薄覆層的 的英文怎麼說

中文拼音 [bófùcéngde]
薄覆層的 英文
thin-coated
  • 薄 : 名詞[方言] （浮萍） duckweed
  • 覆 : 動詞1. [書面語] （蓋住） cover 2. [書面語] （底朝上翻過來; 歪倒） overturn; upset 3. 同 「復」 （Ⅱ1. 2. ）
  • 層 : i 量詞1 （用於重疊、積累的東西 如樓層、階層、地層） storey; tier; stratum 2 （用於可以分項分步的...
  • 的 : 4次方是 The fourth power of 2 is direction
  1. 1 water threatening - resistant characteristic : for instance, the outside tangency wall of epidermis cell prominently thicken ; the outside of epidermis cell are obviously covered by cuticle ; few stomats exists ; stomats are sunken ; and it has stmatic chamber structure, big aqueous tissues - parenchyma cell, mucilage cell, abnormal vascular, and soon

    抗水分脅迫的抗鹽結構特徵。如表皮細胞外切向壁明顯加厚，表皮外有明顯的角質層覆蓋；氣孔稀少、氣孔下陷及具有孔下室結構；大型貯水組織薄壁細胞、粘液細胞、異型維管束等。
  2. The light travels in a composite medium made up of the film, the substrate and the cladding.

    光在由薄膜，襯底和覆蓋層組成的混合介質中傳輸。
  3. Methods of testing vitreous enamel finishes - determination of resistance to thermal shock of coatings on articles other than cooking utensils and fabricated sheet steel components

    搪瓷釉層的試驗方法.第1部分:除廚房器具和薄鋼板組件外的製品覆層耐熱沖擊性的測定
  4. Methods of testing vitreous enamel finishes - determination of resistance to thermal shock of coatings for fabricated sheet steel components such as burners and pan supports for cookers

    搪瓷釉層試驗方法.第22部分:炊用爐燃燒器具和炊具支架類薄鋼板組件覆層的耐溫度沖擊性測定
  5. Standard test method for adherence of porcelain enamel coatings to sheet metal

    金屬薄板搪瓷覆層的粘著性的標準試驗方法
  6. Thin epoxide woven glass fabric copper clad laminated sheet of defined flammability, for use in the fabrication of multilayer printed boards

    限定燃燒性的薄覆銅箔環氧玻璃布層壓板
  7. Thin polyimide woven glass fabric copper - clad laminated sheet of defined flammability for use in the fabrication of multilayer printed boards

    多層印製電路用限定燃燒性的薄覆銅箔聚酰亞胺玻璃布層壓板
  8. Results show that the overlying soil with a soft interlayer can obstruct the rupture failure from bedrock up to the earth ' s surface, however, a soft interlayer which is deeply buried, will bring about a wider range of the earth ' s surface rupture failure ; in addition, the thickness of the soft interlayer may have effects on the rupture course of the overlying soil

    從模擬的結果看出，軟夾層對上覆土層破裂有一定的阻礙作用；當軟弱層埋置較深時，一旦上覆土層破裂，失效土體的范圍較大；軟弱夾層的厚薄對上覆土層的破裂進程和破裂范圍也有影響。
  9. This technique improves the speed of the transistors, but engineers have been pushing hard to do even better using something called silicon - on - insulator technology, which involves putting a thin layer of insulating oxide slightly below the surface of the wafer

    這項技術提高了電晶體的速度，不過工程師為了追求更好，採用一種稱為絕緣層覆矽的技術，方法是在晶圓表面下緣加入薄薄一層絕緣氧化物。
  10. Paints and varnishes - coating materials and coating systems for exterior masonry and concrete - determination of water - vapour transmission rate of free films dish method

    塗料和清漆.外部砂漿和混凝土覆層材料和覆層系統.無薄膜水蒸氣滲透率的測定
  11. Therefore, in the process of load transfer within the unconsolidated confined aquifer, the key strata of overburden rock are prone to have a compound breakage when the load on the upper interface of bedrock is great and the bedrock is very thin

    在鬆散承壓含水層的載荷傳遞作用下，作用在基巖頂界面的載荷較大，當基巖厚度較薄時，采場覆巖關鍵層易產生復合破斷。
  12. Aluminium and aluminium alloys - anodizing - part 16 : check for continuity of thin anodic oxydation coatings - copper sulfate test

    鋁及鋁合金.陽極化.第16部分:薄陽極氧化覆層的連續性檢查.硫酸銅試驗
  13. Coil coated metals - test methods - adhesion of strippable films

    卷材覆層金屬.試驗方法.可剝離薄膜的粘結性
  14. Standard specification for steel sheet, carbon, metallic - and nonmetallic - coated for cold - formed framing members

    冷成形構件用金屬覆層和非金屬覆層的碳鋼薄板的標準規范
  15. Standard practice for establishing conformance to the minimum expected corrosion characteristics of metallic, painted - metallic, and nonmetallic - coated steel sheet intended for use as cold formed framing members

    冷軋成形構件用金屬塗有金屬和無金屬覆層的薄鋼板符合最低腐蝕期望值的標準實施規程
  16. Plates for thin - layer chromatography ( tlc ) with an attached layer of porous polymer monolith have been prepared and used for the separation of small molecules, peptides, and proteins

    制備了塗覆有整體多孔聚合塗層的薄層色譜（ tlc ）板，並將其用於小分子、肽段和蛋白質的分離。
  17. Standard specification for asphalt - coated glass fiber base sheet used in roofing

    屋面用瀝青覆層的玻璃纖維基薄板的標準規范
  18. Materials for interconnection structures - sectional specification set for conductive foils and films with and without coatings - copper foils for the manufacture of copper - clad base materials

    連接結構用材料.第5部分:帶和不帶覆層的導電箔和薄膜的分規范.第1節:銅箔
  19. Standard practice for sample preparation of transparent plastic films for specular gloss measurements, on membrane switch overlays

    薄膜開關塗覆層上拋光光澤測量用透明塑料薄膜的樣品制備的標準指南
  20. Standard test method for measurement of dry film thickness of thin film coil - coated systems by destructive means using a boring device

    用鉆孔裝置破壞性測量薄膜盤繞覆層系統的干膜厚度的標準試驗方法
分享友人
分享到 Line

分享到臉書