蜂窩層壓板 的英文怎麼說
中文拼音 [fēngwōcéngyābǎn]
蜂窩層壓板
英文
honeycomb laminated- 蜂 : 名詞1. （昆蟲名） wasp2. （特指蜜蜂） bee Ⅱ副詞（比喻成群地） in swarms
- 窩 : Ⅰ名詞1 （鳥獸、昆蟲住處） nest 2 （比喻壞人聚居處） den; lair; nest 3 [方言] （比喻人體或物體所佔...
- 層 : i 量詞1 （用於重疊、積累的東西 如樓層、階層、地層） storey; tier; stratum 2 （用於可以分項分步的...
- 壓 : 壓構詞成分。
- 板 : Ⅰ名詞1 （片狀硬物體） board; plank; plate 2 （專指店鋪的門板） shutter 3 [音樂] （打拍子的樂器） ...
- 蜂窩 : 1. （蜂巢） honeycomb2. （像蜂巢物） a honeycomb-like thing
-
The selection of material, typical the structural designs, the mechanical property and the forming pressure of unmanned aircraft sandwich composite material have been studied in this paper. it has analysed and discussed the flexural properties of honeycomb sandwich plate delamination under bending loads in detail. and then the mechanical properties of the laminate panel are studied which are compared with honeycomb sandwich panel
在圍繞某無人機蒙皮選用材料的基礎上，重點對蜂窩夾層結構的結構設計、力學性能、成型壓力對力學性能的影響，以及缺陷對蜂窩夾層結構復合材料的彎曲性能影響進行了較深入的實驗研究和理論分析，同時比較了蜂窩夾層結構中面板與同樣材料鋪層的疊層板力學性能的差異。After mechanical and process properties testing, the results indicated that : ( 1 ) the film resin can make the properties good in climbing drum peer strength of sandwich constructions composite, the little effects of the film resin on other mechanical properties have been given ; ( 2 ) the sandwich composite has the better mechanical properties at central symmetry layer than asymmetric layer ; ( 3 ) through the study of the different pressure of the sandwich composite, the result is obtained that the edgewise properties increases, the flexural properties decreases with the pressure increase from 0. 2mpa to 0. 5mpa ; ( 4 ) at the sameness extend layer, the mechanical properties of the laminate is bigger than that of the honeycomb sandwich panel ; ( 5 ) through the studies on honeycomb sandwich plate delamination under three - point bending tests. it is found that the flexural strength decreases with the area of delamination increases
研究表明： （ 1 ）膠膜能明顯的提高蜂窩夾層結構的剝離性能，對其它性能的影響不大； （ 2 ）對稱鋪層較非對稱鋪層的力學性能高； （ 3 ）固化壓力由0 . 3mpa提高至0 . 5mpa時，蜂窩夾層結構的側壓強度提高，而彎曲強度和剪切剛度分別降低； （ 4 ）蜂窩夾層結構中的面板較同樣材料鋪層的復合材料疊層板的力學性能低； （ 5 ）蜂窩夾層結構的界面上有缺陷時，彎曲強度下降，且隨著缺陷面積增大，彎曲強度下降幅度增大。
分享友人