces of glasses

    兩層玻璃中採用雙層薄膜結構超級熱鏡中空玻璃。
  10. Earth ' s layered structure - - a relatively thin crust of mobile plates, a solid mantle with gradual overturning movement, and the outer and inner core of molten and solid iron

    地球是分層結構?相對運動變化的板塊薄的外殼，一塊具有逐漸加強的顛覆運動形式的固態硬殼，具有遠離中心的外層和內部熔化的內核和固態鐵。
  11. The efficient boundary element method is improved in this paper to deal with open multi - layer structures, and used to analyze thermal barrier coated components of aero - engine, which further enrich the former research

    本文將薄體多層結構邊界元法分析推廣用於開環型多層結構分析，進一步豐富了以前的研究成果，並利用它分析航空發動機帶熱障塗層葉片熱應力。
  12. High - performance ferrocement is a type of thin layer for reinforcing concrete structures, where usually high - performance cement is reinforced with layers of continuous and relatively small diameter steel bar mesh

    高性能復合砂漿鋼筋（絲）網是以鋼筋（絲）網作為增強材料，高性能水泥砂漿為基材組成的薄層結構。
  13. In fact, the two layers could easily be separated by blunt dissection beyond the fat pad in all the cadaveric specimens although they became astonishing thinner in some areas

    事實上，在超出顳中脂肪墊以外的有些區域，盡管這兩層結構變得極為薄弱，但均可用鈍性剝離將其分離。
  14. Owing to its optoelectronic and chemical properties, cdte is an ideal absorber material for high - efficiency, low - cost polycrystalline thin film. the thesis has investigated the structure, figure and optoelectronic characteristics of cdte polycrystalline thin films, the performance of doped cdte, and the influence of their deposition and anneal process

    Cdte具有良好的光電學性質和化學性質，因此成為制備高效率、低成本的多晶薄膜太陽電池理想的吸收層材料。本文針對cdte薄膜，研究了其制備工藝、摻雜和后處理條件對薄膜結構、形貌和光電學性質的影響。
  15. The figure of merit of ito film deposited under these conditions was 3. 10 10 - 3s, the sheet resistance was 53. 8 ? / and the mean transmittance in visible region was 83. 6 % when the thickness of ito film was 10nm

    其次，為了進一步提高室溫下沉積的ito膜導電性，採用ito / ag / ito三層結構的復合薄膜代替單層結構的ito膜。
  16. With the pentacene acting as the active layer, the diode of ito / pentacene / al, the vertical organic thin - film field - effect transistor, the organic thin - film ambipolar field - effect transistor and the organic thin - film double - field - effect transistor are fabricated

    提出雙柵絕緣層結構全有機薄膜場效應晶體管，達到了減少器件柵的漏電流、降低器件工作電壓和提高器件工作電流的目的。
  17. 3d nonlinear finite element method is applied to analyze the stability of rock slope in the paper. when using this method, the thin layer element is used to simulate interlayer and structural joint for sliding surfaces

    本文採用了合理模擬以夾層、結構面等為滑動面的薄層單元及相應的非線性分析為基礎的三維非線性有限元解法來求解巖質邊坡的穩定性。
  18. In this paper, based on some previous scholars " excellent study fruits, the finite element iteration method for stability safety factor of landslide body against sliding is presented, when using this method, the thin layer element is used to simulate interlayer and structural joint for sliding surfaces

    本文在總結前人的優秀研究成果的基礎之上，採用合理模擬以夾層、結構面等為滑動面的薄層單元及相應的非線性分析方法，提出了塌滑體抗滑穩定安全系數的有限元迭代解法。
  19. Ferrocement is a type of thin layer to reinforce concrete structure, where usually hydraulic cement is reinforced with layers of continuous and relatively small diameter steel wire mesh. the mesh can be made of metallic materials or other suitable materials

    鋼絲網復合砂漿是以鋼絲網或鋼絲網和加筋為增強材料，水泥砂漿為基材組成的薄層結構，鋼絲網也可以用其它合適的金屬材料代替。
  20. The tio2, cds and cds - tio2 films on the common glass substrate were prepared, respectively, using ti ( oc4h9 ) 4, cd ( cooch3 ) 2 and scn2h4 as raw materials by sol - gel method. the influences of manifold preparing parameters ( such as the concentration of sol, the amount of the peg. the number of coatings, the heat - treated temperature and time ) on the structure and performance were studied

    本文採用溶膠-凝膠技術，以鈦酸丁酯、乙酸鎘和硫脲為原料，以普通玻璃片為載體，制備了納米tio _ 2薄膜、 cds薄膜和cds - tio _ 2復合半導體薄膜，研究了制備過程中多種制備參數（如溶膠的濃度，聚乙二醇（ peg ）的加入量，鍍膜層數，熱處理溫度及時間）對薄膜結構和性能的影響，採用x -射線衍射（ xrd ） 、掃描電鏡（ sem ） 、能譜分析（ edxa ） 、紫外-可見吸收光譜（ uv - vis ）等測試手段對各薄膜進行了結構和物性表徵。
分享友人
分享到 Line

分享到臉書